Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Fuel Pressure Problems at high RPMS Volvo Penta D6 370s
I have a twin volvo penta d6 370 engines, 2012. They have 200 hours on them. The PSI for the starboard is 32-33 psi at 3600 rpms and the port gets up to 18-19 psi and falls back down and the engine is… read more
Expert
Expert
Have an issue with my port engine. (Yamaha 1990 200ETXD). Rebuilt
Have an issue with my port engine. (Yamaha 1990 200ETXD). Rebuilt the carbs, replaced the fuel filters and fuel lines. Starts and runs well at idle. Will run good up through 3000 RPM but will not go a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
2005 Mercury 115 4 stroke. Boat will idle fine, once you give
2005 Mercury 115 4 stroke. Boat will idle fine, once you give it throttle it will rev to approx 5800 ramp and gradually come down. Till it reached approx 3000 and it will cruise there. I have changed … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have twin 1988 5.7 270hp Crusader Engines. Just recently
I have twin 1988 5.7 270hp Crusader Engines. Just recently the Starboard engine will lose power and seem to miss,lose power and bogdown after running 30 minutes under load. It runs fine in Neutral or … read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I want to check basic timing at 8 degrees. Do I need to
Hello I want to check basic timing at 8 degrees. Do I need to ground the purple &white wire. Where is it.… read more
Master Tech
Master Tech
Marine Technician
Vocational, Technical or Trade Scho
1,168 satisfied customers
I have twin crusader 1997 454 xli engines with borg v drives.
I have twin crusader 1997 454 xli engines with borg v drives. On a recent trip 2 hrs into our 3hr trip the port side engine RPMs dropped to 3000 normally cruise at 3400. Port engine no longer goes abo… read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
747 satisfied customers
I just bought a 1998 SeaRay Sundancer 290 with twin Mercruiser
I just bought a 1998 SeaRay Sundancer 290 with twin Mercruiser 5.7L-EFI's. The engines seem to operate fine in all respects but one. Starts immediately. Runs smooth. Powers up and down smooth. No hesi… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 454 crusader port engine that starts very hard when
I have a 454 crusader port engine that starts very hard when cold but no problem once it starts even if I leave it off for three or four hours. Overnight and it starts very hard with a lot of cranking… read more
orcamarine
orcamarine
Proprietor
Vocational, Technical or Trade Scho
7 satisfied customers
I have a 1986 formula 242ls with a new mercruiser 275hp. from
I have a 1986 formula 242ls with a new mercruiser 275hp. from first mate . alpha with a 15 x 16degree prop. the boat will not go aver 3000 rpm. i have thunderbolt iv and it is working properly engine … read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
Have twin 2007 Mercruiser 8.1S fuel injected inboards on a
Have twin 2007 Mercruiser 8.1S fuel injected inboards on a 37' Searay. Was cruising at 3200rpm when port eng backed down on rpm's and would not maintain an equal balance with stbd eng. Replaced the in… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade Scho
18,277 satisfied customers
I have twin Y-250hps. In rough water my starboard motor has
I have twin Y-250hps. In rough water my starboard motor has major surging issues. I try to run a 3000 rpm and it will drop to 900-400 on a consistent basis. While this is happening, I also can see tha… read more
Whitecap36
Whitecap36
Service Manager/Technician
Vocational, Technical or Trade Scho
1,556 satisfied customers
I have twin 454 MIE 7.4L MerCruisers in a 1992 Sea Ray 370
I have twin 454 MIE 7.4L MerCruisers in a 1992 Sea Ray 370 Sedan Bridge. Both are original and run great. 1,000 hours each. My starboard engine occassionally stalls at idle either before pulling away … read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2003 Searay Amberjack with twin Mercruiser 5.7 Horizon
I have a 2003 Searay Amberjack with twin Mercruiser 5.7" Horizon 350's My starboard engine simply shut down as I was crusing back to my slip -- roughly 5- 5.5 knots (no Wake zone) and was not able to … read more
Jeremy R.
Jeremy R.
5,362 satisfied customers
I have a 2003 Mercruiser Mag 350 serial OM587340. Engine idles
I have a 2003 Mercruiser Mag 350 serial OM587340. Engine idles fine and runs well at 3000-3500 rpm for 5-10 min. Engine then bogs/hiccups and will not maintain rpms. Changed fuel/water separator and f… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
Can a motor slip at high RPM level when it is engaged/with
Can a motor "slip" at high RPM level when it is engaged/with a load on it? *I have two recently rebuilt MERCRUISER big block engines *I took out my boat, a 1987 35 foot SeaRay this afternoon *At 3200 … read more
shane j forrest
shane j forrest
Vocational, Technical or Trade Scho
270 satisfied customers
I have a 2005 4.3L TKS 2bCarb. Mercruiser on a Searay 200 Sport
I have a 2005 4.3L TKS 2bCarb. Mercruiser on a Searay 200 Sport Serial Number OW350213. The problem changes over time. Initially the boat would not idle well and stall on occasion. This all started af… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
I have 4.3 LX Mercuiser generation 2 on a searay sundancer
I have 4.3 LX Mercuiser generation 2 on a searay sundancer 1992 my problem onnce I get on plane the motor rpms fall off I have thunderbolt ignition. I replaced all filters, rebuilt carburetor I have e… read more
capt ron 1959
capt ron 1959
Owner/Marine Mechanic
Vocational, Technical or Trade Scho
348 satisfied customers
I have a 1990 baha cruiser with twin 5.2 liter gas engines.
I have a 1990 baha cruiser with twin 5.2 liter gas engines. The problem that I'm having is after cruising at about 3500 rpms for about 15 minutes, the one engine begins to loose power. I will see the … read more
briggs archer
briggs archer
master marine mechanic
Associate Degree
374 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

Ted G.

Ted G.

Rigger, Diagnostician

747 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

18,277 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,399 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x