Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 2001 Yamaha F25EHLZ outboard that will start as
I have a 2001 Yamaha F25EHLZ outboard that will start as soon as you touch the starter button when the engine is cold and will idle all day long without a problem. When out on the water and going from… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
2 stroke 8 hp Yamaha outboard. Motor starts easily but
2 stroke 8 hp Yamaha outboard. Motor starts easily but stalls when put in gear. New hi test gas with oil and fuel treatment in the gas. Motor sat upright indoors for 3 years without being used. Motor … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
50 hp yamaha 4 stroke fuel injected runs fine at high speed
50 hp yamaha 4 stroke fuel injected runs fine at high speed but dies when i slow to idel.then is heard to start … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Took my 50 hp outboard out of storage after starting it up a
Took my 50 hp outboard out of storage after starting it up a few times it ran for a short period went dead abruptly now all it wii do is turn over and over but will not start. What could this issue be… read more
Blake P
Blake P
Certified RV & Marine Technician
132 satisfied customers
I, I have a 2001 50 Hp. Yamaha 2 stroke. I idles fine and
I have a 2001 50 Hp. Yamaha 2 stroke. I idles fine and cranks with ease. On the hose I can run it up to full RPM, but in the water (under a load) it will " bog down". For while it would bog a little and then pick up an run normal. Over time it has progressed to the point now that it will not pick up at all. I can still manually run up the RPM on the throttle in neutral. I have change the fuel tank,, hose, fuel pump, plugs and pulled the top carb bowl to look for trash or gunk. Clean as a whistle. The local shop says they have never sold a power pack for this model. Where do I go from here? … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
It starts and idles will not accelerate smoothly, has been
has been sitting for about 6 months ... was difficult to start but now starts and idles.... won't go much above idle with out missing and stalling... suspect main jets are clogged … read more
Shane Creekmore
Shane Creekmore
Certified Mercury Marine technician
High School or GED
557 satisfied customers
I bought a Boat. A really nice shop kept 1996 bass boat. The
Good Afternoon: I bought a Boat. A really nice shop kept 1996 bass boat. The mercury 115hp is the one that came with the boat. The owner hardly ever ran the boat. His wife had it covered with sheets. … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 50 hp 1999 outboard. It was running fine at almost
Hello, I have a 50 hp Johnson 1999 outboard. It was running fine at almost full rpm's until I ran into seaweed and the motor started to over heat, no water coming out the water outlet hole. I brought … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I just replaced my 1992 90 hp Yamaha outboard with a 1986
I just replaced my 1992 90 hp Yamaha outboard with a 1986 115 Yamaha outboard on a 1992 17 foot Scout boat. All the wiring and cables hooked up. When first starting the motor it reved up high and had … read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I HAVE A 2004 YAMAHA 40 HP TLRC CARBS HAVE BEEN REBUILT NEW
I HAVE A 2004 YAMAHA 40 HP TLRC CARBS HAVE BEEN REBUILT NEW FUEL PUMP, COMPRESSION IS 110 ON ALL 3 CYL. ITS CHUGGING AT AN IDLE AND SEEMS TO BE BACKFIRING AT WOT, I PUULED THE PLUG WIRES ONE AT A TIME… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Yamaha 4 stroke outboard F115TXRD manufactured 7/04 July 2004
Yamaha 4 stroke outboard F115TXRD manufactured 7/04 July 2004 68VX1035749 It freqently cuts out when you slow down and return to neutral / idle. Only way to start is throttle in neutral then pull back… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1990 force 120 outboard, I beleive it's a 125 HP
I have a 1990 force 120 outboard, I beleive it's a 125 HP motor. Runs great at full open throttle but very hard to get started. Hard to get it to idle, stalls at low RPM and then extremley hard to get… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I am having Trouble Shooting a Yamaha model c60v 50 hp outboard
I am having Trouble Shooting a Yamaha model c60v 50 hp outboard 2 stroke engine stalls while accelerating.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
have a 1989 50 hp 3 cylinder yamaha outboard. It starts fine
have a 1989 50 hp 3 cylinder yamaha outboard. It starts fine but stalls out after 10-15 seconds. will stay running if I throttle up while in neutral, but stalls out when I go back to idle to shift int… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
what would cause my 1974 302 225 hp mercruser to stall when
what would cause my 1974 302 225 hp mercruser to stall when trolling on lk michigan also it is running real ruff between 1200 and 1500 rpm's. runs great at 800 to 1000 and over 1400 rpm's Chnaged out … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Hi i own a 2006 yamaha 25hp 4 stroke outboard it is a base
Hi i own a 2006 yamaha 25hp 4 stroke outboard it is a base model with no electric start or tilt trim. i bought it second hand with the prior owner stating it had about 180hours use. I have just comple… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 2008 50 hp mercury outboard with power tilt/trim.
I have a 2008 50 hp mercury outboard with power tilt/trim. The boat/motor has about 20 hours on it and is stored at a slip in the water. The motor is typically trimmed out of the water when I leave. A… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I Have A 200 hp Yamaha Outboard 2 stroke. Last week it started
I Have A 200 hp Yamaha Outboard 2 stroke. Last week it started up fine, and ran fine at full throttle, at idle it would stall out. This week It still wont idle but has started revving to around 6000 r… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x