Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 95 OMC Cobra 744DPHUB. I pulled my drive this
I have a 95 OMC King Cobra 744DPHUB. I pulled my drive this weekend and found water in the u-joint bellows and a rusted Gimbal bearing. Can those be replace without pulling the Gimbal Ring? … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 92 caravel boat w/ 140 OMC cobra drive. A shaved
I have a 92 caravel boat w/ 140 OMC cobra drive . A shaved exhaust bellows was installed before I bought the boat. Would I be able to replace it with a unshaven bellows? I read other post that said ex… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Tan, After 8 years I was finally able to get my old Donzi
Hello Tan,After 8 years I was finally able to get my old Donzi back into the water yesterday and I must say without your help that probably would not have been possible. (Thank you) The motor ran real… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1985 OMC Alpha 434 APKW sterndrive. Bad water leak in boat.
1985 OMC Alpha 434 APKW sterndrive. Bad water leak in boat. Hull looks ok. Jacked the front of trailer as high as possible and put water in bilge area. The water leaked out between the transom and the… read more
Michael
Michael
master marine technician/charter captain
Vocational, Technical or Trade Scho
256 satisfied customers
Have aboat with a350 merc engine just put new bellows in bellhousing
have aboat with a350 merc engine just put new bellows in bellhousing when completed hooked garden hose up started motor a lot water came out 2 1"holes at bottom of housing some water came out prop not… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi, I have a 1994 OMC Cobra outdrive on a 5.8 motor. While
Hi, I have a 1994 OMC Cobra outdrive on a 5.8 motor. While underway if I turn the boat left or right I get vibration. I removed the outdrive and the gimbal bearing and the u-joints look and operate we… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
On a 2004 Volvo Penta DP Drive (5.0 Gxi Motor), can I lube
On a 2004 Volvo Penta DP Drive (5.0 Gxi Motor), can I lube / grease the Gimbal bearing with a grease gun via the Zerk fitting while the boat is in the water (outdrive submerged, obviously) to quiet a … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hello, I have a 1990 MerCruiser 7.4/V8 Bravo with a stern
Hello, I have a 1990 MerCruiser 7.4/V8 Bravo with a stern drive installed in a Bayliner 2556 Convertible. The engine is leaking water somewhere in between the bell housing and stern drive. I first not… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,123 satisfied customers
I have a small leak in the metal part that is directly below
I have a small leak in the metal part that is directly below the drive shaft and goes between the motor and stern drive on my 1993 sea ray with a 4.3L mercruiser. The leak does not appear to be at any… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
24,123 satisfied customers
Water in hull of Bayliner 2150. Cobra stern drive 5.8L Ford
Water in hull of Bayliner 2150. Cobra stern drive 5.8L Ford 351. It's not a lot of water, 2-3 gal. in a 20 minute joy ride. Enough to bilge. I have just replaced the exhaust bellows, the gimbal/drive … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I am having water enter the engine compartment,however I do
I am having water enter the engine compartment,however I do not see any leaks on the engine or manifolds. I have a 95 SeaRay with a 2002 4.3 Multiport injected v6 with an Alpha outdrive.… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Please can someone help me. I recently bought a SeaRay 210
Please can someone help me. I recently bought a SeaRay 210 Sundeck. It was great in the sea trials. Since then I have had new risers installed and the outdrive serviced. Now it runs great BUT it sound… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Do I need to remove the engine to replace the shutters Why
Do I need to remove the engine to replace the shutters? Why would there be no water coming from the props when engine is running? Lotes of water comes from the two openings at the bottom of the gimbal… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
my stern drive on my 5.4 litre is shot, i found a stern drive
my stern drive on my 5.4 litre is shot, i found a stern drive for a 5.0 litre on ebay, my modle number is XXXXX and the one on ebay is 985271. is there a way to make it fit?… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
Hi have you any tips on how to fit an exhaust bellows to a
Hi have you any tips on how to fit an exhaust bellows to a mercruiser 1996 .I have struggled for 3 hours only to punch a hole in the new bellows trying. many thanks Phil… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
HI, In October 2008, my boat was brought into dry dock
HI, In October 2008, my boat was brought into dry dock without any leakage issues. Maintenance was performed : Drive Service - remove drive, inspect gimbal and ring bearings, inspect bellows, inspect … read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a searay 240 sundancer with inboard outboard bravo 3.
I have a searay 240 sundancer with inboard outboard bravo 3. The exhaust bellow came off from the stern but it is still connected to the drive. Can I wait until the end of the season in three months t… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
my volvo penta has a rattling sound and gets worse at different
my volvo penta has a rattling sound and gets worse at different speeds and trim positions. also it gets worse as you make a turn no matter how slight… read more
John B
John B
Owner
Marine Manufacturer Certifications
14 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

4,115 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,123 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

3,038 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x