Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1993 140 hp and I drive it for 1 to 2 min then it
I have a 1993 140 hp Johnson and I drive it for 1 to 2 min then it slows down. I shit it off wait half hour and it starts up and runs good for 1 min then slows down again … read more
Charles
Charles
Certified Mercury Tech
5,471 satisfied customers
I have a 1994 88hp spl, it is a cross flow motor (distance
good morning sir , I have a 1994 johnson 88hp spl , it is a cross flow motor (distance between top and bottom spark plugs is 4.1 something inches and from what I've researched the looper is 4.7 someth… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Can i adjust the Governor on a 4 stroke 6hp merc. to make it
can i adjust the Governor on a 4 stroke 6hp merc. to make it a bit faster or more powerful?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
i have a 2002 merc 125HP OUTBOARD ON A 196 STARCRAFT SUPER
i have a 2002 merc 125HP OUTBOARD ON A 196 STARCRAFT SUPER FISHERMAN,,, I HAVE USED NGK BPZ 8H-N-10 SPARK PLUGS AS RECOMMENDED BY Marina,, lately on returning slow speed the motor vibrates slightly an… read more
Charles
Charles
Certified Mercury Tech
5,471 satisfied customers
I have a 96 Johnson two cycle 4cylinder 90degree vcross scavenged
I have a 96 Johnson two cycle 4cylinder 90degree vcross scavenged 88 special it starts fine but after iget in water take off after about 5 minutes the hot horn goes off I stop kill it start it horn go… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I purchased a 2008 Fisher 240 Tritoon with no motor and then
I purchased a 2008 Fisher 240 Tritoon with no motor and then purchased a Honda 200 Outboard and attached it with honda rigging. The first two times I went out in the boat with my family it would do 40… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
hi, i have a 1988 omc 3.0. right now i have a 15 pitch prop
hi, i have a 1988 omc 3.0. right now i have a 15 pitch prop on it.. and thought about going to a 17 pitch.. i was told by someone that if i went to a larger pitch on that old of a motor it will hurt t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 1995 140 johnson, the 4 blade prop started slipping
I have a 1995 140 johnson, the 4 blade prop started slipping and I had it rebuilt. before that the motor ran 5150 to 5200 RPMs. when I got the prop back, it had been cupped and now my RPMs are in teh … read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
recently bought a used poontoon with 50 hp johnson. seems to
recently bought a used poontoon with 50 hp johnson. seems to cruise best at 5000 rpm or below 3000 rpm. speeds between these rpm's wont hold steady.rpm's will rise or lower constantly no matter the wa… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I have a 1988 70 hp Johnson outboard. I by-pasted the fuel/oil
I have a 1988 70 hp Johnson outboard. I by-pasted the fuel/oil pump a few years ago with an external electric fuel pump and pressure regular (4psi). Everything ran great until now. The motor run good … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1997 Stratos 201 XLE w/ 200 vindicator. I have a Ballistic
I have a 1997 Stratos 201 XLE w/ 200 vindicator. I have a Ballistic 4 blade 26 pitch. Runs @ 5700 rpm and only gets 60.1 GPS. Is there a better blade to get more top end?… read more
tom
tom
outboard mechanic
High School or GED
117 satisfied customers
I have a Johnson 50 hp model number J50TLEUC and it goes only
I have a Johnson 50 hp model number J50TLEUC and it goes only about 2900 rpm wide open throttle...I have gotten it back from the shop about 1 month ago and had the carbs cleaned, new fuel lines and fi… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
What size replacement propeller is appropeiate for my 90 HP
What size replacement propeller is appropeiate for my 90 HP year 1999 Johnson outboard boat motor installed on a 22 ft pontoon boat.. Does the age of the motor make a difference? It runs about 100 hou… read more
Jason
Jason
Associate Degree
210 satisfied customers
hi larry . my question is i have my 50 hp mercury 2009 done
hi larry . my question is i have my 50 hp mercury 2009 done 3 hours only fixed on my light boat 550 lbs only and am getting max 4000 rpm and on the engine spesifiction shows 5500-6000 rpm so is it (th… read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
i just asked a question about a 70 hp got 1 more. would you
i just asked a question about a 70 hp got 1 more. would you have any ideal what size prop i might need. the boat is a 1989 tracker pro deep v 16. before it started having trouble i had a 17p x 13 3/4 … read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
I have a 1986 mercruiser that overheats at idel speed. I have
I have a 1986 mercruiser that overheats at idel speed. I have changed the lower unit impeller, and thermostat with no luck. The new thermostat rating is 140 degrees, but at high speed the engine runs … read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I just bought a Crest Pontoon boat. It has a 1994 ...
I just bought a Crest Pontoon boat. It has a 1994 Johnson Outboard 70HP motor.Rebuilt Carbs,150lbs compression on each cyclinder.runs @ 2500to3000rpm . Starts , runs in low to mid range throttle. new … read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I have a 2001 Sea Doo Utopia with the 200 hp Optimax ...
I have a 2001 Sea Doo Utopia with the 200 hp Optimax Mercury Jet Drive. Everytime I go over 5000RPM the engine dies but will start back up like nothing happened. It idels and goes to 5000 RPM perfectl… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
1,074 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x