Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1997 4.3 liter mercruiser and the ignition control
Hi, I have a 1997 4.3 liter mercruiser and the ignition control module is bad. It's a denso(###) ###-####and the bar code reads 861251-1 4.3L/LH Alpha. I found a replacement part, it's a denso(###) ##… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a question I have bought 2 x good second hand Two
I have a question I have bought 2 x good second hand Two Mercruiser Diesel 250 DTronic 250hp 4.2l 6 cylinder with Bravo 3 Stern legs. However the Transom Assemblies is not good on these there was a leak in the transom I currently have 2 x 260hp 5.0l V8 Mercruiser with Alpha 1 Legs … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,668 satisfied customers
Looking to buy a 1987 Sea Ray 268 Weekender but it has a
Looking to buy a 1987 Sea Ray 268 Weekender but it has a single Mercruiser 454 Mag Alpha 330 Hp stern drive and I hear this was discontinued by Sea Ray with this model because a Bravo One Two or Three… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,668 satisfied customers
can I install two very good bravo two outdrives both upper
can I install two very good bravo two outdrives both upper & lower on a boat that previous had bravo 1's on before ? if so what would I need in addition to do?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
The manual that came with my boat (1977, 26 Uniflite Sedan)
The manual that came with my boat (1977, 26' Uniflite Sedan) shows two Mercruiser engine models: 330 TR and 330 TRS. It appears the difference is the gear ratio the TR being 2:1 and the TRS 1.5:1. The… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
Is there a duoprop outdrive configuration that will exchange
Is there a duoprop outdrive configuration that will exchange with my 1994 (350V8), alpha one Mercruiser leg? The boat is a 1994 Campion 24', and so far have not talked to anyone who has tried this wit… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 220 hp 4.3l mercruiser 2005 with alpa 1 leg. Engine
I have a 220 hp 4.3l mercruiser 2005 with alpa 1 leg. Engine sometimes cuts out when I put into gear. usually after running for a while. I also find restarting can be difficult after motor has been ru… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,668 satisfied customers
I have a mercruiser 5.0L MPI Bravo engine and would like to
I have a mercruiser 5.0L MPI Bravo engine and would like to fit in boat with alpha transom assy and drive. I have make adjustments to water entering engine and replace shift bracket. Question is: do I… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
horse power raring of a bravo compared to an alpha 1 as ||I
horse power raring of a bravo compared to an alpha 1 as ||I have a 454 with a alpha 1 that can blow up easy I would like info to upgrade. thank you Mark… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
What is best combination for stern drive and d254 turbo ac
What is best combination for stern drive and d254 turbo ac mercruiser 1993.Also what is good ratio will be used.Boat is Wellcraft 26 foot cca 2800 kg. Thanks Mario from Gold Coast Australia.… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I just bought a 32 planing hull cruiser that needs to be repowered,
I just bought a 32' planing hull cruiser that needs to be repowered, probably with twin 5.0 mercruiser EFI and Bravo II. Displacement wet is about 14,000 lbs. What stern drive gear ratio would you rec… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hello i have one of mercruisers 454 with a alpha drive and
Hello i have one of mercruisers 454 with a alpha drive and we want to replace it with a bravo 3 unit what will interchange and do they make a kit to do so the boat is a 1987 colbolt 24 ft money is no … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi Guys, Really need some advice here ! I have just bought
Hi Guys, Really need some advice here ! I have just bought a 36ft cruiser with 2 x 454(330hp) MCM330 Mercruisers & the stern drive legs are both 330TR serial No.'s(NNN) NNN-NNNNport side) &(NNN) NNN-N… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a MCM 7.4LX EFI ( GEN VI ) Bravo serial # XXXXX
I have a MCM 7.4LX EFI ( GEN VI ) Bravo serial # XXXXX I need some help figuring out what the model is exactly what does the X in the LX stand for? I see seveal 7.4L models and only a few 7.4LX I gues… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Good Day all, I am looking at buying a 28 foot leeder with
Good Day all, I am looking at buying a 28 foot leeder with twin 4.3 v6 motors with 700 hours on them.. one of the motors when started and revved pumps water out the back I thought it was the exhurst m… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
350 magnum merc efi/mp. It shift well into reverse, but shifting
350 magnum merc efi/mp. It shift well into reverse, but shifting forward it lags. I need to move the shifter forward more to engage forward, therefore, the throttle is higher giving you a sudden engag… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Hello I have a 1984 Mercruiser 330 that is leaking oil
Hello I have a 1984 Mercruiser 330 that is leaking oil out the propeller shaft. How do I tell what model drive it is? Ther serial number is(NNN) NNN-NNNN I have been told that it is a TR.… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
i have a mercury mercruiser 5.0 2003 engine and the fuel ...
i have a mercury mercruiser 5.0 2003 engine and the fuel pump does not shut off when i turn the key off… read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x