Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1995 bayliner capri 2050 with the 5.0 liter engine
I have a 1995 bayliner capri 2050 with the 5.0 liter engine and alpha 1 gen 2 outdrive that is slipping at high rpms. checked the prop and it is not there. I have taken the stern drive apart and all s… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 2000 sea ray sundancer 7.4 bravo 3. Complete
I have a 2000 sea ray sundancer 7.4 bravo 3. Complete outdrive was replaced with brand new mercruiser drive complete includin g shaft with u-joints. chasing a vibration from coupler the u-joint shaft … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
I am wondering why my 165 hp Mercruiser in line 6 pre alpha
I am wondering why my 165 hp Mercruiser in line 6 pre alpha sterndrive upper unit shaft didn't go into the engine. It bolted up fine but will not turn the gears in the upper unit when the engine is tu… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I HAVE A 2001 SEARAY 460 DA CUMMINGS/ZF TRANS,I NEED TO REMOVE
I HAVE A 2001 SEARAY 460 DA CUMMINGS/ZF TRANS,I NEED TO REMOVE PORT SIDE TRANS. IS THE SHAFT COUPLING INSIDE THE HULL ?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 350 Mercruiser straight inboard. The outside oil seal
I have a 350 Mercruiser straight inboard. The outside oil seal of the transmission needs to be replaced because of a slow but steady drip. How do I pull the propeller shaft out so that I can replace t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Do you need to change the engine side of the drive spline if
Do you need to change the engine side of the drive spline if wear is showing on outdrive spline ? The unit is a 1996 Bayliner 2655 with a bravo II.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a Sea Ray 175 with 4.3 litre Mercruiser and alpha leg.
I have a Sea Ray 175 with 4.3 litre Mercruiser and alpha leg. Up to about about 10-12 knots all is fine but beyond this putting the throttle down results in the engine revs increasing but absolutely n… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I put a waterpump impeller in my 1997 175 hp EFI Mercury outboard.
I put a waterpump impeller in my 1997 175 hp EFI Mercury outboard. I took it apart with the shifter in forward. When reinstalling the lower unit I put the shifter on the boat in neutral and the propel… read more
Capt.Cory
Capt.Cory
LICENSED CHARTER CAPTAIN
High School or GED
2 satisfied customers
I have a 97 Maxum with a 3.4 liter Mercruiser in it. I pulled
I have a 97 Maxum with a 3.4 liter Mercruiser in it. I pulled it out after a long winter and it started right up. Engine sounds great (had major service last fall). I also had both my props rebuilt ov… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 4.3 litre V6 Mercruiser with an Alpha one outdrive.At
I have a 4.3 litre V6 Mercruiser with an Alpha one outdrive.At full throtle the rpm's max out but the Prop doesn't come along for the ride.At 45 mph the trouble starts, but the boat doesn't speed up a… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
How to remove Mercruiser 454 Magnum from 1987 Sea Ray Sundancer.
How to remove Mercruiser 454 Magnum from 1987 Sea Ray Sundancer. Motor is stuck, and rather than try to bust it loose and hope for the best I plan to open it up and rebuild it. 22+ years and 500 hours… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
have a 83 bayliner with penta aqi25 170 with treedamaged hull
have a 83 bayliner with penta aqi25\170 with treedamaged hull great motor tho, bought 84 bayliner to put my motor into. what is the easyist way to do the swap can i seperate the engine at the bellhous… read more
Scott Martin
Scott Martin
Service manager
Vocational, Technical or Trade Scho
167 satisfied customers
Hi I have a small automatic transmissin fluid leak on a Mercruiser
Hi: I have a small automatic transmissin fluid leak on a Mercruiser 454 330HP V-Drive, 1990 era. This minor leak appears to be coming somewhere between the bellhousing area and the actual V-Drive unit… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
i have a 1977 mercruiser, boat is same year. its 140h 4
i have a 1977 mercruiser, boat is same year. it''s 140h 4 cylinder. on the water i hit something with the prop and it knocked a chunk out of the propeller. it kept going run well the rest of the day. … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a Mercruiser 4.3L engine on my 205 sport Sea Ray (2006).
I have a Mercruiser 4.3L engine on my 205 sport Sea Ray (2006). I am losing oil (no obvious leaks), and also cant get the engine past 4000 RPM. I lost half a quart of oil into the bilge in a 15min tes… read more
Marc C. Albertson
Marc C. Albertson
Chief Service Technician
Vocational, Technical or Trade Scho
56 satisfied customers
i have a 1992 MerCruiser Alpha One gen 2 with a 4.3 lx. i was
i have a 1992 MerCruiser Alpha One gen 2 with a 4.3 lx. i was out driving the other day and the motor just rved up and stoped moving. i backed off and try to go again and nothing. got towed back and t… read more
The Man on the Dock
The Man on the Dock
Marina Owner, Operator
Vocational, Technical or Trade Scho
74 satisfied customers
I have 1988 bayliner with a 5.7 liter mercruiser and an omc
I have 1988 bayliner with a 5.7 liter mercruiser and an omc cobra out board the engine just shut down will we were pulling out of the harbor when we tried to restart it it would not turnover thought i… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I partly dismantled my 4.3L V6 Mercruiser engine whilst motor
I partly dismantled my 4.3L V6 Mercruiser engine whilst motor still in boat (Heads, etc removed) found damaged piston. I want to know if I can remove the motor with the Alpha 1 leg still fitted to boa… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x