Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2005 mercruiser 5.7 i/o stalled now it cranks but wont
2005 mercruiser 5.7 i/o stalled now it cranks but wont start. After it happened I had my soninlaw remove the spark arrestor and pour a little gas in the carb, put it back together and it started and r… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
You have helped me in the past so I thought I would come
Hi Jason, you have helped me in the past so I thought I would come back and seek more advice from you. I launched my Rinker 342 on Friday and a problem that was happening at the end of last season of … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,609 satisfied customers
I have a 2001 Searay w/ 4.3 L mercruiser stern drive
Hello. I have a 2001 Searay w/ 4.3 L mercruiser stern drive Alpha I w/ Thunderbolt V ignition system. Recently rebuilt motor due to improper winterizing, cracked block. I ordered short block marine en… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I have a 1999 Campion with 5.7 liter Mercruiser GM engine
I have a 1999 Campion with 5.7 liter Mercruiser GM engine Bravo 2 drive. Engine starts and runs great cold, for about 15 minutes, but spits and pops in the 2500-3800 rpm once hot, under load, worst at… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,609 satisfied customers
Have twin 7.4 l mercruisers. 1991 carb models. When I start
Have twin 7.4 l mercruisers. 1991 carb models. When I start and go o to plane for first time they accelerate smoothly. But if we have stopped for some time and restart the boat and accelerate again, o… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
I have twin mercruiser 454 gas engines in a 1986 Sea Ray Sundance
I have twin mercruiser 454 gas engines in a 1986 Sea Ray Sundance when I take the engines over 2700 rpms it looses power and back fires. My mechanic can not figure it out. He has done everything we ca… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
19,609 satisfied customers
98 5.7l mercruiser. Ive had over heating issues for the past
98' 5.7l mercruiser. I've had over heating issues for the past two years.1st had almost full blown fire. Shop replaced bellows, impellor,thermostat and more. The SS hose clamps were almost melted. Fir… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have twin 454 MIE 7.4L MerCruisers in a 1992 Sea Ray 370
I have twin 454 MIE 7.4L MerCruisers in a 1992 Sea Ray 370 Sedan Bridge. Both are original and run great. 1,000 hours each. My starboard engine occassionally stalls at idle either before pulling away … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1998 Searay 290DA Sundancer with twin - 5.0 EFI Mercruisers
I have a 1998 Searay 290DA Sundancer with twin - 5.0 EFI Mercruisers and Alpha one drives The boat has 310 hours on it and had been used very little before I purchased it in 2008 For the past several … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
Desperate Merc owner...Info 1996 Mercruiser, well kept w/Alpha
Desperate Merc owner...Info: 1996 Mercruiser, well kept w/Alpha 1 Gen 2, 5.7 GM 2 BBL carb; Recently overhauled engine, carb, new impeller, drive serviced... Replaced coil, tank check valve and fuel l… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Have 88 454 Mercruisers in a Sea Ray 430 Convertible. Recently
Have '88 454 Mercruisers in a Sea Ray 430 Convertible. Recently the starboard engine has started to shut down after running for 45 min. to an hour. It has never shut down at higher RPM's 3800 cruise o… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
I have a 1993 Tiara Model Open 2700 with twin inboards Mercruiser
I have a 1993 Tiara Model Open 2700 with twin inboards Mercruiser 5.7L 350/250. These are carborated engines (probably manufactured in 1992) I ahve owned the boat since 2006. Each engine is losing coo… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
i have a 88 carver santego with twin 98 4.3 ltr mercruisers.
i have a 88 carver santego with twin 98' 4.3 ltr mercruisers. the port motor starts up fine and idles up to wot (wide open throttle) fine at the dock when not in gear. but when underway with drive eng… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
What is the difference between an automotive coil and a Mercruiser
What is the difference between an automotive coil and a Mercruiser coil for a 4.3 with the thunderbolt ignition?… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
2005 350 mag mpi w/ alpha gen II drive in a 21 Cobia San Marino.
2005 350 mag mpi w/ alpha gen II drive in a 21' Cobia San Marino. The motor ran real rough last week when first started and was knocking near the exhaust bellows on the starboard side. The boat came o… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I have a 1993 Mercruiser 4.3L 4V. It starts fine, but when
I have a 1993 Mercruiser 4.3L 4V. It starts fine, but when run at full throttle, it does not accelerate past 3500rpm (it used to go to 4500 with this prop) and after a short while it begins to run lea… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I have a mercruiser 2005 5.0L Thunderbolt V ignition 2 bbl.
I have a mercruiser 2005 5.0L Thunderbolt V ignition 2 bbl. carb.alpha drive, the Seloc book says there is a knock sensor module and knock sensor ? I see none ! did the manufacturer forget it ? How el… read more
Jack
Jack
Marine Technician
Vocational, Technical or Trade Scho
54 satisfied customers
502 BBc 9to 1 compression, Merc 500 hp cam, Demon marine 750
502 BBc 9to 1 compression, Merc 500 hp cam, Demon marine 750 carb, MSD ignition running 32 Degrees total advance. Runs great to about 4200 rpm and destroys pistons at about 4300. two motors in a row, … read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

19,609 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x