We use cookies to give you the best possible experience on our website. By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.

Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them.
Related Boat Questions
I have bought an old Mercury 50 hp outboard motor. 1974 model
I have bought an old Mercury 50 hp outboard motor. 1974 model I believe. I need to know how much oil to mix per 6 gallons. We had an Evinrude 50 hp motor years ago and it 1 pint per 6 gallons. I just … read more
Jeff G.
Jeff G.
Owner, Outboard Service Center
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1971 Johnson 125 outboard.It seems to start ok on
I have a 1971 Johnson 125 outboard. It seems to start ok on land when cold with the muffs on, water flowing through hose etc. I took the boat recently for its first test run. It started ok on boat ram… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Jason, two questions. I have an old Johnson 15 horse outboard.
Jason, two questions. I have an old Johnson 15 horse outboard. Shop rewound the coil and replaced the gas pump. It was running fine last year after this work. I am wondering if my gas/oil mix is too s… read more
Jason
Jason
Marine Mechanic
24,583 satisfied customers
What can cause a Bayline Jazz Mericruiser not to run properly?
I just purchased a used Bayliner Jazz Mercruiser 120xr jet boat. Starts great does not miss. Very difficult to get on plan. runs around 40 tops. I grew up years ago, learning to ski on 16 ft boat with… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a late fifties vintage 10 horse Evinrude that runs like
I have a late fifties vintage 10 horse Evinrude that runs like a champ, the other day a friend asked If I KNEW for sure I was using the best possible gas/oil mix and and if I was using th best oil. I … read more
Jason
Jason
Marine Mechanic
24,583 satisfied customers
I just bought a 40hp older, not sure the year but its fairly
I just bought a 40hp older, not sure the year but its fairly old evinrude outboard motor and just wondering what the gas oil mixture would be… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi. A little about my project boat- I have a 1972 17 SeaRay
Hi. A little about my project boat- I have a 1972 17' SeaRay outboard. It was basically just a hull when I got it, having sat outside with the plug in for many years. I have worked 6 years restoring /… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
3,140 satisfied customers
I have a 20 year old Evinrude 50hp outboard on my 14 metre
I have a 20 year old Evinrude 50hp outboard on my 14 metre fibreglass boat. The carburettors have been cleaned thoroughly and the engine is correctly displacing water. It revs at high speed ok but wil… read more
Jeff G.
Jeff G.
Owner, Outboard Service Center
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have an Evinrude 3 horse outboard motor I inheirited from
I have an Evinrude 3 horse outboard motor I inheirited from my uncle. I am unsure of the oil/ gas mixture. Help… read more
Jason
Jason
Marine Mechanic
24,583 satisfied customers
This is a dumb question........ Im going to try to start
This is a dumb question........ I'm going to try to start my '82 Evinrude outboard after 4 yrs. of being idle.... I can not remember the oil to gas ratio!! I did mention "this was going to be a dumb Q… read more
Jeff G.
Jeff G.
Owner, Outboard Service Center
Vocational, Technical or Trade Scho
4,730 satisfied customers
I cleaned and installed carb kits in my Evenrude 50 HP. The
I cleaned and installed carb kits in my Evenrude 50 HP. The motor starts and idles fine, but at 1/2 to 2/3 throttle, the motor runs on 0ne cylinder only. Could it be the float not adjusted properly. I… read more
Jeff G.
Jeff G.
Owner, Outboard Service Center
Vocational, Technical or Trade Scho
4,730 satisfied customers
just bought a 17 ft bass tracker boat with 70 hp evinrude outboard
just bought a 17 ft bass tracker boat with 70 hp evinrude outboard motor. previous owner forgot to take the plug out after last fishing trip. boat was covered and stored. it rained for two weeks the b… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
570 satisfied customers
1963 5.5 evinrude fisherman last ran 1971 sat in garage dry
1963 5.5 evinrude fisherman last ran 1971 sat in garage dry oil in plug holes. I bought it mixed up 50:1 fule cleaned out cilinders with air cleaned up plugs. 3 pulls with choke and it started in 55 g… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I just bought a boat with a 1968 Murcury 100 hp. outboard engine,
I just bought a boat with a 1968 Murcury 100 hp. outboard engine, and I would like to find out the propeer gasoline / oil mixture for this engine. I have been told 16:1, 32:1, and 40:1... Any help fro… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
I have a 1986 70 hp outboard that has set for about 2 years
I have a 1986 70 hp outboard that has set for about 2 years and will not run. It ran like a champ until it sat. I have changed the gas and oil mix and have run carb cleaner through the engin. The engi… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have bought a 1983 Venture with a 150 Mariner outboard. This
I have bought a 1983 Venture with a 150 Mariner outboard. This boat has been siting up for a few years. What should I do before thinking about getting it in the water?… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Hi, should have asked this question befor I bought this engine
Hi, should have asked this question befor I bought this engine but here goes. I bought a 1990 88 HP Evinrude outboard to power my 24 ft fiberglass pontoon boat. Seems to run alright but was wondering … read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
I have a 55 johnson outboard motor 1977, I cant keep running or idle
I just recently purchased the boat and motor and I put new gas and oil mixture in it 50:1 and took it to the marina to go boating, I was able to start the engine up but unable to keep it running say a… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Show more
Disclaimer: Information in questions answers, and Show Less
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

4,761 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Jason

Jason

Marine Mechanic

24,583 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Noel Schembri

Noel Schembri

Marine Mechanic

3,140 satisfied customers

Advanced technical diploma

TIMOTO

TIMOTO

Mechanic

170 satisfied customers

Former Kawasaki pwc tech. current Honda pwc tech.

Cat Man

Cat Man

Cat Engine Expert

167 satisfied customers

23 years Caterpillar Engine Experience

Yachtwork

Yachtwork

Marine Engineer

3,680 satisfied customers

MEC3 and RYA Yachtmaster Ocean

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x

© 2003-2023 JustAnswer LLC