Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
If I am replacing the shift cable bellows, (alpha 1, gen 2)
If I am replacing the shift cable bellows, (alpha 1, gen 2) do I need to unscrew the outer cable from the bell housing, or can the cable be pulled through the hull while it is still attached to the be… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
Hi, I am changing the u-joint bellows in my alpha one, gen
Hi, I am changing the u-joint bellows in my alpha one, gen 1 outdrive. I assume you need to remove the bell housing for this repair. Is this correct? If so, is there any way I can remove the bell hous… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My Mercruiser exhaust bellow pulled off from the drive side.
My Mercruiser exhaust bellow pulled off from the drive side. Can I install an exhaust tube without taking the drive off? Is this a difficult job. I did the whole bellows job last season and it was pre… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1988 Chris Craft with a 350 mercruiser (chevy) engine.
I have a 1988 Chris Craft with a 350 mercruiser (chevy) engine. I just paid a bunch to have the engine rebuilt. After it was done, the mechanic called me and said when he tested it in the water it lea… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,862 satisfied customers
Jeff --I have a 2001 Bennington 2575 RLIO Tritoon with a 5.0
Jeff --I have a 2001 Bennington 2575 RLIO Tritoon with a 5.0 L MPI--Alpha 1 Gen II Stern drive. Replaced all the bellows and having a real problem getting the exhaust bellows to stay on the rear?? Kee… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
trying to remove seized mercruiser steering cable, power assisted, 350
trying to remove seized mercruiser steering cable, power assisted, 350 mag i/o. disconnected at helm, loosened large nut connection at powersteering unit, removed cotter pin and clevis pin at tip of s… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
92 bayliner 27.5 350 mercruiser dripping water into engine
92 bayliner 27.5 350 mercruiser dripping water into engine compartment around plastic water supply tube wher it comes through transom from stern drive water pump. . There is a two bolt retainer plate … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi, On my mercruiser Alpha 1, the cooling water does not
Hi, On my mercruiser Alpha 1, the cooling water does not come out the prop, rather it pours out between the bellhousing and leg. So I assume the exhaust bellows is broken. Is it imperative that it is … read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
Hello Mike, Read a post from you about 5.7 GXi where you asked
Hello Mike, Read a post from you about 5.7 GXi where you asked the configuration of the exhaust, i.e.: (lower) bellow conncted or not to the lower unit ! I have one of those GXI where the lower unit i… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Hi have you any tips on how to fit an exhaust bellows to a
Hi have you any tips on how to fit an exhaust bellows to a mercruiser 1996 .I have struggled for 3 hours only to punch a hole in the new bellows trying. many thanks Phil… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
What is the correct method apporved by Mercrusier on resealing
What is the correct method apporved by Mercrusier on resealing the raw water pump on a Alpha -one drive Gen 2.… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Is it possible to replace the exhaust bellows on a 1996 4.3
Is it possible to replace the exhaust bellows on a 1996 4.3 LX alpha one genXXXXXwithout having to remove the entire sterndrive?If so do you have any tricks regarding getting to the hose clamp closest… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a searay 240 sundancer with inboard outboard bravo 3.
I have a searay 240 sundancer with inboard outboard bravo 3. The exhaust bellow came off from the stern but it is still connected to the drive. Can I wait until the end of the season in three months t… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Replacing the exhaust bellows on my 1981 mercruiser 3.0L. How
Replacing the exhaust bellows on my 1981 mercruiser 3.0L. How do you use the special tool and what are the steps to acomplishing the task?… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Hello I just bought a 2003 Sea ray 320, with Mercruiser 350s,
Hello I just bought a 2003 Sea ray 320, with Mercruiser 350s, 150 hrs on the motors, compression test was done, came out excellent. I am reading a lot about the water ingestion problem through the exh… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
I found an old water shutter in my exhaust port. Where are
I found an old water shutter in my exhaust port. Where are the water shutters located on a 1982 Mercruiser 260 (350 CI pre-alpha), and how are they replaced? Do you have a parts diagram, and do I need… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
How do you replace the bellows on the out drive of a alpha
How do you replace the bellows on the out drive of a alpha one, 350 mac merc cruiser out drive… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have an 1981 898 mercruiser. The wiring to the trim indicater
I have an 1981 898 mercruiser. The wiring to the trim indicater on the gimble ring is broke. Need to run new wire from pump. How do you fish the wire through ?… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,862 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x