Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Kerry! Mercruiser ALPHA 1 had a nice shifting alpha 1 but
Kerry! Mercruiser ALPHA 1 had a nice shifting alpha 1 but noise was coming from between engine and lower unit. Removed out drive to replace gimble bearing,seal,drive shaft bellows, EX bellows,raw wate… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 1987 Mercruiser 5.7L (2BBL) Alpha One. I started
I have a 1987 Mercruiser 5.7L (2BBL) Alpha One. I started it up today to take it out and noticed that it is squirting water out the back of the engine at the center up above the flywheel housing and w… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
If I am replacing the shift cable bellows, (alpha 1, gen 2)
If I am replacing the shift cable bellows, (alpha 1, gen 2) do I need to unscrew the outer cable from the bell housing, or can the cable be pulled through the hull while it is still attached to the be… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hi, I am changing the u-joint bellows in my alpha one, gen
Hi, I am changing the u-joint bellows in my alpha one, gen 1 outdrive. I assume you need to remove the bell housing for this repair. Is this correct? If so, is there any way I can remove the bell hous… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i had to replace my outter bellows,i bought one used,dont know
i had to replace my outter bellows,i bought one used,dont know what year.i had the gimble bearing installed etc,i had new style motor mts.installed,than i installed new coupler and then engine with no… read more
James
James
Marine Mechanic
Vocational, Technical or Trade Scho
4,111 satisfied customers
Hello, I have a mercruiser 1987 Alpha one, Generation One
Hello, I have a mercruiser 1987 Alpha one, Generation One outdrive that leaks outdrive fluid and water into the bilge. In the summer of 2010 I noticed that the outdrive oil reservoir level would drop … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Mercury Mercury I own a 19 SeaRay boat with a 5 liter (225
I own a 19' SeaRay boat with a 5 liter (225 HP) Mercruiser Engine and an Alpha One Sterndrive. We discovered that the ~3" diameter bellows between the Sterndrive and the transom was disconnected at th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Is there supposed to be a seal on the flywheel at the spline
Is there supposed to be a seal on the flywheel at the spline fitting for the stern drive driveshaft for a Mercruiser 1986 Alpha One MR, and if so, what are the dimensions, part number etc?… read more
James
James
Marine Mechanic
Vocational, Technical or Trade Scho
4,111 satisfied customers
I have a 1991 Sea Ray 200ov with a 5.0L Alpha one, I have water
I have a 1991 Sea Ray 200ov with a 5.0L Alpha one, I have water comming into the back of the boat, can hear it dripping into bilge, almost a laping sound. The shift cable bellows has been replaced rec… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
hi john here, i have a 1986 170 224 alpha stern drive i need
hi john here, i have a 1986 170 224 alpha stern drive i need to replace the engine coupler what is the easyest way to do this.… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
1996 Sea Ray with 5.7L Mercruiser Alpha 1 with a leak around
1996 Sea Ray with 5.7L Mercruiser Alpha 1 with a leak around the shift cable area. Have replaced all of the boots and ensured clamps are tight. What else can I check? A friend told me it may be one of… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have an 1989 17 vip boat. It has a 2.3l engine with an omc
I have an 1989 17' vip boat. It has a 2.3l engine with an omc outdrive. I know there is a conversion to make it a mercrcruiser outdrive. What I need to know is which particular outdrive and conversion… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Hi have you any tips on how to fit an exhaust bellows to a
Hi have you any tips on how to fit an exhaust bellows to a mercruiser 1996 .I have struggled for 3 hours only to punch a hole in the new bellows trying. many thanks Phil… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
1996 Mercruiser Alpha one outdrive. Needs Shift Cable Bellow
1996 Mercruiser Alpha one outdrive. Needs Shift Cable Bellow replaced. How hard/ how long should I expect a mechanic to take to do this. It has a temporary fix on it right now of silicone and wire tie… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I had a problem with my mercruiser alpha 1 sterndrive which
I had a problem with my mercruiser alpha 1 sterndrive which Larry B correctly diagnosed as the shift cable siezing up. I have now serviced the leg and replaced the cable. The manual was not very clear… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
The shift cable bellows on my 89 Mercruiser Alpha One 3.7
The shift cable bellows on my '89 Mercruiser Alpha One 3.7 Liter has a small tear in it that has led to a slow leak into the bilge. Is it possible to repair the tear in place with duct tape, glue, etc… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have an alpha One that the shift cable boot needs replacing.
I have an alpha One that the shift cable boot needs replacing. I've removed the outdrive, but cannot determine what to do to remove the cable. Please advise!… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have an 1981 898 mercruiser. The wiring to the trim indicater
I have an 1981 898 mercruiser. The wiring to the trim indicater on the gimble ring is broke. Need to run new wire from pump. How do you fish the wire through ?… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x