Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Suzuki DF6 outboard. Sat two years. New plug and terminal
Suzuki DF6 outboard. Sat two years. New plug and terminal cap - starts nearly every first pull. Ran ragged (rpm surging) in neutral and would not run without choke. New fuel tank, new fuel lines, old … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1980 suzuki spirit DT8 that I do not want
Hello, I have a 1980 suzuki spirit DT8 that I do not want to toss. It is like new but recently floods itself out after 5 min run time, I cleaned carb, same thing, changed needle, same results. There i… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,716 satisfied customers
I have a 1978 mercury 700 70hp outboard it will only run on full chok
I have a 1978 mercury 700 70hp outboard it will only run on full choke if I try to advanced the throttle the engine will die carburetors and fuel filter are spotless, I can only increase the RPM by in… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
I have a 4 cycle 4HP yamaha outboard. It starts fine, but
I have a 4 cycle 4HP yamaha outboard. It starts fine, but doesn't idle down at low speed well. At low speed, just above stall, it seems to be almost too fast to shift. It jumps into gear when shifting… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 05 Johnson 90 hp 2 cycle outboard. Its not sucking
I have a 05 Johnson 90 hp 2 cycle outboard. It's not sucking air thru gas or oil hoses. It's been doing it for 2 yrs. Last yr took it back to the dealer and they put a new gas pump on it. It's doing t… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I replaced the float in a 1956 10hp Johnson outboard motor
I replaced the float in a 1956 10hp Johnson outboard motor with OMC#0396514. This float is a bit thicker than the old cork float that was in the carb. I'm not sure if there is enough room in the bowl … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1998 Bayliner 5.7L alpha one I/O Engine recent rebuild, runs
1998 Bayliner 5.7L alpha one I/O Engine recent rebuild, runs good at idle and above about 1000 RPM. Slow or normal throttle move from idle, engine runs very rough about 900 RPM it either stalls or wit… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a 1990 yamaha cv30eld. I just bought a jon boat with
I have a 1990 yamaha cv30eld. I just bought a jon boat with this on it. The motor looks really clean, however it will only fire and run for a few seconds after starter fluid is sprayed into carb. any … read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,716 satisfied customers
I have a Suzuki 30 hp oil injected outboard, not quite sure
I have a Suzuki 30 hp oil injected outboard, not quite sure of the year, I'm thinking early 90's, that stalls when put in forward gear ( does not stall in reverse ), will not keep running at low (trol… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
5 hp briggs outboard motor - was running fine - stopped running.
5 hp briggs outboard motor - was running fine - stopped running. Now it will only run with the choke fully closed. As soon as you move the choke it quits running. We have removed the carb and cleaned … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
1074, 70 hp johnson outboard. We have run about 4 gallons
1074, 70 hp johnson outboard. We have run about 4 gallons of fuel with seafoam through it so far. Has been sitting for a couple of years or more. Starts fine and idles. Smokes alot. Runs OK to about 2… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
Johnson 48 outboard wont idle... have to make adjustments
Johnson 48 outboard won't idle... have to make adjustments with the motor running in the water, very scary. Is this the fuel pump?… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 89/90 40HP oil injected Mercury outboard (SN#0C160126).
I have a 89/90 40HP oil injected Mercury outboard (SN#0C160126). Had not run it for three years. New plugs/new gas with STARTRON. Starts with choke, but will not idle. As long as choke is engaged engi… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have twin 350 cu inch Marine Power engines with less than
I have twin 350 cu inch Marine Power engines with less than 25 hrs. I don't have access to many marne mechanics. My port engine is flooding.They have been running fine. They have electric chokes. Any … read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
Ive got what I believe is a 94 or 96 Johnson 48HP outboard.
I've got what I believe is a 94 or 96 Johnson 48HP outboard. It was tuned and running fine last time it was used, but that was 2 seasons ago, (I recently acquired it). Sitting has obviously caused it … read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
I have a 1984 9.9hp Johnson outboard on my sailboat. It has
I have a 1984 9.9hp Johnson outboard on my sailboat. It has ran well for years. This year I have had real trouble keeping it running. It will run fine and then stall as if it is not getting fuel. I pu… read more
FieldServiceTech
FieldServiceTech
Vocational, Technical or Trade Scho
146 satisfied customers
175 yamaha outboard- starts fine and seems to get plenty of ...
175 yamaha outboard- starts fine and seems to get plenty of gas in nuetral, but dies when I put it in gear.… read more
Larry B.
Larry B.
Marine Service Tech
High School or GED
574 satisfied customers
1996 mercury 115hp outboard 4 cylinder- no power under ...
1996 mercury 115hp outboard 4 cylinder- no power under load-have spark all cylinders & have replaced both filters & cleaned the jets (needle valves) going to the bottom two cylinders.Runs ok in neutra… read more
Wrenchtech
Wrenchtech
Vocational, Technical or Trade Scho
616 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x