Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
How much do you charge for answers? I have a 2000 mercury
I have a 2000 mercury 175xr2 sportjet. Thermostats and poppet valve delete. Have good water circulation on hose. In water no water at tell tale. Have water flow on hose through all.lines . The only place under an obstruction is at the starboard side bottom at the brass.fitting on figure 8 style poppet cover. I tried putting air, air.and water, and it does not flow through the small hole behind poppet cover. I.removed cover and ran hose good flow.from.large hole with no poppet valve, but no water from small hole … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
150 mercury 2 stroke serial 0G814787 overheating at idle.
150 mercury 2 stroke serial 0G814787 overheating at idle. Rebuilt water pump and replaced both thermostats. When start up see major turbulence that I assume is air being pumped out of 5he system, then… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Just replaced my water pump and impeller on my 94 135hp
Just replaced my water pump and impeller on my 94 135hp Mariner, took it out, pees fine when idling but stops peeing at about 3/4 open throttle. I can put it in after that, rev it up and starts peeing… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I believe I have a blockage in the popet valve. the motor
I believe I have a blockage in the popet valve. the motor begins to overheat above 1200 rpm. Water pump is new . Water pressure goes up to 45psi. Removed the popet valve, looks OK. I tried squirting w… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I'm installing the MERCURY QUICKSILVER THERMOSTAT KIT 75692A7
I'm installing the MERCURY QUICKSILVER THERMOSTAT KIT 75692A7 on a 1990 60 HP 2 stroke Mercury engine with serial number 0C245219 to increase the operating temp. The engine currently does not have a t… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 97 Johnson 50 hp 2 stroke with power tilt trim. Took
I have a 97 Johnson 50 hp 2 stroke with power tilt trim. Took motor off tilt trim to replace o rings in the cylinder. When I got the motor off I turned the unit upside down to drain hydraulic. A small… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Is it normal for the poppet valve to weep? I replaced it and
Is it normal for the poppet valve to weep? I replaced it and thermostats as preventative maintenance. The old did not weep. Flow from tell tale is very strong at all rpm. new impeller. NO heating issu… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
2001 merc 150 carb engine. S/n 0t395869 , engine is running
2001 merc 150 carb engine. S/n 0t395869 , engine is running warm at idle speed in gear temp around 160-180 and tell tail is weak,anything above idle speed all is good,temp is steady at 140-145 and goo… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Hi I have a 1975 mercury 650 65hp 3 cycl. Engine. Im having
Hi I have a 1975 mercury 650 65hp 3 cycl. Engine. I'm having issues with water flow.. There is no water coming out if the "weep hole", "tell-tale", or "pee hole" I'm not sure what the formal name is. … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Looking for the raw water impeller part number for a marine
Looking for the raw water impeller part number for a marine diesel generator (Westerbeke). The pump looks like the Westerbeke 33636 pump but it has an "O" ring instead of the paper gasket. It's a 7.5 … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have replaced water pump on my 200 Mercury Outboard Motor
I have replaced water pump on my 200 Mercury Outboard Motor and can't figure out why I am still not getting water to the upper end.… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I broke off the port drain plug (the large plug) in a 1993
I broke off the port drain plug (the large plug) in a 1993 Mercruiser engine. The resulting hole diameter is 3/8 ". I tried using an "EZout", but couldn't remove it. The EZout kept slipping. Should I … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
3GM30F High internal pressure causing oil leaks, starts and
3GM30F High internal pressure causing oil leaks, starts and runs fine. What can be done to reduce pressure?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a Evinrude 40 hp 1993 E40TTETF. To know how to change
I have a Evinrude 40 hp 1993 E40TTETF. To know how to change water pump impeller. Engine is off getting bored at a shop. Top of drive shaft and shift rod is clear. Also have the four bolts out of the … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
How do I reassemble my sea water pump in my Mercruiser 5.7
How do I reassemble my sea water pump in my Mercruiser 5.7 L V8 2004 model year, Bravo One? I took it apart ordered the replacement 1 piece housing, impeller metal plate and it has 2 O-rings one small… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I run my boat about a mile,a solid alarm comes on.I idle a
I run my boat about a mile,a solid alarm comes on.I idle a few minutes,the alarm goes off.This keeps repeating itself.I have a new lower unit and new water pump,also I have good water pressure(18-20 l… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Hi Sir, I fix this boat now Hull Identification RGMP1239A888
Hi Sir, I fix this boat now Hull Identification RGMP1239A888 like to know what size engine and out drive, its has no engine or out drive at all can you tell me anything about this boat, its a Regal 19… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 35 honda outboard with tilt and trim.Its the bf35a
I have a 35 honda outboard with tilt and trim.Its the bf35a model.Need to know where to fill the tilt and trim up.The rod is slowly leaking when raised and need to add fluid.The reservoir I think is h… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x