Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1981 115 seahorse, when I start up the motor and go
I have a 1981 115 Johnson seahorse, when I start up the motor and go out it runs just fine, then when I go to restart it it will idle fine but then stall out when I go to give it gas, any ideas?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,553 satisfied customers
I have a 2000 150hp runs perfect 1st thing but if you run
I have a 2000 150hp Johnson runs perfect 1st thing but if you run say 1/2 hour then stop to swim or fish it will not throttle up on restart, primer bulb flat has to be continually pumped to keep it id… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Have 1998 mercury 115, and VRO alarm continues after
have 1998 mercury 115, and VRO alarm continues after starting the motor. does the alarm switch on the bottom of the oil reservoir only advise when the oil reservoir is empty and to refill, or does it … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,553 satisfied customers
I have a 2005 Johnson 150 hp outboard motor. When I first get
I have a 2005 Johnson 150 hp outboard motor. When I first get to the lake it runs perfect. When I fish for a while the motor starts right up but when I try to go the motor stalls. It will start again … read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 1996 Johnson 115 hp replaced power pack , VRO pump,
I have a 1996 Johnson 115 hp replaced power pack , VRO pump, anti siphon valve, all fuel lines , primer bulb , no leaks , carbs are good boat idles good spark plugs are burning clean gettin fire to al… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2004 115 hp mercury outboard on my pontoon boat.
I have a 2004 115 hp mercury outboard on my pontoon boat. The engine has low use, only used maybe twice a year. Was running at Lake Powell at near full throttle for about an hour, pulled into a canyon… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 17.5 Lund Tyee (rated to 140 hp) and I fish Lake
I have a 17.5' Lund Tyee (rated to 140 hp) and I fish Lake of the Woods in northern MN & Canada with 4 adults in the boat. Mercury makes 115, 125 & 135 hp Optimax motors. Other than the small differen… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Im having a problem with low idle and a primer pump bulb not
I'm having a problem with low idle and a primer pump bulb not staying firm on a Johnson 115 motor (1995). I just had the boat in for tune up/repairs and first time I took it out it started and ran fin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i have a 2000 cobalt with a 502 motor in it. It starts fine
i have a 2000 cobalt with a 502 motor in it. It starts fine an runs fine. Drive it across the lake then turn it off. Hang out then try to start it and no go, it only starts if you give it 3/4 gas. The… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,553 satisfied customers
Hello I just bought an early 90s 60 hp Johnson motor for a
Hello I just bought an early 90's 60 hp Johnson motor for a 16 ft skiff for saltwater fishing and some tubing and skiing. My problem is that on occasion when I give the motor full throttle it will gar… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
i got both engines running in the driveway fine. 2001 johnson
i got both engines running in the driveway fine. 2001 johnson 150 ocean pro's. i put the boat in the water and ran the engines at idle and the starboard engine seemed to idle about 100 rpm's lower tha… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Good Morning! Jeff from Lake worth Florida. XXX-XXX-XXXX I
Good Morning! Jeff from Lake worth Florida. XXX-XXX-XXXX I have a 2003-115 4 stroke. i was in the hospital over 97 days, so i guiss i would drain all the gas out tank and lines. i took the main gas li… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
My 2001 Johnson, 115 HP, oil-injected, motor does not run at
My 2001 Johnson, 115 HP, oil-injected, motor does not run at a constant speed at full throttle. It speeds up to full speed, runs for 1-2 minutes fine, then slows don't (throttle still at full position… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
I have 1996 Johnson 115 with only 140 hours on it. Just bought
I have 1996 Johnson 115 with only 140 hours on it. Just bought the boat, have run it about 4-5 hours and burned about 20 gallons of gas....starts, runs very nice except it seems very rich and runs a l… read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
555 satisfied customers
i have a 1997 evinrude 115 fast strike. it is a little hard
i have a 1997 evinrude 115 fast strike. it is a little hard to cold start but once it starts all is well. As soon as you apply throttle after warming up it will pane out my boat but has an entermitent… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 70 hp 4 stroke johnson outboard motor installed on
I have a 70 hp 4 stroke johnson outboard motor installed on a 16' Mchee craft cc that has a rating of 135 hp. My problem is that at full throttle it only turns 3000rpm and won't get enough speed to pl… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I have a 50 horse Johnson outboard and while running full speed
I have a 50 horse Johnson outboard and while running full speed down the lake and alarm started going off. The alarm was an intermitent alarm. I stopped the boat and shut down the engine and topped of… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
i have 1960 johnson...on the dials at top..slow speed it is ...
i have 1960 johnson...on the dials at top..slow speed it is on 2 by lean and the bottom which says high speed the dial is at 1 by lean..do these hae to do witht the speed of motor? how do i make it go… read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,553 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x