Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I have a 1988, vro 110. Vro unhooked.. I replaced the fuel
I replaced the fuel pump.with one just like I took off.. it starts and idols. Give it throttle.. starts to come up to hi rpm... Then goes back to idle... … read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I got a problem with my kawa zxi1100 97, It starts an idle
It starts an idle fine at 1200 when try to trottle the engine rpm jumps and rpm needle goes to 0. In goes up to 1200 when stop trottling. … read more
Boat Doc
Boat Doc
253 satisfied customers
2000 Yamaha f100 four stroke. I've owned it since 2005. I've
2000 Yamaha f100 four stroke. I've owned it since 2005. I've pulled the carbs and cleaned them. Idles nicely and runs great above 3500 rpm but doesn't accelerate smoothly. I replaced the little 10 mic… read more
Charles
Charles
Certified Mercury Tech
5,752 satisfied customers
I have a 70hp nissan out board 2002 model. stater and the power
I have a 70hp nissan out board 2002 model. stater and the power pack has been replaced new plugs carburators cleaned. Total check out. It will run along a 4,000 rpm dragging will not open up then all … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Hi Tan Dwight Nicholas here. First of all I want to thank
Hi Tan Dwight Nicholas here. First of all I want to thank you for the great advice on my 1995 Mercury XR6. I replaced the coil and found a broken wire from the switchers to the coil on the other cylin… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
My 1999 Mercury 150HP is running rough at idle. This has recently
My 1999 Mercury 150HP is running rough at idle. This has recently started happening after multiple day trips of some distance. I cleaned the carbs and put new gasket kits, but still running rough. Any… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 99 70 hp 2 stroke 3 cylinder. Carbs have been cleaned,
I have a 99 70 hp 2 stroke 3 cylinder. Carbs have been cleaned, tank cleaned, new plugs and thermostat..It idles high but will start and idle no problem. When I hit 2800 rpms it starts to stutter/ sha… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
did mercury ever build a 2.o litre efi my cowling says 2.o
did mercury ever build a 2.o litre efi my cowling says 2.o litre 98 150 just had new power head put on dont run right over loading guy at marine said he never seen 2.0 litre efi thinks computer is fee… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I have a 1997 two stroke 150 saltwater series. I am experiencing
I have a 1997 two stroke 150 saltwater series. I am experiencing two times in a row the exact same senerio. I leave the harbor and run at 2600 rpm to a destination approx 45 minutes. I drift for about… read more
Jeff G.
Jeff G.
Marine Mechanic
Vocational, Technical or Trade Scho
4,730 satisfied customers
this motor appears to be running rich because the back of the
this motor appears to be running rich because the back of the boat became black much quicker than usual and it cuts off when it warms up, won't crank back. a dealer replaced the impeller over the wint… read more
Noel Schembri
Noel Schembri
Marine mechanic
Diploma
2,719 satisfied customers
hi i have a 1999 xr6 150 merc motor it cranks and idles fine
hi i have a 1999 xr6 150 merc motor it cranks and idles fine in cool weather .but once the weather turns hot it is stubborn to crank and doesn't idle nearly as smooth. even in hot weather it cranks fi… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
i have a 1999 mercury xr6 and it wouldnt start after a little
i have a 1999 mercury xr6 and it wouldnt start after a little trouble shooting i realized the flywheel nut was loose and flywheel wasnt turning crank so i took it off put it back on and boat cranks fi… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have 2003 mercury xr6 150 motor and It shutts down once I
I have 2003 mercury xr6 150 motor and It shutts down once I reach about 40 mph. However, it recranks immediately. I have replaced the fuel filter, primer bulb, and sparks plugs. Anything else to note?… read more
Whitecap36
Whitecap36
Marine Technician
Vocational, Technical or Trade Scho
1,557 satisfied customers
1994 OMC Cobra 5.0 stearndrive in a Seaswirl boat. The engine
1994 OMC Cobra 5.0 stearndrive in a Seaswirl boat. The engine will run fine and let me jump up out of the hole and reach high speed with no problem for the first 15 minutes or so then I can feel it st… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I seem to have carbon buildup on my cylinders according to
I seem to have carbon buildup on my cylinders according to my mechanic. I ran the boat for about 8-9 hours over two weekends and 6 of the 8 plugs were fouled. He put a new coil in and cleaned the plug… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 50 hp johnson 2004. i resently had it tuned up and
I have a 50 hp johnson 2004. i resently had it tuned up and was told the compression is lower on one side. the boat had trouble starting and running in idle. once i engaged the throtle it ran fine. i … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Have a 1992 40 H.P. 4 cylinder Mercury. no power, low rpm.
Motor is the classic. Will not rev over 4200 rpm. and slow to get to that rpm. Prop never changed, used to rev 5000-5500, all cylinders test @ arround 120 psi.… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
i have a mariner 90 hp and i cant get full trodle out of it ...
i have a mariner 90 hp and i cant get full trodle out of it it only goes about 10mph can you help its also smoking alot. i used 89 octin is that bad. also i im using a 6 gallon gas can how much 2 cycl… read more
BC Boat Guy
BC Boat Guy
Lecturer/Instructor
Vocational, Technical or Trade Scho
56 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,678 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x