Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
98 twin 350 Vortex throttle body fuel injection on a Searay
98 twin 350 Vortex throttle body fuel injection on a Searay 290Are there more than one oil pressure senders on these motors? I have disconnected the wire from what I thought was the only oil sender an… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
I have a 1996 28' sea Ray with twin 350 merCruiser engines
Hello I have a 1996 28' sea Ray with twin 350 merCruiser engines there is a buzzer coming from the dashboard when I start the starboard engine Oil is full lower unit oil is full Any ideas ? Thanks kei… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
I have a 1996 mercruiser 4.3lx with alpha 1 gen 2. I got a
I have a 1996 mercruiser 4.3lx with alpha 1 gen 2. I got a steady alarm while cruising and temp reads fine and so does oil pressure, I do not have an oil monitor bottle so will this still alarm for lo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,507 satisfied customers
Both 496 mags will not stay running. Schared valve had little
Both 496 mags will not stay running. Schared valve had little air. Boat ran fine when docked. Yesterday starboard out lube bottle empty(strange). Alarm going beep-beep.filled bottle with lube. connect… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have twin mercruiser 5.0 2002 engines. Gimbles/ shift cables
I have twin mercruiser 5.0 2002 engines. Gimbles/ shift cables were just replaced, engines out- prior had no problems with alarms or stalls. Now back in water and I have an intermittent 2 minute alarm… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
1983 Mercruiser 340HP inboard, starboard motor (counter-rotating)
1983 Mercruiser 340HP inboard, starboard motor (counter-rotating) lost power and oil pressure on Tahoe yesterday afternoon in 3-4 foot surf, limped in on one motor. Shut the motor down as soon as the … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
i have a 2006 38DA sun dancer with twin 8.1 horizon mercruiers.
i have a 2006 38DA sun dancer with twin 8.1 horizon mercruiers. they have run perfectly every summer and just recommissioned after winter dry dock. Starboard motor is running at 38psi oil pressure por… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,804 satisfied customers
today went on a cruise with my 400 sundancer. it has twin mercruiser
today went on a cruise with my 400 sundancer. it has twin mercruiser 7.4 mpi's. ran it up to about 3800 rpm, ran great. back it down to 1200 and was cruiseing and at some point the port oil pressure w… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have 28ft Searay and after driving for an hour the oil pressure
I have 28ft Searay and after driving for an hour the oil pressure gauge dropped to zero and the boat alarm went off. Plenty of good clean oil in the motor. No over heating, no unusual noises, no moist… read more
Noel Schembri
Noel Schembri
Marine Mechanic
Diploma
2,759 satisfied customers
I recently bought a 1998 Tiara coronet with twin 454s that
I recently bought a 1998 Tiara coronet with twin 454's that has about 480 hours. Things have been running great until tonight when during an short sunset cruise I noticed the port engine oil pressure … read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
I have a 2003 Searay Amberjack with twin Mercruiser 5.7 Horizon
I have a 2003 Searay Amberjack with twin Mercruiser 5.7" Horizon 350's My starboard engine simply shut down as I was crusing back to my slip -- roughly 5- 5.5 knots (no Wake zone) and was not able to … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
where is the starter located on a sea ray 340 sundancer starboard
where is the starter located on a sea ray 340 sundancer starboard 7.4 engine. I assume its on the lower right side of engine if looking from the rear of the engine. do you know if the 1987 sundancers … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have twin 2000 5.0 mercs (EFI) with roughly 350 hours on
I have twin 2000 5.0 mercs (EFI) with roughly 350 hours on them. This spring I've had an intermitent problem with the engine alarm. typical condition is when backing down off of plane, alarm goes down… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2002 searay with twin 350 mag.We took a 20 minute
I have a 2002 searay with twin 350 mag.We took a 20 minute cruise across the Chesapeake. When i throttled down the starboard engine stalled. The next day the engine started ,we did a return trip home … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
3,332 satisfied customers
I have a 2005 Larson with twin inboard 420hp HO Mercruisers.
I have a 2005 Larson with twin inboard 420hp HO Mercruisers. While out today, the engine alarm sounded continuously after bringing revs up to 1500 rpm, no noise during initial 10 minutes below 1000rpm… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,427 satisfied customers
Hello, I have a 1998 carver 405 with twin cummins 330 diesel
Hello, I have a 1998 carver 405 with twin cummins 330 diesel engines. My starboard oil pressure switch reads zero at low speeds and then shows normal pressure at cruise speed. I'm not leaking any oil … read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
Have a mercruiser 260, just replaced motor and now my oil pressure
Have a mercruiser 260, just replaced motor and now my oil pressure indicates around 40 when idling or below 2000 rpm. When I try to accelerate above 3000 rpm pressure gauge drops. I would be expecting… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I have a 2003 Maxum with twin Mercursier 350 Mag MPI - Bravo
I have a 2003 Maxum with twin Mercursier 350 Mag MPI - Bravo 3's in which I am have an intermitent alarm (2 beeps every minute). The alaram begins as soon as the engine is started. Gear lub reservior … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

3,332 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,804 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,507 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

2,759 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x