Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Hit something in water with 40hp mercury on pontoon. Motor
Hit something in water with 40hp mercury on pontoon. Motor did not kick up noticeably, but ran rough and lost power afterward. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Motor will run fine, I'll stop and restart and all is good.
Motor will run fine, I'll stop and restart and all is good. After about 3 start attempts, motor will stall and cannot restart. After a few hours motor will restart with same same problem stated above.… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
2005 50hp, 2 stroke. Starts fine and ran ok on first two
2005 Johnson 50hp, 2 stroke. Starts fine and ran ok on first two trips to lake except for loss of power for a short time which seem to recover and run good for most of the day. I did notice a slight m… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My Yamaha 115 4 stroke races (rpm spikes momentarily causing
My Yamaha 115 4 stroke races (rpm spikes momentarily causing a lurch) between 2000-3200 rpm. You can see it on the tach and feel it as it lunges forward for less than a second. I have not noticed it a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2000 Hewes Bonefisher 18 powered by a 1999 Yamaha
I have a 2000 Hewes Bonefisher 18 powered by a 1999 Yamaha 130. WOT is 4700 rpm and hole shot is poor. Thinking it is the prop which is a 3 blade SS 13.25x19. The prop is probably ten years old, decen… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have an old Johnson 225 VRO mounted on 1972 21.5ft Boston
I have an old Johnson 225 VRO mounted on 1972 21.5ft Boston Whaler Outrage. I bought this used and I am the third owner with no owner's manual. The VRO is disconnected and I manually mix the 2-stroke … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the helm is located at the rear. the boat is rated 1900 lbs/75hp . when i am towing a tube, the majority of the outboard shaft is under water and… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 17.5 Lund Tyee (rated to 140 hp) and I fish Lake
I have a 17.5' Lund Tyee (rated to 140 hp) and I fish Lake of the Woods in northern MN & Canada with 4 adults in the boat. Mercury makes 115, 125 & 135 hp Optimax motors. Other than the small differen… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1992 18 four winns I/O bowrider (180 Freedom). I
I have a 1992 18' four winns I/O bowrider (180 Freedom). I was pulling my kids today on a tube and all of a sudden I lost torque at the propeller. With the throttles full forward the tach would read a… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I think I broke something on my outdrive today. I have a Regal
I think I broke something on my outdrive today. I have a Regal 1900 LRS with Volvo 3.0 GS 4 Cyl with Penta outdrive. I possibly hit a sandy bottom, creating drag for about 2 seconds. Everything ran we… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1992, 24 Trophy boat; 5.7 merc I/O, with Alpha 1
I have a 1992, 24' Trophy boat; 5.7 merc I/O, with Alpha 1 outdrive. When the boat is heavy with people & fuel, the prop seems to slip, or if it had a transmission it would be slipping trying to build… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2007 Carver 45 Cockpit Motor Yacht about 37,000 lbs
I have a 2007 Carver 45 Cockpit Motor Yacht about 37,000 lbs with fuel. I have Volvo D6 370 HP inboard engines. I think it's under powered and is very sensitive to Barnacles, wind and currents. It sho… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,059 satisfied customers
HELLO, I HAVE A QUESTION. MY 1978 ENDEAVOUR IS FITTED WITH
HELLO, I HAVE A QUESTION. MY 1978 ENDEAVOUR IS FITTED WITH A YANMAR 2GM20 ENGINE THAT HAS APPROXIMATLY 1400 HOURS ON IT. IT HAS BEEN OVERHAULED AND GIVEN THE BEST OF CARE. I LOVE THIS ENGINE AND IT HA… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 50 hp Honda 4-stroke on 21 foot pontoon boat. First
I have a 50 hp Honda 4-stroke on 21 foot pontoon boat. First time run this summer. Idles and revs up at the dock with no load to 5000 rpms, but when I take it out and give it gas, it bogs down and cut… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hey guys, Im disabled and cant afford brand new engines.
Hey guys, I'm disabled and can't afford brand new engines. I have a 30 ft. pacemaker sf powered by crusader model 220's some have told me they are 305 's and some have told me they are 350's 260 hp, t… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I was on the lake yesterday with my Mecruiser Alpha 1 20 Regal.
I was on the lake yesterday with my Mecruiser Alpha 1 20" Regal. Cruising along about 3000 rpm @ 35 mph all of a sudden the motor revved up and we lost power. The feeling you get if you raise the outd… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
hi larry . my question is i have my 50 hp mercury 2009 done
hi larry . my question is i have my 50 hp mercury 2009 done 3 hours only fixed on my light boat 550 lbs only and am getting max 4000 rpm and on the engine spesifiction shows 5500-6000 rpm so is it (th… read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
I have a 90 HP Mercury outboard motor on a 24 ft pontoon ...
I have a 90 HP Mercury outboard motor on a 24 ft pontoon boat. We have not used the boat very often. It used to run very weel and would go fast. Now after sitting for awhile it only runs about half as… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x