Boat

Have Boat Questions? Ask a Boat Repair Expert.

Connect one-on-one with {0} who will answer your question

Related Boat Questions
96 6hp outboard. Has around 72 psi compression for each
96 6hp johnson outboard. Has around 72 psi compression for each cylinder. Is this sufficient?… read more
Jason, Mech.
Jason, Mech.
34 satisfied customers
Have a 1986 140 hp outboard on our boat. We were out on the
Hello- Have a 1986 Johnson 140 hp outboard on our boat. We were out on the lake today, running about 3500 RPM when the motor just suddenly lost power and shut down. When we got it home I ran a compres… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
WHAT HAPPENS WHEN YOU HAVE LOOSE MAGNETS ON A 225 HP 1992
WHAT HAPPENS WHEN YOU HAVE LOOSE MAGNETS ON A 225 HP JOHNSON 1992 LOOPER ENGINE,WILL IT BOG AT HIGH RPM… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
I have a new to me 2000 Johnson 225 Ocean Runner. Stalls constantly
I have a new to me 2000 Johnson 225 Ocean Runner. Stalls constantly at under 2000 rpms. At higher rpms motor surges, backs off, then stalls. Always starts right up. Fuel new this year. Filters all rep… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
1984 johnson 150, is 90 psi ok on very cylinder, and on a
1984 johnson 150, is 90 psi ok on very cylinder, and on a 200 evinrude, is 90 psi, these were checked with all plugs out… read more
Jason
Jason
Marine Mechanic
24,193 satisfied customers
I am looking to buy a 1991 Lowe boat with a 70 HP Johnson motor.
I am looking to buy a 1991 Lowe boat with a 70 HP Johnson motor. Are there any particular problems that you are aware of on either of these? Any thing that is a common problem? AL… read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
Johnson 110hp vro 1987 I just bought this motor, its vro
Johnson 110hp vro 1987 I just bought this motor, it's vro is disconnected. It was running for ten to fifteen minutes with a hesitation about every 30 seconds that sounded like it was going to run out … read more
Evinrude/Johnson
Evinrude/Johnson
Evinrude/Johnson marine technician
Vocational, Technical or Trade Scho
41 satisfied customers
I have a 1989 Johnson 40hp outboard. I have replaced gas tank,
I have a 1989 Johnson 40hp outboard. I have replaced gas tank, lines, conections and spark plugs. Unit finally started with water hookup and repeated mulitple times until I got it to the water. It sta… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
I have a 2003 polaris MSX 140. It appears to be running on
I have a 2003 polaris MSX 140. It appears to be running on two cylinders. Compression tested all three cylinders and all tested @ 50 psi. Rear cylinder is cooler in temp and spark plug is oil wet. Can… read more
James
James
Certified Marine Mechanic
Vocational, Technical or Trade Scho
4,094 satisfied customers
What is the fuel mixture for a 1989 9.9HP Johnson, 100:1 or
What is the fuel mixture for a 1989 9.9HP Johnson, 100:1 or 50:1. The owner I bought this from said it runs like crap at 50:1. What to I do with that set of circumstances?… read more
Tan
Tan
MerCruiser Certified Technician
Certified Marine Technician
11,409 satisfied customers
its a 2000 suzuki 225 hp outboard motor. need to know the proper
its a 2000 suzuki 225 hp outboard motor. need to know the proper psi the cylinders should have for a compression test? also your candid opinon of the motor it self. pros and cons. thank you for your t… read more
Greg Robinson
Greg Robinson
Senior service manager
Vocational, Technical or Trade Scho
199 satisfied customers
Have a 98 johnson ocean runner 225 and will only pull 4000
Have a 98 johnson ocean runner 225 and will only pull 4000 rpm, has a 17 pitch prop and did compression test, checked for spark, all checks out fine. But can't get it to pull top rpm?… read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
i have a 1989 johnson 225 i ran a compression check the cylinders
i have a 1989 johnson 225 i ran a compression check the cylinders had 50 lbs on all 6 is that a good number or what should it be… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1991 Johnson 175 (J175STLEID). It broke a ring in
I have a 1991 Johnson 175 (J175STLEID). It broke a ring in one cylinder. I don't know yet why it broke a ring, as I haven't taken it apart. The other 5 cylinders have good compression, within 5 PSI of… read more
Master Tech
Master Tech
Service Manager/Technician
Vocational, Technical or Trade Scho
1,167 satisfied customers
I have a 1998 Mercury 225, it is making wet fouled plug and
I have a 1998 Mercury 225, it is making wet fouled plug and starting slow at the beginning and I will say did not go full speed (only 50 MPH) any advose???… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
I have a 225 Hp Johnson 1999 that idles fine at 850 neutral
I have a 225 Hp Johnson 1999 that idles fine at 850 neutral 700 in gear, comes up good until 3000 rpm and almost on plane then bogs down to 2200 and will not plane.… read more
davesoutboard
davesoutboard
owner
Associate Degree
1,570 satisfied customers
Hi I have a 1989 Yamaha 50 hp outboard motor and when I was ...
Hi I have a 1989 Yamaha 50 hp outboard motor and when I was running it at the lake all of a sudden lost over 3/4 of its power. It still ran ok at idle but not anything much past that .Its not missing … read more
Captain Dave
Captain Dave
Charter Captain & I.S. Director
Master's Degree
2,808 satisfied customers
Wont throttle up in the water, stalls when put in gear
Runs and idles fine OUT of the water, IN the water it will idle fine and throttle up in NEUTRAL.… read more
Pappy's Sales and Service
Pappy's Sales and Service
Vocational, Technical or Trade Scho
586 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

Ted G.

Ted G.

Marine Mechanic

4,145 satisfied customers

40 years experience, Safe boating instruct., Failure Analysis, Expert Witness

Dominick

Dominick

Marine Mechanic

1,009 satisfied customers

25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified

John White

John White

Marine Mechanic

306 satisfied customers

11 years experience working on outboards, inboards, sterndrives & pwcs

Jason

Jason

Marine Mechanic

24,193 satisfied customers

Degree in Marine Technology. Gas and diesel marine mechanic.

Tan

Tan

MerCruiser Certified Technician

11,409 satisfied customers

40 yrs. experience with complete engine repairs both inboard/outboard and MerCruiser Certified Technician.

Jeff G.

Jeff G.

Marine Mechanic

4,730 satisfied customers

42 years experience, Certified Master Technician, All Major Outboards, Sterndrives, Hi-Performance

Noel Schembri

Noel Schembri

Marine Mechanic

3,046 satisfied customers

Advanced technical diploma

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x