Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I just had my 24 foot Pursuit with Mercruiser 350 Mag MPI,
I just had my 24 foot Pursuit with Mercruiser 350 Mag MPI, new transom, new outdrive bravo 3 and new prop at a good place that has certified mechanics from mercruiser. I'm about 10 hours on the new sy… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My 4 winns H260 just started to take on more water in the
my 4 winns H260 just started to take on more water in the bilge than normal? used to hardly take in any water, now overnight I'm having to run the bilge for 20-30 seconds full flow … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have an older 77 searay, repowered, it has hydrolic
I have an older 77 searay, repowered, it has hydrolic teleflex duel helm steering with what I believe to be mercruiser or Saginaw power assist, can I remove the power steering pump..the belt driven on… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Good morning, I'm considering purchasing a 2006 280 Sea Ray
Good morning, I'm considering purchasing a 2006 280 Sea Ray Sundancer with twin 5.0 engines and 400 hours. During the sea trial I noticed that the engines were slow responding to the throttles. It was… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Jason, I have a sound hull 1987 Searay Amberjack that I
Hi Jason, I have a sound hull 1987 Searay Amberjack that I really like(layout) - but the drives and engines are badly corroded and worn out. I want to repower with something that runs smoothly, a litt… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 8.1 Merc with 40 hrs on it. Boat over heat alarm started
I have a 8.1 Merc with 40 hrs on it. Boat over heat alarm started coming on after about 15 mins and only at higher RPM's. Mech changed water pump and impeller, Still doing the same thing, mech has giv… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a Bayliner 2855 96 model and it has a 7.4 mercruiser
I have a Bayliner 2855 96 model and it has a 7.4 mercruiser with bravo 3 drive and 26 p props on it . i was out with a group of 6 adults on board and it could not get up on to the plane. the engine wa… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,639 satisfied customers
I have a 1986 44 Gibson houseboat powered by twin 454 mercruisers
I have a 1986 44' Gibson houseboat powered by twin 454 mercruisers with bravo II drives. I think it weighs around 19000lbs. I am considering doing the Great Loop and am worried about the reliability o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Can you swap out a Bravo I or an Alpha I lower unit with a
Can you swap out a Bravo I or an Alpha I lower unit with a Bravo III lower unit. Trying to see if there is a way to convert to a dual prop without having to go buy a different boat.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
if you are looking for a 40" Sea Ray Boat, does the boat perform
if you are looking for a 40" Sea Ray Boat, does the boat perform better with Merc DTS Bravo III or the Merc V-Drive? Cruising speed? fuel burn per hour? faster to plane?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi All. I am thinking off upgrading my sterndrive leg from
Hi All. I am thinking off upgrading my sterndrive leg from bravo 1 to bravo 3. I have been offered a leg and transom plate to suit the motor i already have in my boat which is a 496 ho mag. My questio… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
this is for James Will, hello James! I have been doing some
this is for James Will, hello James! I have been doing some research on the internet and I have come to the conclusion that the speed of the boat really depends on the hull, am I rightand weight? I co… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I just bought a 32 planing hull cruiser that needs to be repowered,
I just bought a 32' planing hull cruiser that needs to be repowered, probably with twin 5.0 mercruiser EFI and Bravo II. Displacement wet is about 14,000 lbs. What stern drive gear ratio would you rec… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Im looking to repower my 28 Ft. Bertram with twin diesels.
I'm looking to repower my 28 Ft. Bertram with twin diesels. Right now it has twin Mercruiser 350s. What should I be looking for in a diesel engine?… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
At the end of last season my rinker with a 454 ci was reving
At the end of last season my rinker with a 454 ci was reving up to 5000rpm ( had never gone beyond 4200 rpm ) and the speed had dropped from 40 mph to 22mph. We had just recently installed the bravo 3… read more
Kenny
Kenny
Mercury & Mercruiser Diagnostics
Master's Degree
99 satisfied customers
I have an 89 Donzi Regazza that is starting to leak oil and
I have an '89 Donzi Regazza that is starting to leak oil and has serious spark knock at high acceleration. Use to run 50MPH top end now tops is maybe 44. Should I: A. Buy a crate engine. B. Replace ne… read more
John White
John White
Marine Mechanic
Vocational, Technical or Trade Scho
306 satisfied customers
I have a 31 foot sundancer with 2 7.4 litre MPIs and Bravo
I have a 31 foot sundancer with 2 7.4 litre MPI's and Bravo 3 drives. Have 400 hours on the boat without incident. Port engine is having trouble shifting from neutral to eithe forward or reverse. The … read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Bravo III Out drive I need to scrape some blistered paint
Bravo III Out drive: I need to scrape some blistered paint on my outdrive. Is is recomended to remove the trim pistons to make sure I get complete coverage when I spray paint? Is there anything this t… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x