Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a no start prob.87 Marine 350/260 ,Have spark ,have
I have a no start prob.87 Marine 350/260 ,Have spark ,have fuel,trimming is on. Don't seem to be getting fuel to plugs .rebuilt carb , … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
1984 aq125a volvo engine, petronics ingnition, correct coil.
1984 aq125a volvo engine, petronics ingnition, correct coil. new plugs, it hestitates then stalls on throttle up, if i feather the throttle then it gets going just fine, acts like it flood after idlei… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a pair of 5.7's V8 Crusaders in a boat I just had
I have a pair of 5.7's V8 Crusaders in a boat I just had surveyed. Port engine was not running the same RPM as starboard on sea trial and compression test showed 160, 155, 135, 135 115, 140, 135, 135.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I was hoping it was just a raw water pump issue regarding my
Jason, I was hoping it was just a raw water pump issue regarding my first question about my 5.7 volvo penta that overheated and I was towed into the dock in Half Moon Bay CA. If you recall it started … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
1995 Johnson 115 starts and runs good on muffs but in the
1995 Johnson 115 starts and runs good on muffs but in the water will not get above 3200 rpm. I have changed fuel filter and the dreaded gray fuel lines but still the same problem. Whats next?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I HAVE A YEAR 2000 5.0 GM TBI VOLVO PENTA THAT WILL NOT IDLE
I HAVE A YEAR 2000 5.0 GM TBI VOLVO PENTA THAT WILL NOT IDLE WHEN COLD. IT STARTS WHEN COLD AND WILL RUN AT ABOUT 2500 RPM AND THEN AT 2000 RPM. WHEN THE TEMP GOES UP TO ABOUT 160 F THE ENGINE WILL ID… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 3.0 volvo penta engine on my 99 boat it starts, idles
I have a 3.0 volvo penta engine on my 99 boat it starts, idles and runs fine at slow speed but when it reaches 2000 and until it pass 2400 rpms it trembles and sounds like it ready to stall. Once it t… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
honda BAWS-3001412 reduced compression on middle cylinder (limp
honda BAWS-3001412 reduced compression on middle cylinder (limp mode???) won't run on middle cylinder.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
My moms friend thinks he threw a rod in his boat. Im happy
My moms friend thinks he threw a rod in his boat. Im happy to help and learn but im not sure what engine he has. I think its a VOLVO Pinto 350. Does that sound familiar? I just cant find much online.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
Mr. Abiorca. Yesterday , I started the engine and it took
Yesterday , I started the engine and it took little bit for the temp gauge to come up. ia accelarated and then it moved While idling at 1000 rpm started to overheat past 180 degrees and I turned engin… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I did a compression test on my 350 volvo penta when the
i did a compression test on my 350 volvo penta when the engine was cool and in the right head all pistons where 180 psi and the left head was 155 psi all the pistons is this normal… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
i have a volvo d6 inboard the sump is being pressurised forcing
i have a volvo d6 inboard the sump is being pressurised forcing oil up the breather pipe into the air intake and into the engine thi s motor has done only 29 hours and is 4 weeks old also the compress… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
hi, i just bought a 1999 wellcraft 175S penta volvo 4.3gl.
hi, i just bought a 1999 wellcraft 175S penta volvo 4.3gl. brand new motor not rebuilt. it sat in a garage for 2 years with a full tank of gas. the man said to drain the gas out of it but my husband d… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
Hi I have a problem with my volvo penta 5.7 Gi 280HP. Gasket
Hi I have a problem with my volvo penta 5.7 Gi 280HP. Gasket burnt and had to replace cylinder and rings. This engine has only about 400 hrs. So is this a reliable engine? Where there any similer comp… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
My new 350 volvo penta chevy engine pings at rpms higher than
My new 350 volvo penta chevy engine pings at rpm's higher than 3400, doesn't ping under 3400. I have a new 650 holley 4 barrel carb on it. We just filled up at the dock with 87 octane unleaded which f… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 87 4.3 v6 gm, I do not have the outdrive on. I purchased
I have a 87 4.3 v6 gm, I do not have the outdrive on. I purchased this boat "broke", the previous owner stated that the engine would idle ok, but when you give it throttle it will run for a min then j… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
have boat with chevy engine casting # 3970010 with eletronic
have boat with chevy engine casting #(NNN) NNN-NNNNwith eletronic ingition and carburated need to figure out plug gap and timing degree, can you help?… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
1989 7.4l volvo penta, ignition module part number 3854230,
1989 7.4l volvo penta, ignition module part number(NNN) NNN-NNNN problem is from dead stop to full speed runs perfect, from idle-3k rpms runs perfect, from 3k-4k rpms backfire through carb. extremely.… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x