Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I'm purchasing a Hydro sport Vector 2400 center consul with
I'm purchasing a Hydro sport Vector 2400 center consul with an early 250 E tec on it. The performance is dismal with a 14 and three-quarter by 17 three blade prop. It also came with a four bladed 14 a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I HAVE A 1995 JOHNSON 60 DEGREE 150.I WAS RUNNING BOAT TO ADJUST
I HAVE A 1995 JOHNSON 60 DEGREE 150.I WAS RUNNING BOAT TO ADJUST THE JACK PLATE AND MADE THREE RUNS ABOUT 3/4 MILE EACH WAY NO PROBLEM.PUT BOAT ON THE TRAILER AND MADE ADJUSTMENT LAUNCHED BOAT AND RAN… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2000 Johnson 200 that is giving me trouble. It "acts"
I have a 2000 Johnson 200 that is giving me trouble. It "acts" like it drops a cylinder or something. I've had the carbs cleaned, new plugs and even tried a new power pak. It is very sporadic at when … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
2002 mercury 125hp 2+2 gets up on plane, then starts surging,
2002 mercury 125hp 2+2 gets up on plane, then starts surging, like starving for fuel. This lasts about 5 minutes, then runs well after it warms up.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 2003 Johnson 90 hp 4 Stroke Bombardier electronic
I have a 2003 Johnson 90 hp 4 Stroke Bombardier electronic fuel injection engine. I purchased toe pontoon and motor in march. We have used the pontoon and have had the boat loaded with six (6) adults.… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a Mercruiser 7.4 EFI 350hp on a 30 Sea Ray Sundancer.
I have a Mercruiser 7.4 EFI 350hp on a 30' Sea Ray Sundancer. When running at 4800 RPM, after 30 minutes of cruising, the RPM dropped 400 rpm for about 3 minutes and then went back to 4800. It would r… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have two Volvo Penta KAMD 44 marine engines in my 2001 Princess
I have two Volvo Penta KAMD 44 marine engines in my 2001 Princess 38. Thse engines seem to be little too small for the boat. The fuel consumption is quite high. What is the optimal rpm for normal trav… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 17.5 Lund Tyee (rated to 140 hp) and I fish Lake
I have a 17.5' Lund Tyee (rated to 140 hp) and I fish Lake of the Woods in northern MN & Canada with 4 adults in the boat. Mercury makes 115, 125 & 135 hp Optimax motors. Other than the small differen… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
We have a johnson 50 hp model j50pleea srial # XXXXX
We have a johnson 50 hp model j50pleea srial # XXXXX 02/1999......runs 3000 rpms no problem but 4-5-6000 rpms the motor drops bac to 3000 rpms like not getting enough gas.....mechanic says needs new f… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 70 HP 2 cycle Envinrude that will get the boat up
I have a 70 HP 2 cycle Envinrude that will get the boat up on plane and cruise for about 10-15 minutes, then the RPMS drop and it dies. It will start, run rough at idle, and when in gear will not go a… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
HI, have a 1999 johnson 60hp motor. starts fine, runs fine
HI, have a 1999 johnson 60hp motor. starts fine, runs fine full throttle until i slow down, then it won't go above 2400 rpms, tilt motor up out of water, rpms jump to 4800, tilt back down into water, … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
hello i own a 25.5 sea ray amberjack 10 ft. beam 152 gal. gas
hello i own a 25.5 sea ray amberjack 10 ft. beam 152 gal. gas tank fresh water tank this has a 350 mercruiser engine 260 hp. it does get on plane fairly quick about 5-6 sec. but seems sluggish on top … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Problem with a 1999 Johnson 175 HP. This motor starts good
Problem with a 1999 Johnson 175 HP. This motor starts good when it is cold and throttles-up and get on plane good after warming up a minute or two. It also runs great after sitting for up to 30 minute… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 20 ft. searay cuddy cabin with a 4.3 liter v6 alpha
I have a 20 ft. searay cuddy cabin with a 4.3liter v6 , alpha one outdrive . I want to purchase a s.s. prop, what is the ideal size and pitch for all around performance? Is a four blade better than a … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2007 15 hp, 4 stroke - cranks first pull, idles great,
I have a 2007 15 hp, 4 stroke - cranks first pull, idles great, runs at top speed great, when i dethrottle off of a plane the engine sputters then cuts off, imediatley after the engine cranks first pu… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
My 1983 Johnson 200 HP 2 stroke outboard misses until the RPM
My 1983 Johnson 200 HP 2 stroke outboard misses until the RPM gets to 3,800 then it suddenly runs on all six cylinders. But slow dow to 3,800 or less RPM's and it starts to miss again. I think its mis… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a Johnson 97 200 HP outboard that runs fine at 3000
I have a Johnson 97 200 HP outboard that runs fine at 3000 rpm, but cuts out on me at idle. I have re-built all of the carbs... changed all filters, and i replaced the fuel pump last year. I was havin… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
What would cause a surge of about 300 rpm that cycles up then
What would cause a surge of about 300 rpm that cycles up then back above 3000 rpm ? 1999 Merc optimax 200 hp… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x