Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Yamaha c40 outboard that has been sitting for a while. Has
Yamaha c40 outboard that has been sitting for a while. Has fresh fuel, just replaced the fuel line & primer bulb. Pulled the carbs apart to look at them and they are clean-all jets are clear, no gum o… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
551 satisfied customers
I have a 1994 50hp motor, I changed the fuel pump, and
I have a 1994 Johnson 50hp motor, I changed the fuel pump, and cannot get enough fuel to the motor, I think it is my carburetor adjustment… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 25 Hp Yamaha Outboard long shaft. Last year, I had
I have a 25 Hp Yamaha Outboard long shaft. Last year, I had carb rebuilt, changed plugs and fuel filter. The engine cranks and idles fine. When I give it gas, it will start to rev up then die. I thoug… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I HAVE A 1997 225HP. EVINRUDE MOTOR. I HAVE A PROBLEM WITH WITH THE STOCK VRO PUMP I FOUND
I HAVE A 1997 225HP. EVINRUDE MOTOR. I HAVE A PROBLEM WITH WITH THE STOCK VRO PUMP I FOUND THAT I HAD LOW COMPRESSION IN ONE CYLINDER I INSTALLED NEW RINGS ALL OF THE CYLINDERS. I REPLACED THE LOWER C… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I just bought a 2000 johnson 90 and have had the typical carb
I just bought a 2000 johnson 90 and have had the typical carb problems and have rebuilt them. now the motor seemd to not be receiving fuel. primer bulb pumps hard. the motor has run but now will not h… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
Hi I am having trouble with. My 2005 175hp Johnson outboard
Hi I am having trouble with. My 2005 175hp Johnson outboard motor. (Carbed) It starts good and runs great for about 10 min it then starts to die down and will stall if kept at higher rpm. My primer ba… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 50 hp TL & TX Evinrude of approximately 1994s vintage.
I have a 50 hp TL & TX Evinrude of approximately 1994's vintage. When taking it out of storage, it is hard to keep running with water muffs on it. I have to prime it just to keep it running. I used a … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
no fuel going through carb. Only when using primer on bowl
no fuel going through carb. Only when using primer on bowl will it start. Then it will soon die once it uses that fuel. Otherwise it won't start.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I bought a new 9hp motor this year and Ive only been able
I bought a new 9hp motor this year and I've only been able to use it two or three times because I can't get gas to the carburetor. The pump on the gas can gets hard immediately. I've had someone look … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a new 9.9hp Mercury 4 stroke motor. It starts fine
I have a new 9.9hp Mercury 4 stroke motor. It starts fine but keeps stalling after about 1 minute of run time. Fuel flow does not appear to be working properly. I have gone through 3 new fuel tanks an… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have an 88 115 hp 2 stroke outboard,great shape and ran well
I have an 88 115 hp 2 stroke outboard,great shape and ran well until it suddenly started dieing out at full throttle it did this 4 or 5 times after about 3-5 minutes of running(after squeezing bulb ea… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 97 175 Evinrude Intruder, Carb motor that starts up
I have a 97 175 Evinrude Intruder, Carb motor that starts up fairly well and runs pretty good some times. However, after the initial run in the morning I can start the motor to move to another locatio… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Have a 1964 5.5HP Johnson (Model CD-CDL-21) It starts, but
Have a 1964 5.5HP Johnson (Model CD-CDL-21) It starts, but will not continue to run. Possible reasons?… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 9.9 evinrude outboard motor. It quit running while
I have a 9.9 evinrude outboard motor. It quit running while on the water today. I could start it but it would not keep running.… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
force 15 hp, motor runs and starts easy, after running half
force 15 hp, motor runs and starts easy, after running half or full throttel starts to loose power or stall, check fuel hose for leaks, gas tank filter, pump bulb, all working-not restricting flue flo… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 40hp Johson out board 2stroke 1993 The motor runs
I have a 40hp Johson out board 2stroke 1993 The motor runs good but when you put it to more than 1/4 speed she starts to bog down like she wants to die. Help!… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2000 mercury 25hp that I have just rebuilt the carb,
I have a 2000 mercury 25hp that I have just rebuilt the carb, fuel pump and water pump. Motor will start up and run for short period of time and then stops. It will start back up and run if I squeeze … read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
2003/150 hp johnston bombadier starts and runs for a short
2003/150 hp johnston bombadier starts and runs for a short time then seems to run out of fuel but will start again then same thing again… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x