Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I repowered my 2003 searay 225 weekender from a 5.0 efi to a
I repowered my 2003 searay 225 weekender from a 5.0 efi to a 5.7 efi. With the old setup i would obtain around 45 mph at 4600 rpm. The new setup is a 5.7 with a 1.47 sei outdrive but I'm toping out ar… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
I have a 98 bayliner 2452 with a 5.7 and a closed cooling system.
I have a 98 bayliner 2452 with a 5.7 and a closed cooling system. The alarm goes off at 178 engine temp when at full speed. The shop couldn't get it to over heat , they inspected the impeller and serv… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
Hi, I have a volvo penta I/O 3.0 on a 2007 Reinell 185LS.
Hi, I have a volvo penta I/O 3.0 on a 2007 Reinell 185LS. It has a 15 15 prop. At high altitude ~6000 ft WOT is 2500 rpm at 30 MPH. It is definitely sluggish at altitude and stalls out at idle a lot. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
I had a 2005 Four winn 210 Horizon I bought new that was 22
I had a 2005 Four winn 210 Horizon I bought new that was 22 ft. long with 280 hp volvo penta engine and volvo single prop outdrive with a 19 or 21 pitch prop not sure which ran very well and strong wi… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
i have a 25 ft cuddy cabin walk around with a 350 mercruse
i have a 25 ft cuddy cabin walk around with a 350 mercruse i/o and the boat is about 4100 lbs. its a 1995 and i do not know if the engin has ever been overhauld. I cannot get the boat to plain off, th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
I have a Trophy 2352 which has a mercrusier motor. The motor
I have a Trophy 2352 which has a mercrusier motor. The motor has a 2 barrel carburetor and I have tried 4 different props and the motor will not rev past 3800 RPM. My biggest problem is hole shot. I p… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
So a continuing saga... Found out yesterday that Volvo Penta
So a continuing saga... Found out yesterday that Volvo Penta (VP) has deemed my new outdrive has the same gear ratio as the old. But now they also believe that the cause of my "poor performance" may b… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
I have a 2004 formula 382 Fastech w twin 496 HOs. The boat
I have a 2004 formula 382 Fastech w twin 496 HOs. The boat sat for some time and went out for the first time in a year last week,. The boat ran good about 60-61 at 5000rpms. After 15 minutes it shut d… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I had a VP XDP composite outdrive replaced with a new DPS-A
I had a VP XDP composite outdrive replaced with a new DPS-A Oceanx. With the old drive I was getting 4600+- rpm at WOT, but now with the new drive I am only getting 4200. And yet I was told that the n… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
23,082 satisfied customers
hi i have a 79 searay 197 with a mercruiser drive matched up
hi i have a 79 searay 197 with a mercruiser drive matched up too a 302 ford wondering what prop should be on it. It currently has a 14.25 x19 4 blade I do alot of fishing and cruising… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1996 23.5 Monteray BR with a 5.7 FL Volvo engine
I have a 1996 23.5' Monteray BR with a 5.7 FL Volvo engine and Volvo Penta DP drive. What are the proper props for this boat. Recomended RPM @ Full throttle is 4000-4400… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
What diameter & pitch propellar would you recommend for a 27
What diameter & pitch propellar would you recommend for a 27 ft, 5000 lb, cabin cruiser with a 1987 mercruiser 454 / alpha 1 sterndrive? I bought an under-performing boat with a prop that cannot be re… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
being told all diff things what is the max rpm and what is
being told all diff things what is the max rpm and what is the best prop to use to acheieve this with out over reving the boat is a 98 bayliner capri with the 3.0l(NNN) NNN-NNNNmodel… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Hi. I just bought a Strattos 285 xl bass boat with a 150 hp
Hi. I just bought a Strattos 285 xl bass boat with a 150 hp evinrude outboard. The average altitude I run at is between 5000 ft and 8000 ft here in Utah. I was isure a 4 blade prop 13 and 1/2 diam. an… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have twin Volvo Penta 8.1 GXI straight inboards, 420 HP,
I have twin Volvo Penta 8.1 GXI straight inboards, 420 HP, ZF 63 A Hurth trannys 2006 Models. Just completed new engine mounts & engine & transmission alignment. ( Professionally Done) 1 Problem, Engi… read more
Mike of Pompano Beach
Mike of Pompano Beach
Charter Fleet Maintenance
18 satisfied customers
Carver 350 Mariner. 2001. only 195 hrs. Momentary top RPM 4,300.
Carver 350 Mariner. 2001. only 195 hrs. Momentary top RPM 4,300. Cruise at 3,800 RPM getting 16 knots. Only 0.5 mpg?? Hull is clean. At 105 hrs: starboard engine with burn valve, pulverized........new… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a 1998 crownline 266 br with 7.4 l mpi-mercruiser
i have a 1998 crownline 266 br with 7.4 l mpi-mercruiser engine #0l042497, bravo 3props-26p.The boat jumps out of the water and the top speed is around 50. I just finished putting trim tabs(minn kota)… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I am looking for a suitable engine/drive package to repower
I am looking for a suitable engine/drive package to repower my boat: Model: 1988 Bayliner Ciera Sunbridge 2650 LOA: 26.5' Beam: 9 Ft. 6 in. (wide-beam) Draft: 3 Ft. 3 in. Weight: 6000 lb Current engin… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

23,082 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x