Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
To get to the gimble bearing on a '91 Bayliner I/O with an
To get to the gimble bearing on a '91 Bayliner I/O with an "L" shaped foot, do you remove the foot or the motor?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
my2001 Bayliner Capri 2150 5.0 merc will start then stall after
my2001 Bayliner Capri 2150 5.0 merc will start then stall after 2-3 minutes. I might get it to kick over 1 more time for a second or two, before it stalls out again and not start. I think it is a fuel… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,627 satisfied customers
I have removed all the bolts and wires connected to the starter
I have removed all the bolts and wires connected to the starter on my 1988 bayliner Capri V8. The bolts were offset and now I am having trouble removing the old starter from the enginge.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1990 Mercruiser 7.4 with a Bravo 3 outdrive. I need
I have a 1990 Mercruiser 7.4 with a Bravo 3 outdrive. I need to tighten the water pump impeller belt. It appears to be separate from the alternator belt. How do I tighten this belt? Thanks!… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi, I own a 2001 Bayliner Capri 1850 with the 4.3 Mercruiser.
Hi, I own a 2001 Bayliner Capri 1850 with the 4.3 Mercruiser. For some reason the radio quit working. The accessory wire no longer gets power to it. I've had several people tell me to check the fuse. … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
i have a 1995 2050 Capri Bayliner boat with a 4.3 liter engine.
i have a 1995 2050 Capri Bayliner boat with a 4.3 liter engine. It was sunk before I bought it. It had sand thru everything. I had trouble with the steering. It only turned one way. We discovered that… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1990 Bayliner capri 120 hp Merc force inboard that
I have a 1990 Bayliner capri 120 hp Merc force inboard that i've just purchased, it starts fine but the rpm fluctuates from 2000 to 4000 without sitting at a steady rpm for very long any ideas as to w… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
89 Bayliner Capri with the crappy 2.3L Ford. Crankcase full
89 Bayliner Capri with the crappy 2.3L Ford. Crankcase full of emulsified oil. About 1.5 gallons worth. Noticed that the check valve in the exhaust that is meant to stop water from coming back up the … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 1987 bayliner with a 2.3L and a omc 984540 model and
I have a 1987 bayliner with a 2.3L and a omc 984540 model and i want to know if i can change out a 1990 4.3L with a model 986032 omc back half of the omc… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Hi, we have a mid 70s Mercury 115 hp Thunder outboard. We
Hi, we have a mid 70's Mercury 115 hp Thunder outboard. We took the old 1990 90hp Force that came with the boat we just bought as it didn't work. We bought a nice working Merc but the bracket clamps a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i have a 87 bayliner capri 19ft openbow with a 3.0 omc motor
i have a 87 bayliner capri 19ft openbow with a 3.0 omc motor has no outdrive can not find one . i was wondering if i could switch the motor to a merccrusier 3.7 and alpha 1 outdrive on this boat… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Have a 1992 Bayliner Trophy with 3 liter and alpha leg. Raw
Have a 1992 Bayliner Trophy with 3 liter and alpha leg. Raw water used in salt water and motor is done. Was badly underpowered and am considering repowering with 4.3 (carbed or MPI ?) Boat plate indic… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Trying to hook up the starter to my 90 horse outboard mercury.
Trying to hook up the starter to my 90 horse outboard mercury. It's on a 2001 bayliner capri. It was removed and now we don't remember how it goes. Our attempts have been wrong because the bendix spin… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
1985 Bayliner Capri w/ 5.0 OMC trying to replace engine starter.
1985 Bayliner Capri w/ 5.0 OMC trying to replace engine starter. I'm attempting to help a friend and I removed the wires and outboard bolt on the starter. 1rst Q. Is there an inboard bolt to remove ? … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a new used 1989 Bayliner Capri with a ford 2.3 l and
I have a "new" used 1989 Bayliner Capri with a ford 2.3 l and OMC outdrive. Can I, an experienced do-it yourselfer, with a complete set of tools and a factory manual, safely replace the impeller?… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1996 bayliner capri 1850. With a 3.0 I/O. The started
I have a 1996 bayliner capri 1850. With a 3.0 I/O. The started is bad and cant figure out how to get it out to replace it. Anything you can tell me?… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I need to replace the starter solenoid on my 82 Wellcraft (260
I need to replace the starter solenoid on my 82 Wellcraft (260 mercruiser / 350 chevy) There is very little room in the engine compartment. What tricks or what is the easiest way to remove and reinsta… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
hi,i bought a 1988 bayliner trophy 21 ft. it had a 4.3 from
hi,i bought a 1988 bayliner trophy 21 ft. it had a 4.3 from fact. a 5.7 was put in 2004, the leg had to be rebuilt in 2006, was this from to much torque from the 5.7 or is it the same leg as the 4.3?… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x