Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I HAVE 89 MERCRUISER WITH BIG BLOCK, 3 YEARS AGO I CONVERTED
HELLO , I HAVE 89 MERCRUISER WITH BIG BLOCK, 3 YEARS AGO I CONVERTED IT TO ***** MANIFOLDS COOLANT RISERS FRESH WATER COOLED HAS BEEN COOLING PERFECTLY THE MANIFOLDS I HAD USED AT THE TIME WERE USED A… read more
CalebA820
CalebA820
Technician
Marine technology
22 satisfied customers
Have a 5.8ltr cobra omc fuel injected inboard motor in a
Have a 5.8ltr cobra omc fuel injected inboard motor in a 1995 Four winns vista cruiser. My problem is the engine starts immediately when cold but after running for awhile and shutting down for a half … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have a 5.7 mercrusier engine. When the engine is cold it
I have a 5.7 mercrusier engine. When the engine is cold it runs great. I could run the boat on the plane for about 1 hour. Temperature is running at 140 riser is at 150 and manifolds are at 175 degree… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
My boat starts right up and I run it around for awhile. Then
My boat starts right up and I run it around for awhile. Then we shut it down to go for a swim, lunch, or whatever. Then, it won't start up again. In the past I've taken it out of normal start setting … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I have a 2001 Searay w/ 4.3 L mercruiser stern drive
Hello. I have a 2001 Searay w/ 4.3 L mercruiser stern drive Alpha I w/ Thunderbolt V ignition system. Recently rebuilt motor due to improper winterizing, cracked block. I ordered short block marine en… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a crusader 350cdi 270 engine in my ChrisCraft 1982.
I have a crusader 350cdi 270 engine in my ChrisCraft 1982. My mechanic says the risers should have an operating temperature of less than 140 degrees. One side is at 135 to 140 and the other is closer … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
both my 15 horse mercury outboard and my 6hp evenrude outboard
both my 15 horse mercury outboard and my 6hp evenrude outboard started up easily after a long period of storage they both ran then stopped and won't start again. Any ideas?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1984 17 Four Winns bow rider with the 120 hp Mercrusier.
I have a 1984 17' Four Winns bow rider with the 120 hp Mercrusier. It is in beautiful shape and spent it's life stored in a garage when not used. When starting it, I noticed the temperature gauge not … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 3.0 140hp mercruiser in my 1985 four winns. We have
I have a 3.0 140hp mercruiser in my 1985 four winns. We have taken it in to multiple mechanics they said the compression was good in all the cylinders. The points, plugs, wires, fuel pump, alternator,… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Please I just bought a Herters 1959 St. Lawrence which came
Please I just bought a Herters 1959 St. Lawrence which came with a Evinrude GJ 18HP Fastwin Motor It has the what I believe to be a pressurized Fuel sending unit which I believe may have benn outlawed… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
-I have a 94 four winns fling with an omc turbo jet 115 engine....... -it
-I have a 94 four winns fling with an omc turbo jet 115 engine....... -it stahls at low speeds below half throttle and idle, (runs great at full throttle)...... -at idle it coughs, (and makes a mechan… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1995 5.8 liter ford engine in a Four Winns boat.
I have a 1995 5.8 liter ford engine in a Four Winns boat. It starts good initially and runs great. Use to run at 42 mph, now only 32mph. after operating up to temp of 160 degrees, it is hard to start … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1986 Four Winns Horizon 190 with a Mercrusier 140
I have a 1986 Four Winns Horizon 190 with a Mercrusier 140 hp and alpha I outdrive. The engine has a Rochester(actually Mercarb) 2GC carburetor. The engine idles well, has good power, and generally ru… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
Each year when starting my 25 horsepower 4 stroke electric
Each year when starting my 25 horsepower 4 stroke electric motor for the first time after setting for 8 months I have a problem getting it to run. it will only start with starting fluid and runs a sho… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
I have a 1999 Volvo Penta SX sterndrive 5.0L carburated engine
I have a 1999 Volvo Penta SX sterndrive 5.0L carburated engine on a Four Winns Horizon. After starting and idling properly for about 2 minutes, it briefly hits this period where it wants to stall and … read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have a 33 horse Johnson that starts and runs great but will
I have a 33 horse Johnson that starts and runs great but will not let me slow troll without sputtering and stalling. New points, rebuilt carb, new plugs, new gas . Any ideas?… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I converted my 1985 MerCruiser 140 HP 4 cyl from points to
I converted my 1985 MerCruiser 140 HP 4 cyl from points to electronic ignition (Mallory). It runs great for 45 minutes and then quits. I let it set for 20 minutes and it starts right up and runs for a… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
Is there any way I can get more power out of this boat once
Is there any way I can get more power out of this boat once I get it running. It only weighs 1,100 lbs. and the fastest it has ever registered is 35 mph via GPS receiver… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x