Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a question I have bought 2 x good second hand Two
I have a question I have bought 2 x good second hand Two Mercruiser Diesel 250 DTronic 250hp 4.2l 6 cylinder with Bravo 3 Stern legs. However the Transom Assemblies is not good on these there was a leak in the transom I currently have 2 x 260hp 5.0l V8 Mercruiser with Alpha 1 Legs … read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
3,038 satisfied customers
Has the Bravo III XR's been made any stronger recently. We
HI Jason, has the Bravo III XR's been made any stronger recently. We have gone through 2 x ZT350's and 2 x ZT370's behind a 6BY260 Yanmar diesel in 3 years. Seriously pissed about it. Desperately need… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,957 satisfied customers
I have a Bravo 2 drive, about year 2000 model : engine:
I have a Bravo 2 drive, about year 2000 model : engine: M341303 transom (outside) OM508880 leg OM131560 ratio: 2.20R Is there a "Linkage upgrade" for this drive that improves shifting? What is the mos… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,957 satisfied customers
Hi again sorry to drive u mad but I have finally found the
Hi again sorry to drive u mad but I have finally found the problem! Well most of it anyway lol after talking with several mechanics and hrs on the Internet forums ect I have been told that my problem … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi Jason Thank you for your previous advice. Following on
Hi Jason Thank you for your previous advice. Following on from our communications on December 28, 2012 - the boat was lifted from the water on January 8, 2013, the stern leg removed and the top gear b… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,957 satisfied customers
Further to my question back in December 2010 - still have the
Further to my question back in December 2010 - still have the same 33ft, 5 ton launch with a 1997 Mercruiser 7.3 D-tronic V8 diesel & bravo 2 stern leg. Had new bravoXXXXXupper gear box fitted in Dece… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,957 satisfied customers
Hi We have recently purchased a 2006 Sea Ray Sundancer with
Hi We have recently purchased a 2006 Sea Ray Sundancer with a 495 Mercruiser. Since picking up the boat we have found that if you have the leg fully down and cruise at a reasonably high speed, as soon… read more
Malta Tech
Malta Tech
Marine Tech
High School or GED
287 satisfied customers
I have a clunking sound when I put the gear into forward but
I have a clunking sound when I put the drive gears into forward but not reverse. it seems not to catch and when it does it is at a higher rev than preferred the leg is a Mercury Transom with a MerCrui… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,957 satisfied customers
I have a 1998 bayliner 2050 with a 5.7L mercruiser with an
I have a 1998 bayliner 2050 with a 5.7L mercruiser with an alpha one leg, I just got the bellows changed because I had a leak which I thought was coming from the bellows. I had ran the engine and ther… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1978 Donzi Hornet II, 454 cu. in, 460 HP mercruiser
I have a 1978 Donzi Hornet II, 454 cu. in, 460 HP mercruiser engine and sterndrive. Sterndrive badly damaged in May tornado on Grand Lake. Which sterndrive should I replace with and what is approximat… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,957 satisfied customers
I have a 1996 Maxum 32 SCR with 7.4 L mercruiser engines with
I have a 1996 Maxum 32 SCR with 7.4 L mercruiser engines with Bravo III drives. I have a water leak which looks to be at the very rear of engine on the bottom where the cast iron exhaust bellows meet … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a Campion 535 sport-boat with Mercruiser I/O. The interior
I have a Campion 535 sport-boat with Mercruiser I/O. The interior wood deck was starting to deteriorate, so I have removed it. Now have discovered engine mounting block is also totally disintegrated. … read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
Have Bravo lll Diesel and serial no 0M 804193. Do you know
Have Bravo lll Diesel and serial no: 0M 804193. Do you know model year ? and is there any diff. on the transom of ordinary Bravo lll and diesel x Bravo lll ??… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a Mercruiser Bravo II sterndrive powered by a Yanmar
I have a Mercruiser Bravo II sterndrive powered by a Yanmar 6LPSTZE 300 HP diesel engine with approx. 700 hours of use purchased in 1996. The shifting cable housing tore loose from the transom plate. … read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
Water leaking from outdrive 7.5 Bravo III. Looks like around
Water leaking from outdrive 7.5 Bravo III. Looks like around the mounting plate but what about boots and bellows. Water comes in at a steady rate. Just would like a little knowledge before I pull it o… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Good Day all, I am looking at buying a 28 foot leeder with
Good Day all, I am looking at buying a 28 foot leeder with twin 4.3 v6 motors with 700 hours on them.. one of the motors when started and revved pumps water out the back I thought it was the exhurst m… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 94 Regal 23 ft boat with a mercruiser 5.7 L carburated
I have a 94 Regal 23 ft boat with a mercruiser 5.7 L carburated engine with a bravo 3 outdrive. The impeller recently went out and it got hot so I pulled it back to 1/4 throttle and started to look at… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Why is my port mercruiser engine overheating The engine ...
Why is my port mercruiser engine overheating ? The engine overheats at 3500 RPM, but does not overheat at idle. Additionally the top of the elbow is hotter than normal. I have replaced the impellers, … read more
Ted G.
Ted G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,115 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

4,115 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,957 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

3,038 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x