Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
It's Bill Wurster - Greater Philadelphia Search and Rescue.
Hi Jason, it's Bill Wurster - Greater Philadelphia Search and Rescue.This is a followup from a year ago.50 HP HONDA BF50LRTA s/n etc: BBEJ‐1003015 BF50LRTA 651950, 04/2008 Fuel InjectedHad this proble… read more
Boat Doc
Boat Doc
252 satisfied customers
3.7L. 165 4cyl mercruiser engine 1988 at idle engine runs
3.7L. 165 4cyl mercruiser engine 1988 at idle engine runs fine...apply gas speed increases then slowly dies to point of stalling if not taken out of gear or starts accelerating then engine starts chok… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Mercury 2002 2 stroke carbuerated outboard starts and idles
Mercury 2002 2 stroke carbuerated outboard starts and idles fine. When accelerating to 1800-2000 rpm still is running fine and then one can feel the additional two cylinders kicking in and accelerates… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 1995 chappral 21ft with a 5.7L mercruiser alpha 1
I have a 1995 chappral 21ft with a 5.7L mercruiser alpha 1 TBI. I'm having fuel delivery problems after it runs for a period of time. I've changed the fuelwater seperation filter. dumped old fuel in f… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
I have a 1986 Evinrude. I was out last weekend enjoying some
I have a 1986 Evinrude. I was out last weekend enjoying some fishing. We shut the boat off several times to drift. A couple of times when moving from place to place the engine seemed to struggle a bit… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
1,074 satisfied customers
I have a 1987 or 8 110hp evinrude the motor was runnng fine
I have a 1987 or 8 110hp evinrude the motor was runnng fine but o the way back to the ramp it just stopped about four hundred yards out , the plugs were dry i took the carb apart and the bowls were dr… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
when i gave the boat some throttle and just after plaining
when i gave the boat some throttle and just after plaining the engine would go back to idle but not die then it would start out again fine and do the same thing acting like i pulled the throttle back … read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a carbed 1998 evinrude 150 2 stroke V6. I had done some
I have a carbed 1998 evinrude 150 2 stroke V6. I had done some trolling and idling yesterday and at the end of a long day went to head in and as i was getting up to plane the motor boged and died out.… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 1994 Sea Ray 7.4 Bravo III with a Weber carburetor.
I have a 1994 Sea Ray 7.4 Bravo III with a Weber carburetor. If the engine is cold, longer than 2 days, I must crank the engine for at least 3 10 second sessions to get fuel into the carburetor to fir… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
hi, I have a 1959 evinrude lark that just recently got a new
hi, I have a 1959 evinrude lark that just recently got a new starter,ever since then it starts,but then stalls and gas shoots out of overflow(just last year replaced points,new float and seals,new gas… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a mercruiser 5.0/V8 Alpha One that will stall. I changed
I have a mercruiser 5.0/V8 Alpha One that will stall. I changed the fuel/water separator and the engine turned over, made popping sound and little puffs of smoke came out of engine. It will run fine u… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1977 25hp evinrude outboard. I.m having trouble with
I have a 1977 25hp evinrude outboard. I.m having trouble with the needle valve in the float bowl sticking. I tried replacing the needle and after the engine sat for a few days it stuck again. I bought… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
I have a Johnson 60hp (gas/oil in separate tanks. I usin supreme
I have a Johnson 60hp (gas/oil in separate tanks. I usin supreme gas. To start I prime the hand device until hard, open the throttle about an inch, push in the choke twice then turn the key to start a… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have two 2004 Mercury 4 cycle 60 hp engines with EFI. The
I have two 2004 Mercury 4 cycle 60 hp engines with EFI. The engines have not been used for 3 years Stable was not used when laying the engines up. After putting in fresh gasoline and cleaning the gas … read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
motor runs great for approx one hour,running full,3/4,1/2,throttle
motor runs great for approx one hour,running full,3/4,1/2,throttle and idle. shut motor off and it won't start after 45 minutes being towed back to dock still won't start. load up and 70 + MILES Home … read more
Jack
Jack
Marine Technician
Vocational, Technical or Trade Scho
54 satisfied customers
I recently purchased a boat it has a 1995 48hp johnson 2- stroke.
I recently purchased a boat it has a 1995 48hp johnson 2- stroke. I had trouble geting it to stay running your website helped me with that. I cleaned the carbs, new fuel filter, and water fuel seperat… read more
Mechman45
Mechman45
Vocational, Technical or Trade School
152 satisfied customers
Could having low gas under 10gallons in a 60 gallon tank cause
Could having low gas under 10gallons in a 60 gallon tank cause boat to run at 3000 rpm when idle? After this happened, I drove the boat a few hundred yards I stopped and tried to start the boat and th… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a 1995 Evinrude 175 HP that stalls after idleing ...
I have a 1995 Evinrude 175 HP that stalls after idleing about 1-2 minutes. I found water in the fuel seperator after attempting to start afer winter storage but have completely cleaned the tank and sy… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x