Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
My coil is overheating after 30 -45 minutes of running and
my coil is overheating after 30 -45 minutes of running and then the engine shuts down and will not start until the coil cools off. engine has been worked on by several backyard mechanics before my pur… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1986 OMC Cobra 3.0. I am having an ignition problem
I have a 1986 OMC Cobra 3.0. I am having an ignition problem I cant figure out. Start it up and let it idle. It runs from 35 to 50 minutes and dies. Everything is new, points, rotor, cap, coil, wires,… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
LOOKING BALLAST RESISTOR ON A 4.3 LITRE OMC COBRA ITS OF
LOOKING FOR THE BALLAST RESISTOR ON A 4.3 LITRE OMC COBRA ITS OF COURSE A V6 INSTALLING A MALLORY DIS BRAKERLESS IGTION … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Chrysler LM318BWL15-002: have a marine Chrysler LM318 (1984).....5.2
have a marine Chrysler LM318 (1984).....5.2 liter.....235 hp....engine turns over, but won't start.......no spark at all.....getting current from coil.....replaced coil and distributor cap, (electroni… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1975 houseboat. 2 ford 225hp. port engine refused to crank.
1975 houseboat. 2 ford 225hp. port engine refused to crank. now i have to hot wire it to run. once hot wired, it runs great. problem in ignition/run system. have replaced switch, solenoid, and coil. w… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
~73 Chrysler 318, points ignition with a voltage regulator
~73 Chrysler 318, points ignition with a voltage regulator & ballast resistor. Was ran for 15 minutes a couple months ago, now no spark, have replaced coil + voltage regulator, but still no spark at c… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hello, I have a 1990 OMC 4.3L with a Cobra OD. It runs great
Hello, I have a 1990 OMC 4.3L with a Cobra OD. It runs great but occasionally it will just die at high speed or after lots of tubing it won't start. ?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have two 427 ford 300HP Chris Craft engines with Mallory
I have two 427 ford 300HP Chris Craft engines with Mallory pointless ignition. I am experiencing carbon tracking under the cap. What could be causing it? How do I fix it? Thank you.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Im having ignition issues. I upgraded to electronic and found
I'm having ignition issues. I upgraded to electronic and found I cant get above 3000rpm. I think the module is faulty. I want to go back to points, there old school but you can count on them..... the … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1981 sea ray with a mercruiser 260 in it. Im looking
I have a 1981 sea ray with a mercruiser 260 in it. I'm looking to upgrade to an electronic ignition. Anyone done it?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
what is total parts required to convert my 1987 baliner capri
what is total parts required to convert my 1987 baliner capri w/ 0mc cobra 5.0 liter from conventional to electronic ignition system? Do you have a recommendation as to a particular brand? I know I wi… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1986 SeaSwirl, 4.3 ltr V-6, 4 BBL with Select Trim.
I have a 1986 SeaSwirl, 4.3 ltr V-6, 4 BBL with Select Trim. Prestolite Dist. (IBM 7021) I have changed out the point style Ignition to Pertronix 1563A Ignitor. Problem- Can't find out whether I have … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a OMC 5.0 Cobra engine. It will crank up and run fine,
I have a OMC 5.0 Cobra engine. It will crank up and run fine, once it warms up it will start to bog down. While running if it starts to bog down I can hit the trim button and it will start to run corr… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I replaced a 1988 5.7 cobra in four winns, with a reman 5.7
I replaced a 1988 5.7 cobra in four winns, with a reman 5.7 with slight cam. under load only getting about 3000 rpm. manuf wants no more than 30 total time at highest vaccuum approx 17. My question is… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1968 mercruiser 120hp sterndrive and i want to replace
I have a 1968 mercruiser 120hp sterndrive and i want to replace my coil that is still available but the ballast resistors are not. nobody can tell me what the value of the ballast resistors should be … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have an OMC 1976,302 The gray tach wire has a branch,on
I have an OMC 1976,302 The gray tach wire has a branch,on the left is tworesistors and on the right two diodes. I think this may have been a Pertronix mod. The distb is a Mallory marine performance un… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have an 87 Mercruiser 3.0L and decieded to put in an electronic
I have an 87 Mercruiser 3.0L and decieded to put in an electronic conversion kit for the distributor and it does'nt work. I called a mercruiser shop about information on either a ballast resistor or w… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
I want to replace my troublesome thunderbolt ignition system
I want to replace my troublesome thunderbolt ignition system with a new Mallory aftermarket ignition kit #9-26000. Is this an easy operation and does my thunderbolt system already have a ballast resis… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,858 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x