Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Can I bent propeller cause staring issues. Hits some rocks
Can I bent propeller cause staring issues. Hits some rocks yesterday and propeller got teared up. After that I had a hard time turning right. In low gear when I did it, hardly moving at all.… read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
Hi Jeff, I bought a used boat last summer with an 1985 90 hp
Hi Jeff, I bought a used boat last summer with an 1985 90 hp evinrude. I had it out a few times last year, had it winterized, took it out this spring and all was good. Took it out and trolled all day … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
Hello, I have a 2000 Mercury 115 2-stroke on an 18ft boat.
Hello, I have a 2000 Mercury 115 2-stroke on an 18ft boat. I recently drove over some rocks and damaged my propeller. The old propeller was 19 pitch and I was only reaching 4200 rpm with it, so when I… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a Mercury 2 stroke 40hp Model No. 1-041412FF and recently
I have a Mercury 2 stroke 40hp Model No. 1-041412FF and recently went out and stopped and started a few times then couldn't get to start to go home so had to be towed. Motor cranked over well but woul… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2012 90 hp motor with 37 hours on the motor, After
I have a 2012 90 hp motor with 37 hours on the motor, After a day of fishing I check my boat and motor during cleanup. I noticed a slight noise when I spun the prop in neutral at 10 hours. The noise h… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a Evinrude 150 Etec. I had a warning no oil warning
I have a Evinrude 150 Etec. I had a warning no oil warning light come on. I turned it off and then started it again. Same problem. After I loaded the boat back on the trailer and got back home. I noti… read more
Charles
Charles
Certified Mercury Tech
5,519 satisfied customers
I have a 08 225 e-tec ho it started running sluggish new spark
I have a 08 225 e-tec ho it started running sluggish new spark plugs and one fuel injector later no change its slow out of the hole and can't reach maximum rpms was put on the computer showed no fault… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 19890 70hp Evinrude outboard that has been running
I have a 19890 70hp Evinrude outboard that has been running well on my aluminum bass boat since I bought it used in 2000. Over the past several years, it hasn't gotten much use due to my schedule. One… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
1,074 satisfied customers
My 135hp evinrude start fine when launched at boat ramp got
My 135hp evinrude start fine when launched at boat ramp got to fishing spot and fish for a while then went to start it and there was nothing tried few times still nothing so took cover off and used th… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I purchased a 2008 60-mercury 4-stroke with 25 hours on a bass
I purchased a 2008 60-mercury 4-stroke with 25 hours on a bass tracker. Runs like a clock and turns up 5,900rpm's when trimmed out. I used it 2 or 3 times without a problem. The last 3 times I took it… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 2000 evinrude 90 hp ficht that l bought used, seemed
I have a 2000 evinrude 90 hp ficht that l bought used, seemed to run well when l bought it(just seen it run with muffs in the driveway).when I installed it on my boat I crossed the oil return and the … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hello If anyone can help with this, it would be greatly appreciated. My
Hello: If anyone can help with this, it would be greatly appreciated. My 2005 Evinrude 150 hp starts and runs great, until you travel more than 10 minutes at around 5 mph or under 10 km/h. Because, af… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1988 procraft bass boat with a Mariner 100 HP engine.
I have a 1988 procraft bass boat with a Mariner 100 HP engine. I just bought it and this was my first time on the river. The guy I bought it from took me out before I bought it and it ran great. I did… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
i have a 1995 evinrude 115 and the power head runs fine and
i have a 1995 evinrude 115 and the power head runs fine and today while riding across the lake it felt like it slipped out of gear or the prop come off i turned it off raised it out or the water every… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I recently purchased a starter boat which has a 25 horsepower
I recently purchased a starter boat which has a 25 horsepower evinrude 1986 outboard motor with pretty good compression. When we first took the boat out it started like a match no problems their, but … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
hello , i have a 16 foot john boat with a 30 hp yahmaha motor
hello , i have a 16 foot john boat with a 30 hp yahmaha motor ,was running fine when it last ran. but it has been sitting for years ,what are the chances it can be fired up and what prep should i do ?… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
Recently had some work done by local mechanic to replace a
Recently had some work done by local mechanic to replace a blown head gasket. First day out on the water...ran fine. Second day out, did a bit of fishing where I was idling a few minutes and the engin… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Thanks for the information provided eariler. I wanted to provide
Thanks for the information provided eariler. I wanted to provide some specifics. The E-tec is a 2005 90-HP. Currently I have 114 hours on the motor. The motor is mounted to my 17-foot Lund. Last Augus… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x