Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
Just bought a 2019 40 hp Merc 3 cylinder. Have it on a 15
Just bought a 2019 40 hp Merc 3 cylinder. Have it on a 15 foot gillgetter pontoon. The 20 hp 4 stroke i replaced had a top speed of 12- 13 mph. I put a 4 blade 10.6 inch by 12 pitch prop on 1st. Good … read more
Ted G.
Ted G.
Rigger, Diagnostician
Vocational, Technical or Trade Scho
2,876 satisfied customers
I have gibson 30,, with 90 sterndrive, I have a prop on it
I have gibson 30,, with dana 90 sterndrive, I have a prop on it but is wrong one, it bogs down and will go over 2500 rpm. I found a prop that was suppose to be right pitch but it was a left hand one a… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
I am looking at purchasing a 2004, 28 Albemarle Express with
I am looking at purchasing a 2004, 28' Albemarle Express with tower, the boat is powered by twin inboard Mercruiser 350 mag MPI WC engines and I'm after some information on the fuel consumption. At bo… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
Dodge trojan: i have a 1976 trojan with a 318 chrysler. i tried
i have a 1976 trojan with a 318 chrysler. i tried to start boat for first time a couple of days ago(back surgery slow start)and the motor starts and runs for a few seconds maybe 3 or 4 and stops. moto… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
if I increase the HP. from 233 to 350 hp what diameter prop
if I increase the HP. from 233 to 350 hp what diameter prop should i use and what pitch? I want mor torq. and more topend speed. I will use larger trim tabs or a specific trolling tab to slow me down.… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
26 Trojan Hard Top Express 318, 225 horse power. I repowered
26 Trojan Hard Top Express 318, 225 horse power. I repowered 3 seasons ago and put a short block back in the boat using some of the manifolds ect from the previous motor. The boat was running to specs… read more
Jason
Jason
Marine Mechanic
Vocational, Technical or Trade School
22,043 satisfied customers
just bought a boat, took it out for a test drive and idle speed
just bought a boat, took it out for a test drive and idle speed was fine but when i went to accelerate the motor would increase rpm but the boat speed was barely noticeable and when it got to around 5… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
eyghten 24 yacht i have got my hands on a 1gm 10with
eyghten 24 yacht i have got my hands on a 1gm 10with a gearbox ratio of 3 to 1 could you advise me on what propeller i should use… read more
Yachtwork
Yachtwork
Owner Team Yachtwork
Technical or Trade School
1,950 satisfied customers
Hi I have purchased a 1973 trojan cabin cruiser boat with
Hi I have purchased a 1973 trojan cabin cruiser boat with twin v-8 supposed to be 318 ci. How can I tell. if it is 318's One i have got to turn over but no fire yet can i up grade to electronic ing. C… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
I need speed for my boat. My propeller is now 17 diameter by
I need speed for my boat. My propeller is now 17 diameter by 18 pitch. I have a new engine (inboard) rated 375 hp 4500 rpm at FOT. I have more info. I need help… read more
K. Kergan
K. Kergan
Inboard/Outboard Mechanic
Vocational, Technical or Trade Scho
1,031 satisfied customers
We run a 2007 Mercury Verado 225 HP on a 6.8 m (22 foot) very
We run a 2007 Mercury Verado 225 HP on a 6.8 m (22 foot) very deep vee Plate Alloy Centre Console boat in tropical offshore waters (Barrier Reef, Australia). All up vessel weight about 2000 kgs (4400 … read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
What size props would a 1978, 33 foot bayliner cabin cruiser,
What size props would a 1978, 33 foot bayliner cabin cruiser, 11 1/2 foot wide have had? It originally had two, 220 horse power volvo gas engines. It was originally built at Bayliner Boat Corporation.… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Hello, I have a Merc outboard 1982 9.8hp. Runs great. I would
Hello, I have a Merc outboard "1982" 9.8hp. Runs great. I would like to pitch up on the prop but can't find any info even on stock replacement. I believe it is a 9 inch dia. 10 inch pitch 3 bladed pro… read more
Scott
Scott
Marine technician
Vocational, Technical or Trade Scho
543 satisfied customers
1. WHAT SHOULD THE TIMING BE SET AT ON 1983 120 HP. MERC-CRUISER
1. WHAT SHOULD THE TIMING BE SET AT ON 1983 120 HP. MERC-CRUISER 4 CYL. INBOARD 2. HOW HOT (TEMP) SHOULD THIS MOTOR RUN 3. WHAT IS THE BEST PITCH FOR THE PROP. THE BOAT IS A 18' WELLCRAFT BOW RIDER.… read more
The jet ski mechanic
The jet ski mechanic
Vocational, Technical or Trade Scho
18 satisfied customers
What is the best overall prop and stern drive for a 1988 28
What is the best overall prop and stern drive for a 1988 28' chaparral 278 signature series cabin cruiser with a 5.7 litre 350 mercruiser motor? Boat weighs approx 6000 lbs. and has an 8'6" beam.… read more
Professor Diesel
Professor Diesel
Proprietor
Vocational, Technical or Trade Scho
14 satisfied customers
I just bought a 1978 Carver mariner 2896 boat, it has 5.7 L
I just bought a 1978 Carver mariner 2896 boat, it has 5.7 L motor and has a beam of 10 foot 4 in. how fast should it go and will it plane. What is a safe rpm to cruse at ? I'am new at this . Thanks Te… read more
Dr. Joe
Dr. Joe
Bachelor's Degree
198 satisfied customers
i have a merc cruiser 5.7l EFI with Alpha One drive - i have
i have a merc cruiser 5.7l EFI with Alpha One drive - i have it in a lake at 5400' elevation. I can not get it to goet over 3000 rpm with passengers on it. it does not plane out. it will plane out (ba… read more
ROCKET
ROCKET
MASTER CERTIFIED TECH
Vocational, Technical or Trade Scho
426 satisfied customers
I have a 27ft Carver motor cruiser with twin V4 merc cruiser
I have a 27ft Carver motor cruiser with twin V4 merc cruiser gas engines down in Florida I want to take out these gas hogs and fit an economic deisel engine speed is not a priority I would be happy wi… read more
Captain Dave
Captain Dave
Marine Mechanic
Master's Degree
2,672 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Rigger, Diagnostician

2,876 satisfied customers

40 years boating, Safe boating instruct., Offshore Race promoter, Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

22,043 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Captain Dave

Captain Dave

Marine Mechanic

2,672 satisfied customers

USCG Licensed Captain, 20+ Years Boating, Fishing, Maintenance and Repair Experience

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x