Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I've got an 87 searay w/omc 4.3 and it won't start
Hello, I've got an 87 searay w/omc 4.3 and it won't start w/starting fluid, it has spark but it looks weak, any suggestions where I should start? thanks… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Re 1988 Bayliner 24.5 w/5.0 cobra engine & outdrive.
re 1988 Bayliner 24.5 w/5.0 cobra engine & outdrive. Shifting is impossible when in water under load. Distributor is a Bosch single wire with points. Engine will not slow down when shifted. Repair man… read more
Boat Doc
Boat Doc
253 satisfied customers
My 4cylinder 2.3 liter ford boat motor runs good for a few
my 4cylinder 2.3 liter ford boat motor runs good for a few minutes then stalls and wont keep running when u put it in forward or reverse … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
1983 renken 2.5l Omc : No spark, boat has been sitting a
No spark, boat has been sitting a while, got boat from father in law who was having electrical issues as well. Replaced coil, not sure it is wired correctly … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Omc cobra 2: i have a 24 foot bayliner trophy boat ..it has
i have a 24 foot bayliner trophy boat ..it has a gm goodwrench 350 in it for engine and my outdrive is a omc cobra,, I have a problem with it shifting in and out of forward ,reverse ,neutral... after … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1993 omc 5L EFI it is intermittently stalling at rpms above
1993 omc 5L EFI it is intermittently stalling at rpms above about 2400 rpms. Runs good up to that point, but will always continue to hiccup are higher speeds under a load. Just replaced fuel filter, d… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hi, Ive got a Morrision Typ 22c from 1980 with an OMC Z-drive
Hi, I've got a Morrision Typ 22c from 1980 with an OMC Z-drive (240HP). The question I have is on the ESA. It seems not to work. The engine is equipped with an Delco HEI. Can you tell me about the ESA… read more
Charles
Charles
Certified Mercury Tech
5,745 satisfied customers
I have a 1993 chris craft 23 w/ the 5.8l omc; 2 years ago,
I have a 1993 chris craft 23' w/ the 5.8l omc; 2 years ago, it began running very rich - it was actually like dumping fuel. 3 mechanics said it was stuck injectors; 2,000.00 later, nope; Bought a used… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1989 Bayliner with an OMC Cobra 2.3 Ford. I have replaced
I have a 1989 Bayliner with an OMC Cobra 2.3 Ford. I have replaced all the electrical parts in the ignition, had the carb rebuilt and still do not have any power coming out of the hole and can't get t… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have an esa/ignition problem(s). I have an 87 Bayliner Cobra
I have an esa/ignition problem(s). I have an 87 Bayliner Cobra w/ 5.7L GM engine with OMC Cobra outdrive. With the points distributor I had the following problem(s): if idles for over 10 minutes the c… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1985 bayliner w/ a 800 stringer outdrive. recently
I have a 1985 bayliner w/ a 800 stringer outdrive. recently we were on kentucky lake when outdrive started clicking.We had boat removed from water and it was determand that upper unit was bad. We had … read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
I have an 1984 Tiara Slickcraft with a 5.7 liter omc V8 in
I have an 1984 Tiara Slickcraft with a 5.7 liter omc V8 in it. I currently am making some performance updates on it. I bought a Mallory Magnetic breakerless distributor and Plug wire kit. I have the n… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hello, I have a 1993 crownline with a 350 c.i. GM engine OMC
Hello, I have a 1993 crownline with a 350 c.i. GM engine OMC cobra outdrive. The problem is that I seem to be having problems with the ignition system in that at about 3000 rpm and up the engine start… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I just got a 1987 bayliner capri 18 cuddy. I am going to
I just got a 1987 bayliner capri 18' cuddy. I am going to have a stiff shift concern adressed soon. new shift cables and esa valve. I was wondering if you could reccommend a manufacturer and all parts… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a OMC 5.0 Cobra engine. It will crank up and run fine,
I have a OMC 5.0 Cobra engine. It will crank up and run fine, once it warms up it will start to bog down. While running if it starts to bog down I can hit the trim button and it will start to run corr… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
1988 4.3 OMC Ran great last week. Gassed up @ Sunoco (93)
1988 4.3 OMC Ran great last week. Gassed up @ Sunoco (93) on Friday evening and went out. After a couple of miles the engine began to spit and cough at irregular intervals sometime several minutes apa… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1992 boat with twin screws twin 1992 OMC 351 Fords.
I have a 1992 boat with twin screws twin 1992 OMC 351 Fords. Boat has twin OMC King Cobra outdrives. I have a problem with the starboard engine. When running the rpm's only climb to 2800 to 3000 wide … read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
1990 OMC Cobra, 351w ford 600cfm holley v/seconary, all stock
1990 OMC Cobra, 351w ford 600cfm holley v/seconary, all stock but coil MSD. Just replaced. Engine stalls at 2800-3000rpm. rebuilt carb. didn't help. tried a carb that works on another engine still the… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x