Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2002 hpdi 200hp Yamaha, just purchased boat. Had been
2002 hpdi 200hp Yamaha, just purchased boat. Had been sitting for a few years with fuel in it. Drained all fuel & changed water separators, filter inside clear plastic tube, replaced internal pump & f… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 2004 Yamaha 115 HP 2 stroke saltwater series outboard.
I have a 2004 Yamaha 115 HP 2 stroke saltwater series outboard. 180 hours on the clock. The motor stalled, when started again the motor idled no issue, when put into gear and increasing the throttle t… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 1989 Force 85 h.p. outboard. The problem I have is
I have a 1989 Force 85 h.p. outboard. The problem I have is this: It will start right up, but when I go to accelerate it will fall flat and at times stall. I had a boat repair shop look at it and tell… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
1996 offshore 225 hp purchased 24 grady with this motor. 21inchx13
1996 offshore 225 hp purchased 24' grady with this motor. 21inchx13 pitch prop. found fuel pump difective.replaced. problem is if i slowly throttle up the motor will stall but if i instantly throw to … read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
My 2009 225 Suzuki starts and runs perfect. When I throtle
My 2009 225 Suzuki starts and runs perfect. When I throtle up to 3000 rpm or higher the motor runs for 30-40 seconds then bogs down and stalls. Changed the exterior gas water seperator the internal on… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
boat is idling and dies after it is idling in no wake area
boat is idling and dies after it is idling in no wake area or seems to idle then when you put the throtle down fast it dies after, 20 minutes the boat restarts it runs high speed fine slower speeds di… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1999 johnson 90 hp, premix, idles ok but after running awhile
1999 johnson 90 hp, premix, idles ok but after running awhile and shut off, will start fine but bogs down and stalls when put in gear. i have replaced plugs cleaned fuel filter checked fuel, fuel line… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 50 hp Yamaha outboard F50TLRF 6C1L1017967 I installed
I have a 50 hp Yamaha outboard : F50TLRF 6C1L1017967 I installed the engine on a different boat and took it for a test drive. The engine started and ran flawlessly. I ran it for about one hour in the … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2005 Scout with a 150 Yamaha. The engine is cutting
I have a 2005 Scout with a 150 Yamaha. The engine is cutting out after running the boat at high rpms. When we pump the ball the engine restarts and runs for awhile. After getting back up to high rpms … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
i have an 2005 DF 140. i did not use it for 7 months and so
i have an 2005 DF 140. i did not use it for 7 months and so i threw out all the gas and put 32 gallons of fresh gas in it. i added 28 oz of yamaha fuel stabilizer/conditioner. it starts promptly and i… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
I have a 2004 Yamaha 90 2-stroke. Runs great... but doesnt
I have a 2004 Yamaha 90 2-stroke. Runs great... but doesn't idle perfectly - coughs and stalls... seems to idle at a very low RPM.... also a touch slow to start the engine (don't know if that's relate… read more
Jason Forsberg
Jason Forsberg
Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
I have a 2003 Honda 90 hp carburated boat motor and am having
I have a 2003 Honda 90 hp carburated boat motor and am having trouble with it sputtering and stalling out at 2K and 3K rpm. It starts right up and once I get past 3500 rpm it's runs fine. I had the ca… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a 2003 yamaha Lx 210 twin 135Hp. The problem is that
I have a 2003 yamaha Lx 210 twin 135Hp. The problem is that up to 4500 RPM,s the boat runs fine, at aproximately 5000 RPM's the starboard motor stops, the motor will restart but not exceed 5000 RPM's … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Yamaha FL115. engine idles reasonably well but not increase
Yamaha FL115. engine idles reasonably well but not increase rpm under load. Engine bogs down and sometime quits. Good fuel. clean filters. new plugs. fuel pressure at rail is about 38 psi. good spark … read more
Jason Forsberg
Jason Forsberg
Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
my yamaha LZ250TXRB outboard loses power at about 3500 rpms.
my yamaha LZ250TXRB outboard loses power at about 3500 rpms. i have drained all fuel, changed all fuel filters and cleaned water seperaters. any clues to what the problem might be?… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
2001 Johnson 150. During heat of the day or after johnson
2001 Johnson 150. During heat of the day or after johnson 150 runs awhile and you stop for awhile, the Johnson stalls when attempting to put it into gear. Must repeat numerous times before it will run… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a 50 hp johnson 2004. i resently had it tuned up and
I have a 50 hp johnson 2004. i resently had it tuned up and was told the compression is lower on one side. the boat had trouble starting and running in idle. once i engaged the throtle it ran fine. i … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Im trying to tune up a Yamaha VMax 200 on the 1992 Mastercraft
I'm trying to tune up a Yamaha VMax 200 on the 1992 Mastercraft Barefoot 200. Both boat and motor are in great shape, very clean and well cared for. The motor starts fine but puts out white smoke (lik… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x