Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I just put a new trim tilt motor and valve on. My out board
I just put a new trim tilt motor and valve on. My out board wont tilt up … read more
Morgan McKenna
Morgan McKenna
Utah Service Rep
Vocational, Technical or Trade School
TRIM ON MY 97 PONTOON WITH MERCURY 115 OUTBOARD IS LEAKING
TRIM ON MY 97 PONTOON WITH MERCURY 115 OUTBOARD IS LEAKING DOWN UNDER POWER … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
2004 mercury 75 hp 4 stroke will not go all the way up on
2004 mercury 75 hp 4 stroke will not go all the way up on the power trim. It will go about half way up , but no further . I tried bleeding the system repeatedly but with no improvement. The power trim… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Pearl. Kate here. I believe I may have a vapor lock in my
Hi Pearl. Kate here. I believe I may have a vapor lock in my trim system (1999 Yamaha 90 hp - C90 TLRX). I had to replace a wiper seal the other day and decided to go ahead and replace the o-rings as … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Need help with Mariner 90hp tilt system #g102535 we
need help with Mariner 90hp tilt system #g102535 we installed new pump but bleeding the system is a pain we can manually lift and lower motor by hand sometimes have to open release valve to raise all … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Trim on my 1996 75hp Merc wont go up all the way under load
Trim on my 1996 75hp Merc wont go up all the way under load (pushing boat). It goes half way and then gets stuck making short up down cycles about 1 inch up & down. It goes up & down fine when not und… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I replaced the trim rod seals in a 140tl79r Johnson that had
I replaced the trim rod seals in a 140tl79r Johnson that had been sitting for 7 or 8 years. I followed the proper fill procedure as well. Now, when I try to lower the motor, the port trim rod retracts… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Power trim and tilt problems with a Mercury 50 HP.
I have a 2006 Mercury 50 HP 2 stroke. Having trouble with the power trim & tilt. After I take off and start to trim the motor to raise the bow, I will start up but stop. If I start out with some trim … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1985 yamaha 70hp outboard. the power trim/tilt works
I have a 1985 yamaha 70hp outboard. the power trim/tilt works fine and quietly when going up. when going down it makes a screeching and sort of grinding noise. what could be wrong?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I need help with power trim and tilt troubleshooting.
I have a problem with power tilt/trim. Outboard motor has been in up position for the past 2 months and I am unable to get it to go down. The switches appear to engine the tilt motor. The typical soun… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a Yamaha F40B (two in fact) which has done 1000 hours.
I have a Yamaha F40B (two in fact) which has done 1000 hours. The power trim and tilt is malfunctioning. It raises and lowers fine on the switch, but when I leave it in any position it just sinks down… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a Yamaha 225 hp, 4 stroke, Salt water series outboard
I have a Yamaha 225 hp, 4 stroke, Salt water series outboard motor. The outboard is in the up postion. (Tilted up). Won't drop back down. I push the up botton on the throtle. I can hear noise. The two… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have two 135 Mercury Optimax DFI on my boat(2007). I have
I have two 135 Mercury Optimax DFI on my boat(2007). I have just done a kit replacement on the main Trim Tilt Cylinder. When replacing the seals and O rings some of the hydraulic fluid was lost. Would… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 1997 mariner 115 with power trim. The trim unit will
I have a 1997 mariner 115 with power trim. The trim unit will not raise and when lowered the fluid runs out of the hole below the pump and motor, it has the yellow fill cap and I have installed an o-r… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a outboard 2-stroke Evinrude 88 spl with power tilt.
I have a outboard 2-stroke Evinrude 88 spl with power tilt. The tilt motor worked and then stopped working. This is what I mean: The electric motor spins up, but it was taking a few seconds for the hy… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
if the power tilt and trim cylinder is leaking fluid....do
if the power tilt and trim cylinder is leaking fluid....do you have to replace the o ring....and if so....how… read more
FieldServiceTech
FieldServiceTech
Vocational, Technical or Trade Scho
146 satisfied customers
On an Evinrude 70 hp outboard (4 stroke) there is a tilt/trim
On an Evinrude 70 hp outboard (4 stroke) there is a tilt/trim system. The reservoir for the tilt/trim fluid is located on the transom and integral to the outboard mounting bracket. I was getting the b… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 35 honda outboard with tilt and trim.Its the bf35a
I have a 35 honda outboard with tilt and trim.Its the bf35a model.Need to know where to fill the tilt and trim up.The rod is slowly leaking when raised and need to add fluid.The reservoir I think is h… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x