Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Ho. I have a sea Ray boat with qsm11 both engine wont pass
I have a sea Ray boat with qsm11 both engine wont pass 1000 rpm … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,044 satisfied customers
Mercruiser 7.4 mpi twin engines. One Engine will not go over
Mercruiser 7.4 mpi twin engines. One Engine will not go over 2600 rpm while under load. Sometime the rpm's will increase and go back down again. Changed plugs,wires, dist cap & rotor. I'm having the b… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,044 satisfied customers
I havelem could be?ole. have any ideas what my prob a 1997
I havelem could be?ole. have any ideas what my prob a 1997 Johnson 60 hp 2 stroke engine on my pontoon boat. I recently replaced the water pump and thermostat on it. When I take it out for a run in th… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
K, I'm trying to figure out my overheat problem, over 3000
Hi K, I'm trying to figure out my overheat problem, over 3000 rpm only. First, I had a bad stern drive, replaced it, now coincidence or not, over heating. I first pulled the lower & removed the pump &… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hello, I have a 1998 Johnson Venom 225. Started it up for the
Hello, I have a 1998 Johnson Venom 225. Started it up for the first time in about a year and my idle is very fast 1,400 - 1,500 RPMs. I pulled the coweling and do not see any problems with the cabel o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Have replaced coolingimpeller on my outboard engine. its an
Have replaced coolingimpeller on my outboard engine. its an 140 hp v4 two stroke engine from 1986.Have enough cooling when i am lying still...when i move forward and pass aproximately 3000 rpm, the wa… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1974 Johnson 70ESL74M out board moter. When on the
I have a 1974 Johnson 70ESL74M out board moter. When on the water, I get full power for a short time especially when the water is smooth. When I hit a rough spot in the water ie. waves from other boat… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
i own a 1986 boat that has a 120 hp i/o mercruiser. i just
i own a 1986 boat that has a 120 hp i/o mercruiser. i just bought this unit. it appears to have been well maintained. the seller showed me repair reciepts that included a new impellar. took the boat o… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
recently bought a used poontoon with 50 hp johnson. seems to
recently bought a used poontoon with 50 hp johnson. seems to cruise best at 5000 rpm or below 3000 rpm. speeds between these rpm's wont hold steady.rpm's will rise or lower constantly no matter the wa… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 1986 formula 242ls with a new mercruiser 275hp. from
I have a 1986 formula 242ls with a new mercruiser 275hp. from first mate . alpha with a 15 x 16degree prop. the boat will not go aver 3000 rpm. i have thunderbolt iv and it is working properly engine … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
1986 Evinrude 140 HP, I sank it last june after flushing it
1986 Evinrude 140 HP, I sank it last june after flushing it with fress water and had it running within 40 minutes. then took it out for the day and ran ran it every day for 10 minutes after to keep it… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 17.5 Lund Tyee (rated to 140 hp) and I fish Lake
I have a 17.5' Lund Tyee (rated to 140 hp) and I fish Lake of the Woods in northern MN & Canada with 4 adults in the boat. Mercury makes 115, 125 & 135 hp Optimax motors. Other than the small differen… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1990 60 hp Johnson outboard. I need to set the timing
I have a 1990 60 hp Johnson outboard. I need to set the timing while it is on the boat on the trailor. I was going to back it down the ramp and leave it on the trailor so ièm not going to get the rpm … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I am trying to set the timing on a Johnson v4 140 hp TLCRD.
I am trying to set the timing on a Johnson v4 140 hp TLCRD. I'm backing the boat in and setting the timing on the trailor so i need to know the degrees at 3000 rpm, 2000 rpm, 1500 rpm. I installed a n… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 2008 yamaha two stroke 50 HP. First time leaving the
I have a 2008 yamaha two stroke 50 HP. First time leaving the ramp, the boat runs great with a minor engine cut out @ 2000 rpm. After shutting down the engine, then trying to throttle up again, the en… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
What prop should I use on a 4 stroke Johnson 30 HP outboard
What prop should I use on a 4 stroke Johnson 30 HP outboard motor at 6,000 ft elevation? It is a 2005 outboard model.… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I was running my 1990 Searay with outboard 115HP Mercury (4 ...
I was running my 1990 Searay with outboard 115HP Mercury (4 cylinder with 2 cylinders shutdown at lower RPM)full trottle and when I was tring to reduce speed to lower my trottle handle couldn''t go be… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a 22Ft. Odyssey 2000 pontoon boat, Equipped with a ...
I have a 22Ft. Odyssey 2000 pontoon boat, Equipped with a year 2000 Johnson 50 HP Outboard (J50PLSSM). I am about to replace this motor with an Evinrude 90 HP. However it seems to me, that the rear en… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x