Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a Honda bf40 on a 18' pontoon. the rpms never exceed
I have a Honda bf40 on a 18' pontoon. the rpms never exceed 2500 under load. did not have a tachometer before this year so dont know it it was different previous years … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,727 satisfied customers
I have a 2017 mercury 115 HP 4 stroke command thrust
I have a 2017 mercury 115 HP 4 stroke command thrust outboard on a Sun tracker 22 DXL pontoon. I can get 16 mph at 4000 rpm but when I go over 4000 rpm the rpm surges to 6000 rpm and the mph slows. I … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
2014 Bennington 2550 RBR Pontoon Boat, with outboard Yamaha
2014 Bennington 2550 RBR Pontoon Boat, with outboard Yamaha 200 XB engine serial 6DAL10016993. went out for the day,stopped for 1 hr. and boat was great,plenty of Power, no troubles.THEN on way back s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
Our 2010 Bennington 24 foot Pontoon Boat with a 2009 150 HP
Our 2010 Bennington 24 foot Pontoon Boat with a 2009 150 HP Evinrude E Tech outboard motor is pulling very hard to the right. Started last summer after being transported 2000 miles and put in to new l… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
I have an outboard Honda 50 hp motor on a Bennington
Hello! I have an outboard Honda 50 hp motor on a Bennington pontoon. I can't get my shifter to move the boat forward or in reverse... the shifter is a honda remote control... it looks like the motor i… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
I have a 2007 Yamaha F90TLR with 208 hours on it. it is on
I have a 2007 Yamaha F90TLR with 208 hours on it. it is on a 22.5 Bennington Pontoon boat. The only problem is it will only run 5100 RPM @ 14 mph wot. It might be propped incoreectly. What would the c… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
1994 2-cycle 70 hp Johnson outboard overheats at high load.
1994 2-cycle 70 hp Johnson outboard overheats at high load. I have changed the impeller still getting the same stream of water still overheats at high load. Alarm sounds and engine cuts back to slow s… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a inboard jet Mercury optimax 215 hp for a sugarsand
hi i have a inboard jet Mercury optimax 215 hp for a sugarsand boat it beeps when i push the throttle full blast and won't shut off unless i stop the motor and turn it off. do you know what is wrong. … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
i own a 2005 bennington pontoon, the outboard motor is an 115
i own a 2005 bennington pontoon, the outboard motor is an 115 mercury optimal outboard. it was running fine yesterday. Today we were on the lake and as i opened it up and was running it just turned of… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
3,038 satisfied customers
I have a 1997 Mercury Mariner 75 hp outboard engine on a pontoon
I have a 1997 Mercury Mariner 75 hp outboard engine on a pontoon boat. When running at moderate to high speed, the engine will suddenly drop down to a lower rpm for a few seconds, and then pick back u… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
I have a 2008 Mercury 150 outboard on my tritoon. When I am
I have a 2008 Mercury 150 outboard on my tritoon. When I am running at more than about 1/4 speed, everything is ok. When I am running slower, close to idle, the motor will start beeping and then cut o… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the helm is located at the rear. the boat is rated 1900 lbs/75hp . when i am towing a tube, the majority of the outboard shaft is under water and… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,961 satisfied customers
I just bought a 2000 model year ProCraft 180 Combo with a 150
I just bought a 2000 model year ProCraft 180 Combo with a 150 HP Mercury. There was no operations manual. The motor seems to run good, 5200 RPM, but above idle speed there is a beeping, like a warning… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
3,038 satisfied customers
I have a 2006 Bennington Pontoon with a 60hp 4 stroke bigfoot.
I have a 2006 Bennington Pontoon with a 60hp 4 stroke bigfoot. Everything was working prefect last fall when I put it away last winter. I just put in the water this spring and started fine. I started … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
150 horse, 2006, 4 cycle, yamaha F-150, only 30ish hours on
150 horse, 2006, 4 cycle, yamaha F-150, only 30ish hours on a flats boat, get beeping warning at idle, can't see water pressure guage ,am getting stream ( don't know how far its supposed to spit away,… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a warning beep going off. I talked to a mechanic & they
I have a warning beep going off. I talked to a mechanic & they said it goes off if the oil pressure is too low or if the water temp is too high. The alert only sounds when idling or slow speed. Once t… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
hello,my wife and I recently purchased a pontoon with a 05
hello,my wife and I recently purchased a pontoon with a 05 mercury 60 hp injected bigfoot outboard motor,we have taken it out several times without any issues, but the last two time out, a warining to… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2001 mercury 40 hp 4 stroke EFI outboard motor. only
I have a 2001 mercury 40 hp 4 stroke EFI outboard motor. only problem is that when returning to slower speed or idle speed after runing up to about 4500 rpm ....when returning to slower speed I get a … read more
joshua.mathis
joshua.mathis
High School or GED
14 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

4,115 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,961 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

3,038 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x