Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
My Kohler 5e marine generator is overheating. At some point
My Kohler 5e marine generator is overheating. At some point in the past, the previous owner had let a number of impeller blades into the heat exchanger which was causing overheating. All debris has be… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,678 satisfied customers
I got a 2005 5.0l moo bravo. This unit keeps on going to
Hey Jason.I got a 2005 5.0l moo bravo. This unit keeps on going to overheat I have removed and replaced the raw water pump when customer list sit up on his left and everything drains out and put it ba… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
My volvo MD 2030 is overheating, started to put on a new rav
My volvo MD 2030 is overheating, started to put on a new rav waterpump, clean up the raw water system, put on a new exhaust neck, disconnect the lines for the anti water valve, so get the raw water di… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
The sea core hand pump failed to pressurize the system. It
The sea core hand pump failed to pressurize the system. It dripped from the blue plug along time then finally stopped. Did it fully drain? Is there a place I can add some anti freeze?… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 454 bravo. The engine overheated,it would not draw
I have a 454 bravo. The engine overheated,it would not draw water from the leg. I disconnected the hose going to the leg and put a garden hose directly into the hose going to the pump.Engine still ove… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hi I have a Yanmar 4LHA-STP and while running on rpms around
Hi I have a Yanmar 4LHA-STP and while running on rpms around 3000 the engine consumes the cooling water and overheats. What could cause this. According to the manual the top speed is 3100 rpm… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
2001 searay 460 sundancer, hit a sand bank , overheating started
2001 searay 460 sundancer, hit a sand bank , overheating started on port engine after that . the boat is equipped with 450 diamond series. I have removed all heat exchangers , tur,bo, transmission, en… read more
Diesel Boat Doc
Diesel Boat Doc
High School or GED
120 satisfied customers
I have a Mercruiser MCM 7.4 litre Bravo that I replaced the
I have a Mercruiser MCM 7.4 litre Bravo that I replaced the heads and manifolds on last fall. Now the engine runs perfectly, however begins overheating at 2000 RPM and higher. I have replaced the seaw… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i replaced my seawater pump ,thermostat,and waterpump now i
i replaced my seawater pump ,thermostat,and waterpump now i cannot get the seawater pump to pump could i have reversed the seawater pump hoses the wording on the pump is confusing any ideaschuck mcwhi… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I purchased a Morgan OI 33 which is fitted with a Perkins 4108.
I purchased a Morgan OI 33 which is fitted with a Perkins 4108. The engine has approximately 1000 hours on it and has been running fine at 1400 to 2000 rpm. Any higher rpm and the engine will overheat… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My dad has aboat that has a 5 lyer mercruiser with a bravo
My dad has aboat that has a 5 lyer mercruiser with a bravo 3 otdrive in it. I has a seawater pickup that you need to close when you run the enginer out of the water and it is hooked to a hose. He left… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hi, I have a 1986 Ranger 21 boat with the Volvo Pentax
Hi, I have a 1986 Ranger 21' boat with the Volvo Pentax 290 A engine. When I go out on the lake it stays cool for a while and then it starts to overheat. I am told that this engine has 2 thermostats. … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a AQ 171 (1988) mounted in a Hydrocopter (airboat).
I have a AQ 171 (1988) mounted in a Hydrocopter (airboat). It only has 290 hours on it but i experience both overheating problems and lack of power. Above 4000 rpm it basically loses all power and dro… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have restored a 1974 Chris Craft XK-19 boat. Fresh water
I have restored a 1974 Chris Craft XK-19 boat. Fresh water use only - no salt water use. It now has a 2007 Chevy 350 replacement crate motor. It uses the log style, wet marine manifolds with "hump ris… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I just aquired my first boat it is a 1973 Tom Sawyer. It has
I just aquired my first boat it is a 1973 Tom Sawyer. It has a Waukesha 302 engine, & a Volvo power train. The engine is running hot. I've disconnected the hoses that go to & from the raw water pump, … read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
I have a Perkins V2.71M 2 cylinder Marine Diesel, 18 hp, 72
I have a Perkins V2.71M 2 cylinder Marine Diesel, 18 hp, 72 cubic inch. Serial no begins BG24. B means 1975, "75" is actually stamped onto the crankcase. According to Perkins site G means "Made in Gre… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Hi, It seems the freshwater coolant circle of one of the two
1980 Mercruiser 470 freshwater coolant cycle clogged. I bought the Sea Ray 260 a while ago and started today for the first time the engines. The left engine runs fine after correcting the ignition cab… read more
gearheadII
gearheadII
Bachelor's Degree
138 satisfied customers
I recently had my Volvo Penta lower unit rebuilt because the
I recently had my Volvo Penta lower unit rebuilt because the pinion nut on the vertical shaft came loose. After putting the boat back on the water we noticed that the engine would overheat to about 22… read more
mercmastertech
mercmastertech
Service Manager, Master technician
Technical School
249 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x