Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a T9.9EXHP kicker on a 23 ft. Pursuit that moves the
I have a T9.9EXHP kicker on a 23 ft. Pursuit that moves the boat at 2mph at idle. I need to be at 1.0 to 1.5 for trolling. If I turn down the idle I'm afraid it'll damage the motor. Can I change props… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 2007 Crestliner 1750 fish hawk SC with 115 merc 4
I have a 2007 Crestliner 1750 fish hawk SC with 115 merc 4 stroke, and 8 HP kicker motor on the back. Trolling motor up front and 2 battery 24 volt system. starter battery in the back. 24 gallons of g… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I just bought a sea hunt edge 24 withf250xca. On test drive
I just bought a sea hunt edge 24 withf250xca. On test drive boat ran at 50mph 5900 rpm. I told dealer I wanted prop for speed and fuel efficiency Installed is Yamaha salt water 15 1/2 with 17 pitch I … read more
Charles
Charles
Certified Mercury Tech
5,522 satisfied customers
I have a 2006 Mercruiser 350 MPI with Bravo III drive and SS
I have a 2006 Mercruiser 350 MPI with Bravo III drive and SS Prop 20 degree pitch. The boat is a Cruisecraft 700 executive (planing hull and weight of Boat and Motor is 2800kgs). Had motor serviced 6 … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I am looking at purchasing a 2004, 28 Albemarle Express with
I am looking at purchasing a 2004, 28' Albemarle Express with tower, the boat is powered by twin inboard Mercruiser 350 mag MPI WC engines and I'm after some information on the fuel consumption. At bo… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 2002 30 hp. 4 stroke it has a 10.8x11p. prop is that
I have a 2002 30 hp. 4 stroke it has a 10.8x11p. prop is that the right prop. i also have a a 10.8x14p prop that a freind gave me that will fit can i use that or will it drop the rpm to low. the motor… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
83 CARVER MARINER. Bought boat 2 montha ago and was running
83 CARVER MARINER. Bought boat 2 montha ago and was running only max 17 knots so I had bottom cleaned and changed props from 16/15 to 16 /14 and got up to 24 knots . WOT WAS about 3100 each engine and… read more
Jeremy R.
Jeremy R.
MarineTechnician
9,020 satisfied customers
Yanmar 2GM20 Loss of Speed. Im hoping that you might be
Yanmar 2GM20 Loss of Speed. I'm hoping that you might be able to provide me with some advice. I have a 1999 Hunter 280 sailboat with a Yanmar 2GM20 (seawater cooling) engine. I bought the boat new and… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,406 satisfied customers
I have a 2007 Carver 45 Cockpit Motor Yacht about 37,000 lbs
I have a 2007 Carver 45 Cockpit Motor Yacht about 37,000 lbs with fuel. I have Volvo D6 370 HP inboard engines. I think it's under powered and is very sensitive to Barnacles, wind and currents. It sho… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,048 satisfied customers
We run a 2007 Mercury Verado 225 HP on a 6.8 m (22 foot) very
We run a 2007 Mercury Verado 225 HP on a 6.8 m (22 foot) very deep vee Plate Alloy Centre Console boat in tropical offshore waters (Barrier Reef, Australia). All up vessel weight about 2000 kgs (4400 … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 2008 model Suzuki 4 stroke 90hp outboard fitted to
I have a 2008 model Suzuki 4 stroke 90hp outboard fitted to a 5.25 center console alum. boat. The stainless steel prop fitted by the dealer is a 3 blade, 14 x 18 which although has good low speed grun… read more
Scott Martin
Scott Martin
Service manager
Vocational, Technical or Trade Scho
167 satisfied customers
i have a caribbean 2400 f/glass runabout net weight 1750 kg
i have a caribbean 2400 f/glass runabout net weight 1750 kg with 2008 225 etec 15.5 x 17 rebel propeller i can not get over 5000 rpm wot with 3 men on board and 300 ltres off fuel the engine is also v… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
What size props would a 1978, 33 foot bayliner cabin cruiser,
What size props would a 1978, 33 foot bayliner cabin cruiser, 11 1/2 foot wide have had? It originally had two, 220 horse power volvo gas engines. It was originally built at Bayliner Boat Corporation.… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Ihave a 24 ft Robalo center console with twin 4 stroke Yamahas.It
Ihave a 24 ft Robalo center console with twin 4 stroke Yamahas.It has 13-3/4 17 stainless props. The boat slips or cavitates when trolling at 8 -10 knots. I tried 14-1/2 17 aluminum props and the boat… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a bayliner 2556 motor cruiser, with a mercruiser D3-6Ldiesel
I have a bayliner 2556 motor cruiser, with a mercruiser D3-6Ldiesel engine with a bravo 2 leg. I can only achieve about 15 knots and a maximum of 3400RPM. Propleller and bottom have all been checked. … read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
i have74 26 trojan express cruiser,i have a 318 chrysler merc
i have74 26' trojan express cruiser,i have a 318 chrysler merc cruiser inboard won't go over 9 knots shaft is one inch, the nut is 3/4 by 10 thread what is proper pitch to get proper cruise speeds… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 17 Malibu (2000) with a 4.3L Mercruiser , What is
I have a 17' Malibu (2000) with a 4.3L Mercruiser , What is my solution's for propping for the best performance for cruising and running around ?… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a H56TS Xpress boat with a 150hp V-Max 2 stroke...No
I have a H56TS Xpress boat with a 150hp V-Max 2 stroke...No jackplate...original prop now broken was SS 14 1/2x23...been searching for another prop but getting to much feed back...my question is whats… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x