Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 18ft 1985 ranger 370-v w/ a 150 mercury blackmax
I have a 18ft 1985 ranger 370-v w/ a 150 mercury blackmax that had a 23p prop that takes off very slow out of the water. A mechanic said I should try a 21" pitch or 19" pitch. I tried a 21" pitch over… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,666 satisfied customers
Have a new ranger pontoon with 90 hp 2020 4 stroke only
Have a new ranger pontoon with 90 hp 2020 4 stroke only reaches 20 mph and 5200 rpm it's a 20 ft pontoon total length 21 11 … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
How do I reset the safe mode to run properly on my Mercury
How do I reset the safe mode to run properly on my Mercury 60 EFI Big Foot out board/ … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 24' pontoon 2011 with Honda 50 outboard. Rpm's
I have a 24' pontoon 2011 with Honda 50 outboard. Rpm's reach 6300-6400 and will maintain it for 2-3 minutes then gradually slows to 3500-3600 rpm.... I get out of the throttle and put into neutral an… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Have an 80hp Mercury engine. It will not go above 4600 rpm.
Have an 80hp Mercury engine. It will not go above 4600 rpm. Back it to 4200 and you get a 100 rpm surge. Also, the engine sounds like it is cycling (like a weed eater) above 4200. Bring it back down a… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2005 60hp Yamaha outboard which is in great shape
I have a 2005 60hp Yamaha outboard which is in great shape was running great then started dropping rpms from 6000 to 4000 then back to 6000. I took it to the local marina where the guy worked on it a … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Hi all, I purchased a 2006 Islandia, all is good except for
Hi all, I purchased a 2006 Islandia, all is good except for an intermittent problem with return to idle on my port engine. Below 5200 rpm engine throttles up and down correctly. When I take it past 52… read more
Expert
Expert
I have a 2000 50hp 2 stroke mercury outboard. Starts fine,
I have a 2000 50hp 2 stroke mercury outboard. Starts fine, runs along fine max rpm on a 18ft. pontoon 5200. All at once it reduces rpm to 3400, ran at 3400 for about 30 minutes. Then bam, back to 5200… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 31 ft boat in Brazil. Comfortable but weighs 5200
I have a 31 ft boat in Brazil. Comfortable but weighs 5200 lbs. It has a VP 5.7 Gxi with f2 duo props. Can't get over 4800 rpm for a speed of 34 mph max. Guess that's to be expected for this package o… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 2005 115 hp 4 stoke EFI engine. It doesnt seem to
I have a 2005 115 hp 4 stoke EFI engine. It doesn't seem to deliver the performance I think it should. It came to me with a 17" prop and would only tach about 4800 rpms. I changed to a 15 and it gets … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 17.5 Lund Tyee (rated to 140 hp) and I fish Lake
I have a 17.5' Lund Tyee (rated to 140 hp) and I fish Lake of the Woods in northern MN & Canada with 4 adults in the boat. Mercury makes 115, 125 & 135 hp Optimax motors. Other than the small differen… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I was told my computer went out on my Mercury 60 HP Bigfoot
I was told my computer went out on my Mercury 60 HP Bigfoot motor. This is a authorized dealer. They told me it would be $5000 dollars but it is covered under warranty. Do you see this very often? Als… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I was told my computer went out on my Mercury 60 HP Bigfoot
I was told my computer went out on my Mercury 60 HP Bigfoot motor. This is a authorized dealer. They told me it would be $5000 dollars but it is covered under warranty. Do you see this very often? Als… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a mercury 60 hp bigfoot motor on a tracker fishin barge
I have a mercury 60 hp bigfoot motor on a tracker fishin barge 22 FT. I've had it a year. I went on the lake and it got up to 4000 rpm but normally it runs at 5200 rpm. Is 5200 reasonable or should I … read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
I bought a Tracker fishin barge with a 60 hp Mercury bigfoot
I bought a Tracker fishin barge with a 60 hp Mercury bigfoot motor and it ran at 5200 rpm and reached around 16 mph with one person. I bought it at bass pro shoudn't they have matched the correct prop… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have an 2004 200 h.p. evinrude motor. I love it. LAST WEEK
I have an 2004 200 h.p. evinrude motor. I love it. LAST WEEK I TOOK IT IN FOR 100 HOUR SERVICE. BEFORE TAKING IT IN, THERE WAS A MISS AT IDLE AND THE MOTOR WAS HARD TO KEEP RUNNING. NEW PLUGS WERE INS… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 2001 Yamaha XR1800 Jet boat. One engine is sticking
I have a 2001 Yamaha XR1800 Jet boat. One engine is sticking at like 4800 rpm and will run fine at that rpm indefinitely . You can gradually increase the throttle and nothing happens at first until yo… read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
What happens if the throttle and shifter cables on a Honda
What happens if the throttle and shifter cables on a Honda BF 150 are installed wrong, i.e., the shifter cable is attached to the throttle assembly? This is a Honda BF(NNN) NNN-NNNNoutboard motor… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x