Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
40:-P. 1996 venture motor on my pontoon boat put in water in
40:-P. 1996 venture motor on my pontoon boat put in water in June I took it out tie e for a short trip on our lake twice, run perfectly, then on third time out it started acting up within a mile at sl… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Have an older 25 hp and we are having problems keeping it
have an older Johnson 25 hp and we are having problems keeping it running. It seems like we need to keep pumping the bulb from the gas tank in order to keep it running at a steady pace. I can somewhat… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Have a 1995 60 hp Mercury motor. Have had the carbs gone through,
Have a 1995 60 hp Mercury motor. Have had the carbs gone through, rebuilt the fuel pump, have new spin on fuel filter, new gas lines, bulb , and tank, plus new gas. It is on a 18 foot pontoon boat. To… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 30 hp outboard johnson long shaft with controls that
I have a 30 hp outboard johnson long shaft with controls that i just put on my pontoon boat. When i start it by choking it and pulling up throttle it will start and run for 5-10 seconds then it quits.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 4 stroke Mercury 115 hp motor on my 22 Bennington
I have a 4 stroke Mercury 115 hp motor on my 22' Bennington Pontoon boat. It is surging a lot. Runs good then seems like it get bogged down, them will run good for a little while then does the samethi… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
Have a Mariner 1992 40 hp ELO oil-injected motor on pontoon,
Have a Mariner 1992 40 hp ELO oil-injected motor on pontoon, I recently refurbished the pontoon and did work to engine: new gas hose & bulb, rebuilt carbs, new fuel pump, cleaned advance, new plugs, a… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1994 Johnson 70 hp died when got to 3500 rpm after 2 hours
1994 Johnson 70 hp died when got to 3500 rpm after 2 hours on the water and It will only run if I start and rev but it dies at idle. I turned it on with gas line off the carb and it shot a nice stream… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
2000 70 hp Johnson ... seems to loose fuel prime @ idle & die.
2000 70 hp Johnson ... seems to loose fuel prime @ idle & die. New primer bulb yesterday. Ran perfect last fall. No leaks detected anywhere. If I keep squeezing the bulb, it keeps running. Any suggest… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1998 johnson 50 hp keeps flooding gas into block fouls plugs
1998 johnson 50 hp keeps flooding gas into block fouls plugs runs for about 3 minutes then leans out rebuilt carbs renewed needle & seats floats all new gaskets checked reed valves Compression is even… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
70 hp mariner, runs well with muffs. put in water and will
70 hp mariner, runs well with muffs. put in water and will push when in gear at 1000rpm, after that will push up to 2000rpm and then start to die out. checked spark and it is over 1/2 inch. acts like … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
Im having a problem with low idle and a primer pump bulb not
I'm having a problem with low idle and a primer pump bulb not staying firm on a Johnson 115 motor (1995). I just had the boat in for tune up/repairs and first time I took it out it started and ran fin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
i have a 1992 70 hp evinrude mounted on a 18 ft. pontoon boat
i have a 1992 70 hp evinrude mounted on a 18 ft. pontoon boat -- it starts fairly good and runs good for about 20 minutes -- then it starts surging from 5500 rpms down to about 3500 rpms and back up a… read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
I have a 2001 Johnson 90 hp outboard motor on my pontoon boat.
I have a 2001 Johnson 90 hp outboard motor on my pontoon boat. The motor stalls constantly. Even after the boat started running, it ran for a few minutes and stalled again. It seems like it only runs … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
i have a 1993 johnson with fuel coming out of the back of the
i have a 1993 johnson with fuel coming out of the back of the jets. my mechanic said it was the reeds with very little troubleshooting. boat has no horsepower and no top end .already spent 1000 to fix… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
140 HP JOHNSON NEARLY STALLS BUT DOENT DIE. HAPPENS AT ALL
140 HP JOHNSON NEARLY STALLS BUT DOEN'T DIE. HAPPENS AT ALL SPEEDS. SOMETIMES DOES THIS RAPIDLY ( SURGES ). SOMESTIMES RUNS FINE FOR A LONG TIME. SOMETIMES DOES THIS EVERY FEW MINUTES. ONLY CORRECTION… read more
Jeremy R.
Jeremy R.
MarineTechnician
9,023 satisfied customers
We have a 1989 Evinrude 150 HP outboard that was recently rebuilt
We have a 1989 Evinrude 150 HP outboard that was recently rebuilt - cylinders bored .030, new pistons, rings, and gaskets, rebuilt carbs. The motor is flooding itself and misses at low RPM. Plugs are … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
i have a j130pxee johnson motor been having trouble with it
i have a j130pxee johnson motor been having trouble with it running. at one time while on the water max throttle the rpm indicated 2500. a little time later the engine started to increase power to 500… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
I have a mercury 50 ser#6223351 3 cyl engine that the carbs
I have a mercury 50 ser#6223351 3 cyl engine that the carbs were just rebuilt. The motor will run after playing with the choke pushing the button then die out if I play with the button pushing in ever… read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x