Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I got in my pontoon boat this evening and I cannot get the engine to lower its an outboard
I got in my pontoon boat this evening and I cannot get the engine to lower its an outboard. its a 50 horsepower Johnson and the lift controls are on the throttle at the steering wheel. About seems to … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
There. I am looking to buy a first boat with a friend. Something and river
Hi there. I am looking to buy a first boat with a friend. Something for coastal and river "pleasure"/cruising use. Shetland 535 70 hour or Microplus 502 40 hp / similar perhaps. Wondering how much dif… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 1998 Johnson 70 hp outboard. Motor was running great
I have a 1998 Johnson 70 hp outboard. Motor was running great this weekend and when I pulled up to the dock and let the boat idle while going to get my truck and trailer it shut off. I tried to crank … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Problem - my husband personally installed Teleflex 7500 series
Problem - my husband personally installed Teleflex 7500 series in 21ft 1996 Wahoo to 1996 Johnson 150 . Had a problem with shift cable- reverse would not fully engage. Took it to boatyard mechanics. B… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Have a 1995 E60TLEOC on Sylvan 1995 pontoon boat. I bought
Have a 1995 E60TLEOC on Sylvan 1995 pontoon boat. I bought it used and have looked for the warming horn or busser. It did not come with one. I need to know what busser to buy and how to wire it in. Ca… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,504 satisfied customers
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the
i hsave a 96 crest 18 ft pontoon with a 70 hp johnson. the helm is located at the rear. the boat is rated 1900 lbs/75hp . when i am towing a tube, the majority of the outboard shaft is under water and… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 17.5 Lund Tyee (rated to 140 hp) and I fish Lake
I have a 17.5' Lund Tyee (rated to 140 hp) and I fish Lake of the Woods in northern MN & Canada with 4 adults in the boat. Mercury makes 115, 125 & 135 hp Optimax motors. Other than the small differen… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1999 Johnson J50PLEE outboard. The motor sat (on
I have a 1999 Johnson J50PLEE outboard. The motor sat (on a covered and garaged boat) for 3 or 4 years. I recently changed the gas, cleaned the carbs, and took it for a ride. Everything worked fine fo… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Im having a problem with low idle and a primer pump bulb not
I'm having a problem with low idle and a primer pump bulb not staying firm on a Johnson 115 motor (1995). I just had the boat in for tune up/repairs and first time I took it out it started and ran fin… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Hi I have a1998 1800 capri bayliner with a 120 force and was
Hi I have a1998 1800 capri bayliner with a 120 force and was wanting to up grade to a 150 efi mercury outboard.Will the transom be strong enough for this outboard . Or can the boat handle more or less… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Thanks for the reply. Guess I forgot that I have already cleaned
Thanks for the reply. Guess I forgot that I have already cleaned the carbs as I have had to do every spring. Do you reccomend that I put new kits in them? Because the oil-injection system would fill t… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 30 pontoon boat with a 1993 70 HP Johnson. The motor
I have a 30' pontoon boat with a 1993 70 HP Johnson. The motor seems to run fine about 2500 RPM, anything over that it starts to surge and will die. If I pump the prime bulb the motor RPM's increase w… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I am planning to buy a Rivera pontoon. 1999 Rivera Pontoon
I am planning to buy a Rivera pontoon. "1999 Rivera Pontoon Boat. 24 foot long. With 70 horse Johnson outboard motor. Also comes with a Tennessee 2000 model trailer. Seats 18 people. Has on board bath… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a ns40c 2 cycle outboard engine and it seams to be running
I have a ns40c 2 cycle outboard engine and it seams to be running good but I fon't seams to be be getting max performance or speed out of it. It was purchased used. It is powering a 20 ft pontoon boat… read more
Jason Forsberg
Jason Forsberg
Outboard Marine Mechanic
Vocational, Technical or Trade Scho
531 satisfied customers
on the right top side of my shifter on my 2000 premier pontoon
on the right top side of my shifter on my 2000 premier pontoon boa0t is a black square rubber button about 3/4 of a inch long that can be pressed seems like a switch or sometbing, or mabey to give the… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the
I have a 24 ft pontoon boat with a 2005 90 hp outboard ,the engine cavitates alot some times at 3500 rpm somtimes higher ,cruising at 3000 to 3500 for no reason at all the rpms start climbing. the eng… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I just bought a Crest Pontoon boat. It has a 1994 ...
I just bought a Crest Pontoon boat. It has a 1994 Johnson Outboard 70HP motor.Rebuilt Carbs,150lbs compression on each cyclinder.runs @ 2500to3000rpm . Starts , runs in low to mid range throttle. new … read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
I have a 22Ft. Odyssey 2000 pontoon boat, Equipped with a ...
I have a 22Ft. Odyssey 2000 pontoon boat, Equipped with a year 2000 Johnson 50 HP Outboard (J50PLSSM). I am about to replace this motor with an Evinrude 90 HP. However it seems to me, that the rear en… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,504 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x