Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
I had the boat out on the lake today and everything was run
i had the boat out on the lake today and everything was run good, all the way from a smooth idle to full throttle and back. After about an hour and a half of cruising around 30mph i throttle back into… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a 2003 volvo penta in a 34 sailboat. The engine starts
I have a 2003 volvo penta in a 34' sailboat. The engine starts and runs fine. When I shift into gear it stalls. I have changed the fule filters an bled the system. I had a mechanic check it out he sai… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a Yanmar 3GM It did not start at the dock, seemed
I have a Yanmar 3GM It did not start at the dock, seemed like a fuel problem I changed both filters, although the primary was only a bit dirty and the secondary appeared like new. I noted the fuel bow… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
We have the following issues with the Mercury Marine Engines
We have the following issues with the Mercury Marine Engines (type 3.0L with Alpha One Drive) installed in our Doral Venezia: 1- Starboard engine: stalls shifting from neutral into reverse. Problem ma… read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
Just building new boat twin engined was going to specify
Just building new boat twin engined was going to specify the yanmar by260 like the engine (BMW) super light and reliable but very worried about the leg Has the 370 leg proved to be as reliable as the … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a clunking sound when I put the gear into forward but
I have a clunking sound when I put the drive gears into forward but not reverse. it seems not to catch and when it does it is at a higher rev than preferred the leg is a Mercury Transom with a MerCrui… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
I have a catamaran with twin Yanmar 40hp/ sd40 saildrives. We
I have a catamaran with twin Yanmar 40hp/ sd40 saildrives. We have had a lot of problems with clutch cones failing and losing transmission to the props.They have to be lapped and /or replaced at short… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
Mercruiser runs fine at high speed (3000rpms). Each time I
Mercruiser runs fine at high speed (3000rpms). Each time I slow down to a low rpm boat runs rough then stalls. If I throw shift lever into quickly into neutral boat stalls immediately, every time. I a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
18,955 satisfied customers
A new Mercuusier Alpha 1 drive mated to a new 5.7 MPI engine
A new Mercuusier Alpha 1 drive mated to a new 5.7 MPI engine with a new shift cable installed twice. All measurements match Merc specs. Shift stall works as designed of a new shift control. He's the r… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
My almost new 2007 Yanmar marine diesels 315s have smoked
My almost new 2007 Yanmar marine diesels 315's have smoked from the day I bought the boat until now. It's blue and and is pronounced when the engines are cold.… read more
Capt.Cory
Capt.Cory
LICENSED CHARTER CAPTAIN
High School or GED
2 satisfied customers
I have 2 yanmar 6LP STE marine engines in my twin screw power
I have 2 yanmar 6LP STE marine engines in my twin screw power boat. when I return throttle back to idle position one of the engines almost stalls. even when I shift from neutral into gear it drops the… read more
Yachtwork
Yachtwork
Marine Engineer
Technical or Trade School
1,048 satisfied customers
Hello, I have a 1996 mercruiser V8 with a new factory 2 bbl
Hello, I have a 1996 mercruiser V8 with a new factory 2 bbl carb and my boat still was a hard time idling and has a bog or stalling condition when getting off idle. I have adjusted the carb and got it… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,392 satisfied customers
1990 Yamaha 130 HP. Very rough and unstable idle in NEUTRAL
1990 Yamaha 130 HP. Very rough and unstable idle in NEUTRAL but runs very smooth and steady in either gear. Had restricted top speed. Suspected 19yr old carbs might be plugged. Took off top carb - it … read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
i have a 2006 bayliner with a 3liter mercruiser engine it starts
i have a 2006 bayliner with a 3liter mercruiser engine it starts easily and idles fine the problem is acceleration from 1200 rpms to 2200 rpms it wants to stall or has no power until you finese it up … read more
Steve Sr.
Steve Sr.
No Title
High School or GED
79 satisfied customers
I have a 1989 mercruiser alpa one sterndrive that at times
I have a 1989 mercruiser alpa one sterndrive that at times will stall (shut down) the engine. What should I look into too try and correct this problem? Larry D. Newport Beach,Ca… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
Hi i have a 96 bayliner with a mercruiser 4.3lt v6. We are
Hi i have a 96 bayliner with a mercruiser 4.3lt v6. We are having some starting problems and it looks as though the choke is coming back on when it is hot and flooding the carbs when you try starting … read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have a yanmar 3gm30f, recently its begun stopping when i
I have a yanmar 3gm30f, recently its begun stopping when i reduce speed to idle after running for a short time. It always restarts, but if i slow down below about 1200 rpms when the engine is hot, it … read more
Yachtwork
Yachtwork
Marine Engineer
Technical or Trade School
1,048 satisfied customers
I have a searay sedan one engine is stalling at 1200 rpms.
I have a searay sedan one engine is stalling at 1200 rpms. It has a 4 barrel holley carburator is there an adjustment and if so could yuo give details ? The engine runs fine otherwise… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
1,074 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

1,074 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,955 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,406 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x