Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I added gear lube to my 245 Bayliner with a 5L merc (rebuilt
I added gear lube to my 245 Bayliner with a 5L merc (rebuilt with a jasper block). Could be coincidence but after adding gear lube to the reserve tank (just below the add line), my boat stopped perfor… read more
Charles
Charles
Certified Mercury Tech
5,153 satisfied customers
Lower unit on Yamaha 150 seems to be slipping, Twin engines.
Twin engines. Increase revs to get on plane. When both engines reach 3000 rpm the left hand rotation engine revs like prop isnt grabbing. Revs increase quickly but prop doesn't grab water … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
low power,merc,with a alpha 1, 5.0 liter, engine runs up too
low power,merc,with a alpha 1, 5.0 liter, engine runs up too speed, will not plane and goes into overheat at 4000 rpm, slight vibration at 2000 rpm, cant get above 15-20 mph, let off on throttle and c… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
have murcurser alpha 1 4.3L stern drine engine.RPM going crazy
have murcurser alpha 1 4.3L stern drine engine.RPM going crazy .up and down.on startup it reads 3000- 4000 rpm, engine sounds fine,temp fine,prop fine???????… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I am thinking of changing my prop to a high five 13.5" with
I am thinking of changing my prop to a high five 13.5" with 17P from the factory 3 blade 14.5" 19P I have a mercruiser 3.0LX with an alpha one and top RPM is about 4200 at full throttle I am trying to… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,264 satisfied customers
I own a 2009 Merc 50 ELPTO 2-stroke on a Triton VT18 aluminum
I own a 2009 Merc 50 ELPTO 2-stroke on a Triton VT18 aluminum shallow V bass boat. More frequently in warm weather, and sometimes unpredictably, when I start up to take off and make a run at high spee… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
TRYING OUT BOAT; 4.3LX/V6 SN; OD817381 TRANS SERIAL#;OD746904 DRIVE
TRYING OUT BOAT; 4.3LX/V6 SN; OD817381 TRANS SERIAL#;OD746904 DRIVE SERIAL# XXXXX ALPHA ONE TRIED OUT, RAN GOOD WITH GOOD PICK-UP AND ON PLANE BUT NOTICED SOME NOISE AND VIBRATION AT LOW RPM. RAN AROU… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
17,310 satisfied customers
Folks, I am still at the lake and I just hit something in the
Folks, I am still at the lake and I just hit something in the water. It was a barely noticeable bump but it was there. This happened in a hard turn. I notices the engine was running fine after that fo… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,729 satisfied customers
I have a 2005 Mercruiser 350 MAG MPI with a Bravo III drive.
I have a 2005 Mercruiser 350 MAG MPI with a Bravo III drive. After launching 2 weeks ago, I ran it in the bay at all speeds for 1/2 hr. and it ran fine. The other day I started it up at the dock and n… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1997 Bayliner Cierra Express Cruiser. It has a 4.3L,210hp
I have a 1997 Bayliner Cierra Express Cruiser. It has a 4.3L,210hp engine. It has an Alpha One Gen.II stern drive by Mercruiser. It has an aluminum prop 16" diameter and I think it is a 16 " pitch bec… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
704 satisfied customers
Hi Jeff, thank you for your reply. The jack plate is, or I
Hi Jeff, thank you for your reply. The jack plate is, or I should say fine. It didn't move. I checked with measurements off the motor mount area and from top and all measurements were fine. When I men… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,729 satisfied customers
Just got off the lake with a new prop the boat only got to
Just got off the lake with a new prop the boat only got to 3400rpm and seem to pull to the left I had abunch of work on my sterndrive the boat has a merc 5.7 with alpha 1 drive what causes a boat to l… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 16 Galaxy bowrider (1980) with a 3.0L mercruiser
I have a 16' Galaxy bowrider (1980) with a 3.0L mercruiser 120hp I/O, Mercruiser outdrive (not the bravo or alpha). Recently changed props after the 14"x19pitch would only get me to 28 or 29 mph at 51… read more
Andy
Andy
Marine Repair Technician
Vocational, Technical or Trade Scho
16 satisfied customers
Hi I have a 87 crusier with a merc 5.7 alpha 1 sterndrive,
Hi I have a 87 crusier with a merc 5.7 alpha 1 sterndrive, took the boat in for service had some noise in the drive and paid for drive upper bearings and drive service the shop charge me. The problem … read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,385 satisfied customers
i have a merc cruiser 5.7l EFI with Alpha One drive - i have
i have a merc cruiser 5.7l EFI with Alpha One drive - i have it in a lake at 5400' elevation. I can not get it to goet over 3000 rpm with passengers on it. it does not plane out. it will plane out (ba… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 2001 Rinker 340 FV with twin FWC 6.2 Mercs / Bravo
I have a 2001 Rinker 340 FV with twin FWC 6.2 Mercs / Bravo III drives. I had the duo props removed for service over the winter. Now the boat will barely plane. It bogs down at 3000 rpms and slowly ch… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
which prop goes with a d3 190 i have x4 on at the monent and
which prop goes with a d3 190 i have x4 on at the monent and the boat will not plane my boat is a sealine 328. i have had x5 before this. twin engine diesel.will not get on plane i can only get 3000 r… read more
Dan Boy
Dan Boy
Amusement ride technician
High School or GED
110 satisfied customers
I have recently installed an aftermarket stern drive on my
I have recently installed an aftermarket stern drive on my 1991 boat with alpha model Mercruiser engine. It now has trouble achieving planing speed. The motor does not turn as fast as it used to eithe… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

704 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

17,310 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,264 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,729 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x