Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have just replaced both head gaskets on my 2007 F225
I have just replaced both head gaskets on my 2007 F225 Yamaha, I have followed the Manuel for re assembly and all timing marks line up including the gear marks on the Cam chain, However the starboard … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have twin 2004 115 4-strokes on a 2004 Glacier Bay Cat.
Hi, I have twin 2004 115 4-strokes on a 2004 Glacier Bay Cat. Starboard engine doesnt always drop idle speed down to 8-900 RPM either at stat-up or after running and idling back to the Maarina. Hangs … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
My starboard 225 HP yamaha outboard motor (4 stroke) is
My starboard 225 HP yamaha outboard motor (4 stroke) is running roughly. It barely runs at idle, and knocks about every 4-6 seconds. I also noticed that there are a lot of large air bubbles coming fro… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I'm looking at a 1998 Sea Ray 18 foot bow rider with a 75 horse
I'm looking at a 1998 Sea Ray 18 foot bow rider with a 75 horse power mercury. Seller (a marina) will put on a new Evinrude 75 HP) and increase the price $4,000. I am wondering if 75 HP is enough for … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling
2005 yamaha 225 4 strokes . 290 hrs . launched boat just idling out of channel starboard motor died . we go anchor starts back up when give it gas then dies again . changed both fuel filter water /fue… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 1986 Boston Whaler Outrage with twin outboard motors
I have a 1986 Boston Whaler Outrage with twin outboard motors on it. All of the gauges stopped working for the port side of the boat. The problem appears to be at the console. Any advice?… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2007 Yamaha sx230 I bought in Mesa AZ. I live in Colorado
I have a 2007 Yamaha sx230 I bought in Mesa AZ. I live in Colorado at an elevation of about 5700'. I am only able to get 42 MPH with not much of a hole shot. My main problem is that I get 9k rpm out o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I bought a new 16 foot Smokercraft proAngler boat with a used
I bought a new 16 foot Smokercraft proAngler boat with a used 1 year old mercury 4-stroke 60 hp. Bigfoot outboard. I was told at the time of purchase that I would love the extra torque this motor woul… read more
James
James
Marine Mechanic
Vocational, Technical or Trade Scho
4,111 satisfied customers
I am in the process of repowering my 1989 Mako 231 with a 4
I am in the process of repowering my 1989 Mako 231 with a 4 stroke outboard. This boat presently has the original Yamaha V6 200 HP motor. I have seen a lot of newer boats (sea Hunt etc) with comparabl… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 265Ex Edgewater boat with twin 225 4 stroke Yamahas
I have a 265Ex Edgewater boat with twin 225 4 stroke Yamahas (counter rotating). Since new the boat will list to port side when on plane esp when the ocean is anything but flat. The trim tab on port s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I recently purchesed a new 17 foot RIB with a 115 hp outboard.
I recently purchesed a new 17 foot RIB with a 115 hp outboard. Along with a few other problems including leakage between the tube and fiberglass body, I noticed a definite list to port while on plane.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i got both engines running in the driveway fine. 2001 johnson
i got both engines running in the driveway fine. 2001 johnson 150 ocean pro's. i put the boat in the water and ran the engines at idle and the starboard engine seemed to idle about 100 rpm's lower tha… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hi, I have just fitted two 115 4 stroke Mercs(2010) to a 7.2mtr
Hi, I have just fitted two 115 4 stroke Merc's(2010) to a 7.2mtr Fibre Glass boat. The boat originally was fitted with twin 100 yamaha four strokes. I spend most my time trolling at around 6 - 10 knot… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Am thinking about buying a used boat This is my first venture
Am thinking about buying a used boat This is my first venture into boating. Have identified 38foot cruiser as the type I would like. Have found one with two 80 HP engines and one with two 120 HP engin… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
I have a 2005 Yamaha AR230. The compression in both motors
I have a 2005 Yamaha AR230. The compression in both motors are the same but the Port motor when running the boat wide open is about 1000 rpms less than the Starboard motor. The throttle cable for the … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I am looking to purchase a near mint condition 22 foot aluminum
I am looking to purchase a near mint condition 22 foot aluminum boat with a hardtop. It looks great, but I have always been leery of Merc's since owning a couple of them back in the 1980's and 1990's.… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a Yamaha 50Hp 2-stroke 3 cylinder engine. When I run
I have a Yamaha 50Hp 2-stroke 3 cylinder engine. When I run the engine at the start of the day it runs fine. After a while it gets difficult to start and does not idle. It seems as though the carb is … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I am looking for about an 18 foot family boat, open bow, ...
I am looking for about an 18 foot family boat, open bow, that I would like to carry 3 adults and a couple small children and pull a skier at times. I don''t know if I want an inboard/outboard or an ou… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x