Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
2007 mercruiser 5.0 MPI, just replaced raw water impeller,
2007 mercruiser 5.0 MPI, just replaced raw water impeller, thermostat, oil, plugs, drive lube and engine runs smooth but using an IR gun thermometer I get 90F on top of riser, 180-185 on lower sides o… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 3116 300 HP temperature at thermostat getting up to
I have a 3116 300 HP temperature at thermostat getting up to 220 replaced thermostat and still there took it out ran the engine and it is running at 110 at thermostat. Any suggestions we are at a lost… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I want to check basic timing at 8 degrees. Do I need to
Hello I want to check basic timing at 8 degrees. Do I need to ground the purple &white wire. Where is it.… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
my 2001 mercrusier 350 MAG MPI Gen+ Inboard, S/N 0L671768 drivers
my 2001 mercrusier 350 MAG MPI Gen+ Inboard, S/N 0L671768 drivers side exhaust manifold is much hotter than the passenger side. When I changed the thermostat this spring I removed the duck head and fl… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi. I have a 2003 Mercruiser 4.3 MPI alpha one Gen II. I recently
Hi. I have a 2003 Mercruiser 4.3 MPI alpha one Gen II. I recently performed the following maintenence: New exhaust bellows, driveshaft bellows, shift bellows, water hose, and impeller. On the test run… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi, I own a 2008 185 sport w/3.0L TKS Alpha type Mercruiser
Hi, I own a 2008 185 sport w/3.0L TKS Alpha type Mercruiser 4 cyl motor. To date it has 80 hrs on the clock and I've been miticulous about winterizing and servicing the fluids except for the cooling s… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 2007 sea ray 230 select with a 350 mag and bravo three
I have a 2007 sea ray 230 select with a 350 mag and bravo three deive. The other day we took it out and I ran it WOT with the captains call on it ran hot after about 10 minutes. We shut it down to coo… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
We have a 1987 Alpha 1 outdrive. 165horse 4cyclinder engine
We have a 1987 Alpha 1 outdrive. 165horse 4cyclinder engine with heat exchanger. Engine overheated, sea water leaking into boat thru transom. Any ideas?… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have twin 7.4L 454Mag MPIs (year 2000) with 500 hours.
I have twin 7.4L 454Mag MPI's (year 2000) with 500 hours. New boat owner (2 months). Port engine has been prdoucing a bluish-gray smoke through the exhaust - much more so than the starboard engine. Ye… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Im looking to purchase a 2000 Sea Ray 380 Sundancer. I heard
I'm looking to purchase a 2000 Sea Ray 380 Sundancer. I heard something about the engines having a problem. They list the engines as Mercruiser 7.4 EFI - FWC which I din't think were the standard engi… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have alpha one gen II outdrive leaking water . It looks
I have alpha one gen II outdrive leaking water . It looks like its leaking near drive boot . I have replaced all boots , gaskets, bearings and seals that come in transom kit. Its still leaking ! any i… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I give up. I have a 2002 Mercruiser 5.0L MPI with bravoIII.
I give up. I have a 2002 Mercruiser 5.0L MPI with bravoIII. Keeps overheating. I replaced EVERYTHING!! Thermostat , Water Circulating pump twice, Sea water impeller, Exhaust Mans & Elbows. Hoses are u… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Do I need to remove the engine to replace the shutters Why
Do I need to remove the engine to replace the shutters? Why would there be no water coming from the props when engine is running? Lotes of water comes from the two openings at the bottom of the gimbal… read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
2004 had a new 350 mercruiser installed in 1980 boat always
2004 had a new 350 mercruiser installed in 1980 boat always ran at 180 heated up to 220 upon stopping told by installer of motor that it was normal. This year heated up to 200 would not cool down, sho… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
I have a 1999 Caravelle 188 with a volvo 4.3 engine. It has
I have a 1999 Caravelle 188 with a volvo 4.3 engine. It has been a perfect boat until now. Always serviced and it has always ran fine. Today I put it in the water and when I started away from the pier… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Our 1987 gas powered Sea Rays AlphaOne 260 HP Mercruiser 35
Our 1987 gas powered Sea Ray's AlphaOne 260 HP Mercruiser 350 MCM heats up to 200 - 210 F when I open it up. However, when I really slow down the speed then the temp returns near 180 F. I know little … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 2001 4.3L V6 Mercruiser with an Alpha outdrive. The
I have a 2001 4.3L V6 Mercruiser with an Alpha outdrive. The stock one piece exhaust elbows rusted out and water got into the engine so I pulled the motor out and rebuilt it. The heads were taken in a… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
3,847 satisfied customers
I have a 1996 sea ray with a 5.7 mpfi engine and it ...
I have a 1996 sea ray with a 5.7 mpfi engine and it overheated.the port side exhaust bellow had a hole blown in it . i will replace it but do i need to replace the rawwater pump as well?… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

3,847 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x