Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
My boat is stalling when shifting out of and back into
Good morning, my boat is stalling when shifting out of and back into neutral. This is happening intermittently. Mechanic insists it's not interrupter switch or shift cable, boat does "click" when shif… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
570 satisfied customers
I have an '81 Evinrude E15RCIS. It hadn't run years
I have an '81 Evinrude E15RCIS. It hadn't run for 10 years prior to me starting it recently. Seems to run out of gas. I have disassembled the carb and fuel pump. Cleaned them out. Replaced the fuel pu… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1998 Evinrude 15 HP 2 stroke outboard. At low speeds,
I have a 1998 Evinrude 15 HP 2 stroke outboard. At low speeds, the engine seems to miss and nearly die out. (Meaning: sounds like one cylinder did not fire, engine slows and nearly stops). There's no … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have an older model 25hp Johnson sea horse. It has electric
I have an older model 25hp Johnson sea horse. It has electric start and is a non-through hub exhaust model. We had the carb cleaned and a new kit installed in it. The engine has good compression and g… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I just bought a used sailboat with a 6hp evinrude outboard.
I just bought a used sailboat with a 6hp evinrude outboard. Today while tryng to start it the motor cut off after running a short time and we were unable to pull the rope to turn over the motor. It fe… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
For James lll Got a 1995ish 25hp Evinrude on a 15 foot Ghanoe
For James lll Got a 1995ish 25hp Evinrude on a 15 foot Ghanoe carbureted. I always run the gas out of the carb before I put it up, as I don't use that much. I had it out last month, ran fine. I did no… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
My 1985 25 hp Evinrude ran like a top last summer. I got a
My 1985 25 hp Evinrude ran like a top last summer. I got a fresh tank of gas today, turned the key and it started right up. It ran for about 1.5 minutes and shut down. Took the cover off, opened the p… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
new motor 4.3 v-6 starts runs for few minutes,stops restarts
new motor 4.3 v-6 starts runs for few minutes,stops restarts ok runs again for minutes. changed carb-new, changed fuel pump-new ,new filters and fuel line, after draining 40 gallons-put in 10 started … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,849 satisfied customers
Hi I have a 1994 25 hp evinrude TEERC outboard motor it hasnt
Hi I have a 1994 25 hp evinrude TEERC outboard motor it hasn't run in last 5 years. I have taken it out to the lake and put fresh gas/oil into it and it fired up and idles nice but when I try to open … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have 9.9 fourstroke big foot. Ran fine last week. Put on
I have 9.9 fourstroke big foot. Ran fine last week. Put on lake today, very hard to start. when throttle up engine dies and won't retart for about 5 minutes. What next?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1976 Evinrude, 70 hp, starts, idles, give it the gas, comes
1976 Evinrude, 70 hp, starts, idles, give it the gas, comes out of the hole, runs....slow down no wake zone whatever, give it the gas, it bogs... will die if you continue to gas but if you tilt the mo… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I have A 1987 Evinrude 90 hp 4 cyl. 2 stroke. I cant seem to
I have A 1987 Evinrude 90 hp 4 cyl. 2 stroke. I cant seem to keep it running at a good throttle. It will idle all day long, I thought it was a gas problem at first so I changed the water seperator fil… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1971 Evinrude Mate. It finally quit me. I cannot
I have a 1971 Evinrude Mate. It finally quit me. I cannot get gas from the carburetor. This is the one year rope pull model.… read more
tom
tom
outboard mechanic
High School or GED
117 satisfied customers
I just purchased a 1976 Glastron with volvo penta 280. First
I just purchased a 1976 Glastron with volvo penta 280. First trip today, started fine and idled well until I tried to put into neutral to then go into gear. Everytime the motor would stall. Did get go… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
We have a 1998, oil-injected, 25 horsepower Evinrude motor.
We have a 1998, oil-injected, 25 horsepower Evinrude motor. It starts up right away, runs fine full out, and then just stops after a bit (about 300 feet). this continues and then eventually just bogs … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1978 Evinrude 85 HP Motor that is leaking and spewing
I have a 1978 Evinrude 85 HP Motor that is leaking and spewing gas at the filter when I go to prime it. I didn't find that out until after I had been on the water today, and it would cut on then cut o… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Boat runs fine for 5 to 10 minutes. Then it stalls and wont
Boat runs fine for 5 to 10 minutes. Then it stalls and won't restart. If I wait about 20 minutes it will start and run for less than a minute and stop. Has brand new battery. I put on a new coil. Has … read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I have an Evinrude Triumph 55 HP motor, I believe 1969. Its
I have an Evinrude Triumph 55 HP motor, I believe 1969. It's been running great with exception of shifting issues. However, this past weekend, I took it out and when I pushed the throttle forward it d… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,849 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x