Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I've had an oil change and changed all the spark plugs I've
I've had an oil change and changed all the spark plugs I've changed both sleeves in the thrusters on my 2007 Yamaha ar230. Recently I had both Thruster lines replaced. I took the boat out I had two di… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have a 2019 seadoo spark 900 ho ace...long story short i
hello, i have a 2019 seadoo spark 900 ho ace...long story short i sucked up a rock and ruined the wear ring. the impeller was pretty knicked up so i filed it the best i could and put everything back t… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have lots of power and will fire rev to 7500 rpm but will
I have lots of power and will fire rev to 7500 rpm but will not actually take off. We have replaced prop and shaft and pto looks good. … read more
Blake P
Blake P
Certified RV & Marine Technician
132 satisfied customers
Carolina Classic 28: MY starboard Cummins 4BTA-3.9L engine
MY starboard Cummins 4BTA-3.9L engine takes almost a minute to accelerate on to the turbo. My port engine responds almost exactly with the lever. I reduced the pitch of the starboard propeller and it … read more
Jason
Jason
Marine Mechanic
22,973 satisfied customers
I have a 2005 Yamaha 60hp 4 stroke....when I put it in reverse
I have a 2005 Yamaha 60hp 4 stroke....when I put it in reverse it will go fine until I really give it some gas......once I give it a decent amount of throttle the engine will be wound up but the prop … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi there. Im trying to figure out why I cant get my starboard
Hi there. I'm trying to figure out why I can't get my starboard engine (my boat is powered by twin merc 4.3L EFI's) running up to 3000+ RPM's to get on plane-my boat is a Regal 2860 Express cruiser (a… read more
Jason
Jason
Marine Mechanic
22,973 satisfied customers
Hi, my seadoo challenger 180 se (2008, 215hp) will drive ok
Hi, my seadoo challenger 180 se (2008, 215hp) will drive ok until I try to go past 5500 rpm, it then just over revs to 8000 rpm and loses all power. When I back off the throttle it is fine again until… read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
i have a 1995 sugar sand jet boat witha 120 hp mecury. i was
i have a 1995 sugar sand jet boat witha 120 hp mecury. i was working last year i had a mechanic tune it up for and clean the carbs. now it seems to not have any power at full throttle it only wants to… read more
Jason
Jason
Marine Mechanic
22,973 satisfied customers
I have a 2007 Yamaha sx230 I bought in Mesa AZ. I live in Colorado
I have a 2007 Yamaha sx230 I bought in Mesa AZ. I live in Colorado at an elevation of about 5700'. I am only able to get 42 MPH with not much of a hole shot. My main problem is that I get 9k rpm out o… read more
Jason
Jason
Marine Mechanic
22,973 satisfied customers
Hello, I have a 2008 Yamaha AR210. I believe i have a cavitation
Hello, I have a 2008 Yamaha AR210. I believe i have a cavitation problem when my motor revs up above 4000 rpms on the port side. I replaced the impeller the intake grill was re-caulked, spark plugs re… read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
seadoo gtx rfi wear ring problem replaced pump housing,bearings,
seadoo gtx rfi wear ring problem replaced pump housing,bearings, thrust bearing ran for 1 hour good then started to slip again . took apart today impler would pull out of wear ring shaft has pulled th… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I have a 1996 or so seadoo boat and when I pu tit in the water
I have a 1996 or so seadoo boat and when I pu tit in the water it doesn't bite. The RPMs soar and no speed. Like the impeller is spinning in air. If I slowly give it gas it will eventually level off a… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
2001yamahaxlt1200. starts cavitating at 1100 rpms. will stop
2001yamahaxlt1200. starts cavitating at 1100 rpms. will stop at 1400 rpms. can use craft if I let it get just to cavitation and pull back throttle, it then seems to bite and in a second it grabs or sl… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
Hi, I have a seadoo 1999 Gti I rode it on a lake. While
Hi, I have a seadoo 1999 Gti I rode it on a lake. While riding it would loose speed sounding like it was skipping gear. i took out the plugs & they smell a little burnt what can i do.… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I took my sea doo out this weekend .. Motor ran fin up to 5000
I took my sea doo out this weekend .. Motor ran fin up to 5000 rpms 30mph no problem power ....but when I go to pinn the throttle to go faster ....I stopp going foward ( I am thrust foward because of … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,396 satisfied customers
I asked a previous question concerning my Seadoo boat, and
I asked a previous question concerning my Seadoo boat, and you answered with the possible cavitation. We replaced the jet pump seal, and the impeller, and still have the same result. The boat still on… read more
RSRBOB
RSRBOB
MC / Pwc Shop Owner
Vocational, Technical or Trade Scho
457 satisfied customers
I was trolling with my seadoo jet boat today when I heard a
I was trolling with my seadoo jet boat today when I heard a pop from the starboard side of the boat. I then tried to give the boat a little throttle and the starboard side of the boat vibrated loudly.… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the engine cavitates alot some times at 3500 rpm somtimes higher ,cruising at 3000 to 3500 for no reason at all the rpms start climbing. the eng… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,973 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x