Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I changed the steering helm and the wheel. Also cleaned the
I changed the steering helm and the wheel. Also cleaned the cable at the back end where it connects to the motor.Its still ready hard to turn the wheel tho. is there a grease point on this motor to he… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I bought a boat with a 2000 Johnson plssm motor. It has two
I bought a boat with a 2000 Johnson plssm motor. It has two fuel type lines going into the motor. One is gas and the other comes from a OMC oil reservoir. What is the oil line for? Is it a four stroke… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 29 foot boat with twin 150 hp Johnson outboards(about
I have a 29 foot boat with twin 150 hp Johnson outboards(about 2003). The steering is done with a wheel-activated hydraulic system. It has become very hard to steer, so I disconnected the steering cab… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
The steering pivot point on the engine leg is stiff and have
The steering pivot point on the engine leg is stiff and have tried heating and grease have also put a jack under the leg to try to get the grease to go up not out the bottom but it is still stiff. The… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Im ready to launch my boat and want to make sure all is OK. Im
I'm ready to launch my boat and want to make sure all is OK. I'm putting grease in all the fittings around the transom there is one fitting on top of the bell housing behind the motor. question is : W… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have a 1996 Bayliner Cierra 2858 flybridge. It has a 7.4L
I have a 1996 Bayliner Cierra 2858 flybridge. It has a 7.4L mercruiser with a Bravo 2. The problem is stiff steering to starboard. I removed the pins and checked the cabin helm and flybridge helm both… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I HAVE A 1987 GRADY WHITE TOURNNAMENT BOAT WITH A 1999 HONDA
I HAVE A 1987 GRADY WHITE TOURNNAMENT BOAT WITH A 1999 HONDA FOUR STROKE MOTOR. I HAVE OWNED THE BOAT SEVERAL YEARS. THE STEERING WHEEL IS VERY STIFF AND SOMETIMES EVEN SLIPS WHEN TURNING THE WHEEL HA… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1994 Mercury 150 Black Max that turns very hard.
I have a 1994 Mercury 150 Black Max that turns very hard. The boat was in Florida for most of its life. It is now in fresh water only. I have replaced steering cables and have narrowed the problem dow… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
My steering is very stiff. Should I look at the power steering
My steering is very stiff. Should I look at the power steering pump or somewhere else as the source of the problem… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1994 115 hp mercury outboard. Very stiff steering.
I have a 1994 115 hp mercury outboard. Very stiff steering. It's not the cable since it moves freely when disconencted from the motor. The steering shaft of the motor is well greased but still is stif… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1998 searay 210 with mercruiser motor. At the end
I have a 1998 searay 210 with mercruiser motor. At the end of last year I noticed the steering getting very stiff. I checked the fluid levels and they were ok. Also no "whining" noises. This spring I … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Grease points for volvo sterndrive! I have a Fairline Viven
Grease points for volvo sterndrive! I have a Fairline Viven with volvo AQ120 engine and (I thought) 270 sterndrive. But Operators Manual shows slight differences on sterndrive to the one I have. I bel… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
honda aquatrax rope stuck in the intake.......not coiled around
honda aquatrax rope stuck in the intake.......not coiled around the shaft but sucked up in the hole in the front of the ski. how do i fix. take grate off and turn shaft/impeller in reverse to free it?… read more
TIMOTO
TIMOTO
Bachelor's Degree
163 satisfied customers
my force 150 pivot pin lower bushing is very tight . I need
my force 150 pivot pin lower bushing is very tight . I need 2 hands to steer. Ques. how should I free up the lower pivot bushing ?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
my outboard is difficult to turn to the right or left. I have
my outboard is difficult to turn to the right or left. I have mechanical steering which works fine, but the vertical column on the actual outboard is rusted or lacks grease. What can I do to make it m… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
i have a 2007 vip baystealth with a 90hp honda and the steering
i have a 2007 vip baystealth with a 90hp honda and the steering has gotten real stiff. any suggestions on what to do? it has rack and pinion steering.i have taken the cable loose and the motor turns g… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
I have a 1994 Nitro 180FS bass boat, I just bought it. The
I have a 1994 Nitro 180FS bass boat, I just bought it. The steering is very stiff, especially to the left. Do you know what type of steering mechanism it has? also what maintainance can I do to make i… read more
TOM
TOM
Vocational, Technical or Trade Scho
196 satisfied customers
The tiller tube on my Evinrude 60 VRO is seized and the steering
The tiller tube on my Evinrude 60 VRO is seized and the steering bar will not move. I was able to disconnect the steering flex on the other side and can withdraw the bar also. On the opposite end is t… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x