Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have 15 hp evinrude outboard from 83. Engine will start,
hi. I have 15 hp evinrude outboard from 83. Engine will start, and run, but in nuetral doesn't seem to hit high rpm. Under load the engine will fail when you try to rev into high rpms … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
We just changed the oil of a 15 hp Mercury outboard. We go
We just changed the oil of a 15 hp Mercury outboard. We go to start it up and it fires up and then dies off. It fired up and ran fine last week. Will not start when throttle is added. … read more
Charles
Charles
Certified Mercury Tech
5,471 satisfied customers
I have a 60hp 3 cylinder outboard. Model - CJ60TLCEA. Carb
Hi there, I have a Johnson 60hp 3 cylinder outboard. Model - CJ60TLCEA. Carb info is - 43266 MX 08 H W The engine starts great. idles good, but when you take off you have full power for just a couple … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 1990 40 hp Evinrude. It fires right up and idles
I have a 1990 40 hp Evinrude. It fires right up and idles fine. But when you throttle it up in gear, it backfires here and there. Can unburned oil that is there from previous trips cause this? I just … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 70 hp Evinrude that I just bought (used). Ran fine
I have a 70 hp Evinrude that I just bought (used). Ran fine on sea trial. Ran fine today for first hour, now seems like it is missing on a cyl. Cooling water NEVER got above ambient.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2002 Mercury 15hp four stroke outboard. It idles
I have a 2002 Mercury 15hp four stroke outboard. It idles and runs fine but is missing at full throttle as if it is being starved a bit. The plugs were very lt. brown. Looks a little lean to me. Motor… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 48 SPL Evinrude with an electric start. There are
I have a 48 SPL Evinrude with an electric start. There are 2 levers the one on the right is N, R and the throttle. But I'm unsure what the level on the left is for. I believe the choke is in the key s… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1987 V4 140 hp evinrude. Just changed the power pack.
I have a 1987 V4 140 hp evinrude. Just changed the power pack. at idle can accelerated the engine to full rpms, but under load it will only turn 3000 rpms. Can you help me ID the problem?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 1985 Evinrude 115hp VRO. It starts right up and idles
I have a 1985 Evinrude 115hp VRO. It starts right up and idles fine even at high idle (warm-up). Once you start to throttle up to take off, it seems to just lose power. I have checked fuel flow and th… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Since you did me well last time here we go again. 1999 Mercury
Since you did me well last time here we go again. 1999 Mercury 15 hp 2 stroke electric. History, sat in barn for ten years with gas in carb. Almost no running time on this motor. Have used spray carb … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 50 hp TL & TX Evinrude of approximately 1994s vintage.
I have a 50 hp TL & TX Evinrude of approximately 1994's vintage. When taking it out of storage, it is hard to keep running with water muffs on it. I have to prime it just to keep it running. I used a … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
70 hp mariner, runs well with muffs. put in water and will
70 hp mariner, runs well with muffs. put in water and will push when in gear at 1000rpm, after that will push up to 2000rpm and then start to die out. checked spark and it is over 1/2 inch. acts like … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
1997 200 hp evinrude ocean pro. Ran fine last week. This week
1997 200 hp evinrude ocean pro. Ran fine last week. This week end, started but wouldn't stay running unless some one keep continuously pumping the fuel primer bulb. New fuel from a reliable marina. My… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Hi, I have a 1999 Evinrude 150HP FICHT outboard that wont
Hi, I have a 1999 Evinrude 150HP FICHT outboard that won't run under load at more than 2200 RPM. It will start ok and runs at less than 2200RPM ok. In neutral, it will rev up to 3500 with no problem. … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1975 Evinrude 6 hp (Fisherman, made in Belgium). At
I have a 1975 Evinrude 6 hp (Fisherman, made in Belgium). At slow speed (and idle) it works well even if with some pops. When I give full throttle it does not reach full rpm. After some time (few seco… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
1977 Evinrude 70 hp. Starts great, new carb kits, new fuel
1977 Evinrude 70 hp. Starts great, new carb kits, new fuel tank and line, but it has an issue after it runs. Once I shut it off and it cools for a bit. After restart, it will idle fine, but if I try t… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
70 hp 1991 Evinrude with VRO disconected for the past 5 years. Motor
70 hp 1991 Evinrude with VRO disconected for the past 5 years. Motor starts and idles fine but when pushed to WOT only reaches about 2000 rpm. After 3-5 min it will "jump" to 5000 rpm (like a kick in … read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
does an evinrude 140943 have a shift interrupter switch and
does an evinrude 140943 have a shift interrupter switch? and will this cause lost of power above certain speeds or rpms. motor starts and idles fine , all 4 cylinders are firing per spark plug test . … read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x