Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Re 1988 Bayliner 24.5 w/5.0 cobra engine & outdrive.
re 1988 Bayliner 24.5 w/5.0 cobra engine & outdrive. Shifting is impossible when in water under load. Distributor is a Bosch single wire with points. Engine will not slow down when shifted. Repair man… read more
Boat Doc
Boat Doc
253 satisfied customers
I have a 1986 Searay 18 foot with a 4.3 liter GM v6 engine
Hi I have a 1986 Searay 18 foot with a 4.3 liter GM v6 engine and an OMC Cobra outdrive. Bought 10 or 12 years ago used. It was a little hard to shift forward to neutral to reverse. The last couple ye… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Omc cobra 2: i have a 24 foot bayliner trophy boat ..it has
i have a 24 foot bayliner trophy boat ..it has a gm goodwrench 350 in it for engine and my outdrive is a omc cobra,, I have a problem with it shifting in and out of forward ,reverse ,neutral... after … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have been virtually given a Bayliner boat. I am planning
I have been virtually given a Bayliner boat. I am planning a renovation and I need information as to what I am dealing with. The Hull number is ***** I believe it is 25.5 ft. long, has a radar dome, f… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I am looking for infomation on the proper pitch of the prop
I am looking for infomation on the proper pitch of the prop for my boat for use in salt water. My boat is a 1989 Bayliner Trophy 23 ft. with a 5.0 engine (gm) with a omc cobra stern drive. The currant… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1989 Bayliner 2650 Sunbridge which had an OMC Sterndrive.
I have a 1989 Bayliner 2650 Sunbridge which had an OMC Sterndrive. Last year the leg blew-up, and the best solution was to replace it with a SEI16 Sterndrive requiring an adapter. I barely got the "br… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
OMC 1989 King Cobra 460, Bayliner 2855 Sunbridge Problem:
OMC 1989 King Cobra 460, Bayliner 2855 Sunbridge Problem: Cooling Not getting water to the motor from outdrive pump. I have changed impeller and gaskets which seamed to be ok, flushed and back flushed… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a Bayliner Ciera 2556 5.7l V8 petrol. I am having a
I have a Bayliner Ciera 2556 5.7l V8 petrol. I am having a problem with changing from gear and engine cuts out changing from forward to reverse through neutral. Gear change is very stiff. Although we … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have an OMC Cobra 3.0 liter engine with a 3.0 Cobra
I have an OMC Cobra 3.0 liter engine with a 3.0 Cobra outdrive. The problem I am having is that when I shift it to forward I hear a grinding noise. To test it, I left it on forward then went and light… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 1986 OMC Cobra 4.3l engine on my house boat. Can
I have a 1986 OMC Cobra 4.3l engine on my house boat. Can you please tell me how the ignition system works. My distributor is a prestolite and there is a module on the rear of the engine connected to … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,526 satisfied customers
I just purchased a Bravo 3 complete outdrive serial # XXXXX
I just purchased a Bravo 3 complete outdrive serial # XXXXX with 220R gears. It is a 1994 model. I am hooking this up to a 1992 OMC 454, King Cobra engine that has been rebuilt, and now has 395hp and … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,526 satisfied customers
I have a 1987 bayliner with a 5.7 litre. I have not had it
I have a 1987 bayliner with a 5.7 litre. I have not had it in the water for 2 years now but it was winterized and stored inside. It has a cobra out dirve and it has 2 levers one for throttle and one f… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I have a 1985 bayliner w/omc 350 that misses out of hole &
I have a 1985 bayliner w/omc 350 that misses out of hole & above 2800 rpm. the boat has after market electronic ignition. I have replaced esa module, fuel filter,cap & wires. The ignition module came … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
1986 seaswirl 4.3L chevy v6 cobra omc sterndrive, stalling
1986 seaswirl 4.3L chevy v6 cobra omc sterndrive, stalling issue after 10-15 min 3500 rpm.Will restart.Replaced points,condensor, ignition rotor, ign. coil, esa module,rebuilt carb,fuel pump.Engine wi… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
Hi ... i would repower my bayliner 2755 (1989),actually OMC
Hi ... i would repower my bayliner 2755 (1989),actually OMC cobra 5.8,351 ci,carbs, with OMC drive... what upgrade do you recommend, if i keep my existing drive ? MPI ?… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
It seems the batteries on the boat I just bought are not charging
It seems the batteries on the boat I just bought are not charging when running. I am going to put a battery charger on them in the morning to recharge. What should I look for to determine if alternato… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
Wont idle for over 15 minutes, 1990, 4 WINNS w OMC Cobra 5.8L.
Won't idle for over 15 minutes, 1990, 4 WINNS w OMC Cobra 5.8L. Just had electronic ignition conversion w new coil, plugs and tuning. Now it runs rough and conks out after 15 minutes of no wake runnin… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have had a repair man working on my OMC Cobra ...
I have had a repair man working on my OMC Cobra engine. We have replaced the ignition module, distrubutor cap, and rotor. I have spark to the distributor, but am only getting spark to 2 cylinders on e… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,242 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,242 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,526 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x