Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
4.3 liter mercruser with thunderbolt ignition hesitates when
4.3 liter mercruser with thunderbolt ignition hesitates when applying full throttle. It happens when cold and hot. I clanged plugs and wires and cap and roter before putting in the water.It was runnin… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
1997 mercruser 350 chev runs fine minutes starts to run
1997 mercruser 350 chev runs fine for 20 minutes starts to run rough slows down valves start to rattle slows more backfires out carb and shuts off -if I reduce the throttle it doesn't backfire as much… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I own a Mercury 25hp 4 stroke. The serial number is *****
I own a Mercury 25hp 4 stroke. The serial number is ***** The story is that when I start it it runs fine at idle. I then take it out on the lake, a slow stroll around the lake and all is fine. I then … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
99 merc 90 HP carbureted Motor will out of the blue just start
99 merc 90 HP carbureted Motor will out of the blue just start slowing itself down from high speed....then come back to speed ...then go back to a slower speed.... sometimes going all the way down to … read more
Charles
Charles
Certified Mercury Tech
5,446 satisfied customers
I have a 1998 V6 Evinrude e150execd. I have replaced all the
I have a 1998 V6 Evinrude e150execd. I have replaced all the fuel bowls because they were cracked and rebuilt the carbs last year. I have replaced the Fuel/Oil pump with a new unit 2 months ago. I hav… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2002 mercruiser 330hp 18 months ago my hoist
I have a 2002 mercruiser 330hp 18 months ago my hoist set down and the packing was leaking 2/3 of the engine was submerged since then the engine running great for 20min or so will cough and sputter I … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
More stalling problems. 1998 Mercruiser 4.3L. Ran well all
More stalling problems. 1998 Mercruiser 4.3L. Ran well all last year. This season, new fuel filter/water separator, starts cold easily, runs smoothly at low speed for 10 minutes to get to open sea. Th… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,804 satisfied customers
I have a 1964 5.5 Evenrude motor. Gas is not getting from carb
I have a 1964 5.5 Evenrude motor. Gas is not getting from carb to cylinder .I put gas in the cyl. and it starts but dose'nt keep running. There is gas in the flout ball. Carb has been rebuilt. Fuel pu… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 1984 55hp Evinrude motor with the throttle toward
I have a 1984 55hp Evinrude motor with the throttle toward the front of my boat. When I shift to neutral the motor idles to slow to shift into gear. What should I do so that the motor does not die whe… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 66 evinrude 40 horse big twin electric start what
I have a 66 evinrude 40 horse big twin electric start what is the fuel to oil ratio is it 40 to 1 or 50 to 1. It ran great for two days here at the lake but then now when putting slowly for awhile you… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My 2003 chaparral 180 with a 3.0 volvo penta wants to hesitates
My 2003 chaparral 180 with a 3.0 volvo penta wants to hesitates when getting the boat on a plane quickly. The engine also seems like it will stall unless I back off the throttle I was told by my mecha… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
We own a 15 HP 4 stroke Mercury outboard. Worked great first
We own a 15 HP 4 stroke Mercury outboard. Worked great first 2 years (now 3 years old) but lately seems to be a fuel problem - perhaps air block in rubber hose? Have replaced hose and fittings but pro… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
1,804 satisfied customers
what would cause my 1974 302 225 hp mercruser to stall when
what would cause my 1974 302 225 hp mercruser to stall when trolling on lk michigan also it is running real ruff between 1200 and 1500 rpm's. runs great at 800 to 1000 and over 1400 rpm's Chnaged out … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 1985 Formula 18Ft in very good shape - it has a 260
I have a 1985 Formula 18Ft in very good shape - it has a 260 Mercruser V-8 engine and a Bravo III outdrive. I use it primarily as a utility / short run (less than 1/2hr.runs) boat - Even at relatively… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,399 satisfied customers
I warm my boat up and when I put it into gear it dies. I was
I warm my boat up and when I put it into gear it dies. I was woundering if the idel is to low or if it might be something else. If it is the idel which screws should I adjust. I have a 7.4 mercruser e… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
have a 198 evinrude 3 cylander 70. Starts fine and runs fine
have a 198? evinrude 3 cylander 70. Starts fine and runs fine at 1/4 to full throttle. if idling or slow speed motor will run fine then just quits ( like it is starved for gas) motor is then difficult… read more
Expert
Expert
I have a Bayliner Cierra 2855 with a Merc 4.3. I was cruising
I have a Bayliner Cierra 2855 with a Merc 4.3. I was cruising at 3200 rpms, evrything was fine then suddenly the boat begin to slow down and throttle back until it stopped. Would not start, but it wou… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
i have 1960 johnson...on the dials at top..slow speed it is ...
i have 1960 johnson...on the dials at top..slow speed it is on 2 by lean and the bottom which says high speed the dial is at 1 by lean..do these hae to do witht the speed of motor? how do i make it go… read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x