Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Ihave an old (1979) Spacecraft boat that I have changed from
Ihave an old (1979) Spacecraft boat that I have changed from a Stinger 800 outdrive to a Mercruiser outdrive. Took lots of work. My questions are: … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I have a Montauk and want to put an underwater light on the
I have a 69 Montauk and want to put an underwater light on the back of the transom. The hole has been drilled for the wiring and it appears I've missed any wood core and there is only foam core where … read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
2,048 satisfied customers
Have reinstalled GM 305 small block motor in Bayliner boat
Have reinstalled GM 305 small block motor in Bayliner boat and can't figure out mounting the cooling cylindrical reservoir over the thermostat access on intake manifold? I know ha there is no thermost… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I need to replace a round hatch cover on my boat. It's
I need to replace a round hatch cover on my boat. It's located in the area in front of the outboard motor. It's on a small incline, the rubber gasket is broken, I assume that comes with a new hatch co… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I recently purchased a 1997 Sea Ray 400 Sedan Bridge and I
Hi, I recently purchased a 1997 Sea Ray 400 Sedan Bridge and I would like to install a drain plug in the transom to keep open while it's out of the water. Any suggestions you could provide would be mo… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Bought a used 2001 Sea-Doo Challenger 189 Bombadier and took
Bought a used 2001 Sea-Doo Challenger 189 Bombadier and took it out today for the first time and the hull completely filled with water! Drain Plus were in … read more
Boat Doc
Boat Doc
253 satisfied customers
I have threads that I need to run a tap through on the motor
I have threads that I need to run a tap through on the motor mount bracket and don't know the size of the thumb screw threads. I don't want to run the new thumb screw assembly through the motor mount … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i have a small 1995 17 Spectrum fishing boat. It has accumulate
i have a small 1995 17' Spectrum fishing boat. It has accumulated many small holes on the transom from different fish finders throughout the years. I need to install a new transducer and would like to… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I recently had a rebuilt big block installed on the starboard
I recently had a rebuilt big block installed on the starboard side of my 34 scarab. It was a new boat to me this year and I noticed that the engine oil was milky after little use. I changed the oil an… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I need to know what size flywheel and teeth count for a 1996
I need to know what size flywheel and teeth count for a 1996 mercuiser 5.7. I got a Hydro lock from getting water in the 5 and 7 cylinders. Leaking exhaust maifolds. Replace them now to fix ring gear.… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 50 hp (1996) (ser#0G291554). I have plenty of water
I have a 50 hp (1996) (ser#0G291554). I have plenty of water discharging through the P-Hole, and prop., but none through the exhaust on the foot just under the engine. However I have a hose dischargin… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I blew my Chyrsler 318 super bee II - not rebuildable, so I
I blew my Chyrsler 318 super bee II - not rebuildable, so I bought a rebuilt 318 car block with 10:1 compression pistons, put ina comp cam 268H cam, dbl. roller chain, pro-form roller rockers, new pus… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
i have a 1987 mercruiser 3.0 4cyl it has snapped the starter
i have a 1987 mercruiser 3.0 4cyl it has snapped the starter shaft twice i replaced it w/ a new merc starter it worked great. @ 25 hours it snapped the the short mounting bolt.what the ding dong is go… read more
Dominick
Dominick
Marine Mechanic
Vocational, Technical or Trade Scho
1,009 satisfied customers
my 96 900 zxi jet ski oil pump fell off ...cant find the bolts
my 96 900 zxi jet ski oil pump fell off ...cant find the bolts ...dealer ship said they were 6mm -25 socket screws , got them ...but they are too small...went to 8mm too big went to 7 mm too small ...… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 1968 Sportsfour 65hp engine which i bought in 1969.
I have a 1968 Sportsfour Evinrude 65hp engine which i bought in 1969. the gearcase oil gets milky after use. Which seal needs to be replaced and where can i obtain the seal kit. can you describe what … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a freeze plug that popped out of the block and it is
I have a freeze plug that popped out of the block and it is behind an engine mount. The plug looks to be in perfect shape, but I can not get to the hole without removing the engine mount. Any suggesti… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I recently installed what I thought was a 350 small block,
I recently installed what I thought was a 350 small block, into a jet boat. While hooking up the u-joints/yolk from crank to the jet I noticed the fly wheel (heavey,like for a standered transmission)h… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have an old Johnson (70 s or 80s) 28HP SPL and I noticed
I have an old Johnson (70"s or 80's) 28HP "SPL" and I noticed about 4 1/8" holes about 1/2" deep near the trim fin on the lower section of the foot. This motor has been rebuilt but it seems to be leak… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x